搅拌工艺对半固态Y112铝合金组织及性能的影响

采用自行研制的机械搅拌装置,研究了不同工艺参数对半固态Y112铝合金组织及性能的影响.研究表明,搅拌温度越高,搅拌速度越大,固相颗粒越细小、均匀和圆整,其抗拉强度与伸长率越高;但温度太高,固相颗粒会熔化,抗拉强度及伸长率也降低;随搅拌时间的延长,固相颗粒先变得细小、均匀和圆整,然后长大,抗拉强度、伸长率先升高后降低.     

Numerical study on PEMFC’s geometrical parameters under different humidifying conditions

Steady-state and three-dimensional simulations were carried out to study the influences of geometrical parameters on the performance of PEMFC under different hydrating conditions. Flow fields, species transport, transport of water in polymer membrane and movement of liquid water in cathode and anode porous layers were determined, in order to accomplish a complete estimation of ohmic and concentration losses of PEMFC power. The geometrical parameters were thickness of the polymer membrane, cathode catalyst layer as well as gas channel to rib width ratio. Every simulation was made under different relative humidities of inlet flows (50 and 100%) for every change of characteristic length. Results show that the influence of the geometrical parameters on ohmic and concentration losses is of considerable importance. The performance of PEMFC is seriously affected under dehydrating conditions. However, such performance may be considerably improved by using suitable geometrical parameters. Cathode and anode liquid saturation may not only affect the transport of species, but also the polymer electrolyte water content. These results show the importance of simultaneously calculating both the water absorption and desorption through the polymer electrolyte and the liquid saturation in the cathode and anode porous mediums to obtain an actual view of ohmic and concentration losses of the PEMFC performance.     

Use of the Extreme Groups Approach: A Critical Reexamination and New Recommendations.

Analysis of continuous variables sometimes proceeds by selecting individuals on the basis of extreme scores of a sample distribution and submitting only those extreme scores to further analysis. This sampling method is known as the extreme groups approach (EGA). EGA is often used to achieve greater statistical power in subsequent hypothesis tests. However, there are several largely unrecognized costs associated with EGA that must be considered. The authors illustrate the effects EGA can have on power, standardized effect size, reliability, model specification, and the interpretability of results. Finally, the authors discuss alternative procedures, as well as possible legitimate uses of EGA. The authors urge researchers, editors, reviewers, and consumers to carefully assess the extent to which EGA is an appropriate tool in their own research and in that of others. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

X射线三轴晶衍射法测量半绝缘GaAs单晶的化学配比

采用X射线三轴晶衍射法,根据As间隙原子对作为过量As在GaAs单晶材料中存在的主要形式的模型,可以无损、高精度测量半绝缘GaAs单晶的化学配比.并探讨了引起晶格变化的原因及其与熔体组分的关系,对于制备高质量GaAs单晶及其光电器件具有重要的意义.     

Development of Low-Oxide MCrAlY Coatings for Gas Turbine Applications

Advanced high-energy plasma systems are being used to achieve the benefits of the high-velocity oxy-fuel (HVOF) system without losing the inherent advantages of plasma for coating of gas turbine parts. MCrAlY coatings play a very important role in the performance and reliability of gas turbine components. One of the important considerations for next generation of gas turbines, which have more demanding conditions and need to withstand ever increasing operating temperatures, is that they should possess very low oxygen content levels in the coating. Low oxygen content coatings are applied by the expensive low-pressure plasma spray (LPPS)/vacuum plasma spray (VPS) technique for critical components in aero- and land-based gas turbines. This work deals with the development of low-cost LPPS equivalent coatings (having low oxygen content) using the high-energy high-velocity plasma spray (HEHVPS) gun and inert gas shroud. A comparison has also been made with CoNiCrAlY coatings by HVOF.     

Time and Temperature Factors in Construction of Rock Strength Criteria

Using the synthesis of the kinetic concept on solid strength and the Coulomb - Mohr strength theory as the base, the failure conditions taking into account the time and temperature factors are obtained.     

Ultrasonic properties of hexagonal ZnS at nanoscale

Higher order elastic constants have been calculated in ZnS at 300 K and 500 K following the interaction potential model. Ultrasonic attenuation, velocity and other related parameters have been calculated using the higher order elastic constants for the different size of the material at 500 K. The size dependency of the ultrasonic properties is discussed in correlation with elastic, thermal and electrical properties. It has been found that the thermal conductivity is the main contributor to the behaviour of the ultrasonic attenuation as a function of the size and the responsible cause of attenuation is phonon-phonon interaction. The semiconducting nature of ZnS film has been achieved with the study of size variation of thermal relaxation time and ultrasonic attenuation.     

高坝洲电站碾压混凝土纵向围堰拆除爆破设计与实践

介绍了高坝洲电站碾压混凝土下游纵向围堰现场爆破试验成果,在分析爆破试验效果的基础上进行碾压混凝土围堰拆除爆破设计,详细分析了拆除爆破实施效果及主要影响因素.     

基于人文关怀的信号配时方法研究

在传统的信号配时中，都是以减少车辆的总延误为目标，这样并不能很好地体现出整个社会中人的时间价值。现以减少所有通过交叉口的出行者的总延误为目标，在传统的信号配时方案的基础上，提出了一套新的配时方案，同时以减少全部出行者的总延误时间为目标给出了相应的延误评价公式，最后以杭州市文一路-古翠路口的实测交通数据进行分析，论证了本配时方案的有效性。     

Extremes of random fields over arbitrary domains with application to concrete rupture stresses

To find the exact probability distribution of the global maximum or minimum of a random field within a bounded domain is a pending problem even for Gaussian fields. Except for very special examples of fields, recourse must be taken to approximate reasoning or asymptotic considerations to be judged with respect to accuracy by simulations. In this paper, the problem is addressed through a functional equation that leads to the definition of a class of distribution functions that depend solely on process or field characteristics and domain quantities that can be calculated explicitly. This distribution function class is studied for Gaussian processes in earlier works by the author and it has been obtained explicitly for Gaussian fields on rectangular domains in the plane. Simulation studies show that rather good predictions are obtained for sufficiently smooth wide band Gaussian processes and fields. In this paper, the distribution function is obtained in general for Gaussian fields over arbitrary bounded domains with piecewise continuous and differentiable boundaries, and as in earlier works the distribution function is tested against empirical distribution functions obtained by simulation of sample functions of a smooth approximately Gaussian field, herein called a broken line Hino field. For completeness this particular field type is defined in appendix a and appendix b. The paper concludes with a statistical application on data for plain concrete tensile strength.