反向凝固法生产H90-钢-H90复合带

研究H90-钢-H90反向凝固复合过程中复合层厚度的变化规律以及复合带的组织和性能，探讨界面结合机理。结果表明：随着浸渍时间的增加，复合层的厚度变化经历了凝固生长、平衡相持和回熔3个阶段，钢带的预热温度越低，获得的最大复合层厚度越厚；H90复合层的组织为等轴晶粒，复合界面处Cu和Fe发生了扩散，而Zn未发生明显扩散，扩散层较薄，约为4μm；复合带的界面结合牢固；不同复合层厚度的复合带，其力学性能略有差异，但均达到GB5213——85所规定的F级深冲钢板的力学性能要求。     

柳海矿运输大巷返修工程深部软岩支护设计研究

通过现场调查、室内试验以及理论分析,柳海矿运输大巷支护现状进行分析研究,总结破坏原因。根据现场工程地质条件、岩石特性和破坏特点,确定软岩变形力学机制为高应力膨胀性软岩,并提出采用预留刚隙柔层支护技术进行支护。     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

管网保温层热经济寿命的决策方法

利用保温裸露因数的概念来反映保温层保温性能的变化，提出采用统一原则来建立适用于单元系统和复合系统保温层热经济寿命的数学模型，并通过实例证明在热经济寿命终了时更新保温层，可使系统的运行具有最大的经济性。     

挤扩支盘桩在福建省防震减灾中心大楼的应用

结合工程实例阐述挤扩支盘桩施工质量控制和技术措施,对施工过程出现的异常情况提出对策,为类似工程提供借鉴。     

A New Algorithm for the Elimination of Common Subexpressions in Hardware Implementation of Digital Filters by Using Genetic Programming

A new algorithm based on Genetic Programming (GP) for the problem of optimization of Multiple constant Multiplication (MCM) by Common Subexpression Elimination(CSE) is developed. This method is used for hardware optimization for DSP systems. A solution based on Genetic Programming is shown in this paper. The performance of the technique is demonstrated in one- and multi-dimensional digital filters with constant coefficients.     

指状椭圆函数滤波器的研究与设计

阐述了指状椭圆函数滤波器的特点、适用范围，基本理论以及设计方法。用本文导出的公式进行设计有工程应用价值，介绍了一个L波段滤波器的例子。     

Barrier layer effect of tantalum on the electromigration in sputtered copper films on hydrogen silsesguioxane and SiO2

As IC devices scale down to the submicron level, the resistance-capacitance (RC) time delays are the limitation to circuit speed. A solution is to use low dielectric constant materials and low resistivity materials. In this work, the influence of underlying barrier Ta on the electromigration (EM) of Cu on hydrogen silsesquioxane (HSQ) and SiO₂ substrates was investigated. The presence of a Ta barrier not only improves the adhesion between Cu and dielectrics, but also enhances the crystallinity of Cu film and improves the Cu electromigration resistance. The activation energy obtained suggests a grain boundary migration mechanism and the current exponent calculated indicates the Joule heating effect.     

Centrifugal Casting of High Speed Steel/Nodular Cast Iron Compound Roll Collar

Ｈｉｇｈ ｓｐｅｅｄｓｔｅｅｌ (ＨＳＳ) ,ｉｓｃｈａｒａｃｔｅｒｉｚｅｄｂｙｅｘ ｃｅｌｌｅｎｔｈａｒｄｎｅｓｓ ,ｗｅａｒｒｅｓｉｓｔａｎｃｅ ,ａｎｄ ｇｏｏｄｒｅｄｈａｒｄｎｅｓｓ .Ｒｅｃｅｎｔｌｙ ,ＨＳＳｉｓａｐｐｌｉｅｄｔｏｍａｎｕｆａｃｔｕｒｅｈｏｔｒｏｌｌｉｎｇｒｏｌｌｓｔｏｐｒｏｄｕｃｅｓｔｒｉｐｓｏｆｇｏｏｄｓｈａｐｅａｎｄｓｍａｌｌｃｒｏｗｎｗｉｔｈｅｘｔｅｎｄｅｄｒｏｌｌｓｅｒｖｉｃｅｌｉｆｅ[1,2 ] .ＴｈｅＨＳＳｉｓａｐｐｌｉｅｄｔｏｍａｎｕｆａｃｔｕｒｅｒｏｌｌｃｏｌｌａｒｆｏｒ…     

一种适用于有限长度混合相位未知脉冲的最小平方反褶积新方法

普通的最小平方反褶积只有在子波为最小相位脉冲和反射序列为白噪声的假设下才是成立的,而对于混合相位未知脉冲来说,这种最小平方反褶积就不再适用了。本文提出一种适合于有限长度混合相位未知脉冲的最小平方反褶积方法。运用此法只需预先估计一个混合相位子波的长度。合成数据的试验结果表明,该方法有较好的效果,且对预先估计出的子波长度不敏感。文中还证明混合相位未知脉冲最小平方反褶积等效于一种有间隙的平滑误差滤波器的作用,而这种有间隙的平滑误差滤波又可分解为一个前向多步预测误差滤波与一个后向多步预测误差滤波之和。可以预计这种新的反滤积方法将在地震数据处理中得到有效的应用。