烧结富氧点火自动控制的实现与应用

介绍了长钢烧结厂在24m^2烧结机上采用富氧点火自动控制的实现与应用。     

增产胺的合成与应用

在相转移条件下合成了增产胺，产率达９４％。田间实验表明，增产胺对大豆具有增加光合作用，促进生长，增花增英，大幅度提高单产的作用。大豆亩产增加３１．４％；大豆的质量明显改善，蛋白质和脂肪含量分别提高１５．３４％和６．５８％。     

C／O测井响应随源距变化的理论研究

针对井内介质分别为水、油，地层分别为３５％孔隙度饱和水砂和油砂的４种情况，采用蒙特卡罗方法模拟外径φ８９碳氧比测井仪不同源距处的非弹性散射伽马能谱。通过分析地层或井内介质不同时的Ｃ／Ｏ差值随源距变化的关系，为设计仪器推荐源距参数。     

转炉炼钢静态模型的初步探讨

根据转炉炼钢的物理化学反应机理，从质量平衡和能量平衡的计算出发，通过小参数变动，导出了增量式静态模型中矿石方程和供氧方程的系数。所得结论与新日铁资料基本相符。同时，还进行了炉料和产物的计算，分析了改变废钢比对生产的影响。     

不同灌溉条件下的水稻需水规律及水分生产率分析

稻田需水量包括植株蒸腾、棵间蒸发、田间渗漏3部分。研究表明，水稻在充分供水条件下所形成的蒸腾量中包含了一部分无效蒸腾，无效蒸腾量的减少不会影响作物的生长发育，反而会有不同程度的增产和优质效应。节水灌溉技术的推广产生了明显的经济与社会效益。结合当地实际情况采用3种常见的灌溉方式探讨了不同灌溉方式下水稻的需水规律、灌概定额和生产率的差异，为水稻节水高效栽培提供理论与技术依据。     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

Comparison of mass transfer efficiency in horizontal rotating packed beds and rotating biological contactors

In this study, the mass transfer efficiencies of a novel horizontal rotating packed (h‐RPB) bed and the conventional disc‐type rotating biological contactor (RBC) were studied at four speeds and seven submergences. Pall rings of two different sizes (25, 38 mm), superintalox saddles and a wiremesh spiral bundle were used as packings in the h‐RPB. Volumetric gas–liquid mass transfer coefficients were determined by unsteady state absorption of atmospheric oxygen in de‐aerated water. Power consumption per unit liquid volume has been found for all geometries tested. The oxygen transfer efficiency values for the h‐RPB were found to be 2–5 kg kWh^?1 and for the disc RBC were found to be 1–2 kg kWh^?1. The performance of the h‐RPB was also compared with other gas–liquid contactors such as surface aerators. The study proves that the h‐RPB is a energy efficient alternative to conventional contactors. Copyright © 2005 Society of Chemical Industry     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

On-demand Virtual Neonatal Intensive Care units supporting rural, remote and urban healthcare with Bush Babies Broadband

Premature and ill term babies born in regional Australia must be moved to another hospital with Neonatal Intensive Care Unit (NICU) facilities. Transferred pre-term and critically ill term babies have higher mortality rates and much higher rates of long term disability than similar babies born in hospitals with NICU facilities. This paper details the Bush Babies Broadband project that aims to significantly improve the quality of treatment for babies born in rural, remote as well as urban areas by providing the first on-demand virtual NICU architecture in Australia. Real-time data collected from medical monitors and ventilators attached to the baby, audiovisual streams and static physiological data such as X-ray images are transmitted to the consulting Neonatologist to gain a better picture of the patient's condition than is currently available. The key contribution of this significant research is the infrastructure providing a mechanism for Neonatologists to receive information directly from a regional hospital, thereby preventing, in some cases, the immediate need to move the baby. A key benefit of this framework is that it is available to link regional hospitals with the supporting NICU Neonatologist ‘on demand’ eliminating the need to establish permanent point to point connections. This paper further describes the application of that architecture to a specific pilot connecting the Bathurst regional hospital with Neonatologists within the NICU at Nepean Hospital, Penrith Australia.     

Ant colony optimization approach to estimate energy demand of Turkey

This paper attempts to shed light on the determinants of energy demand in Turkey. Energy demand model is first proposed using the ant colony optimization (ACO) approach. It is multi-agent systems in which the behavior of each ant is inspired by the foraging behavior of real ants to solve optimization problem. ACO energy demand estimation (ACOEDE) model is developed using population, gross domestic product (GDP), import and export. All equations proposed here are linear and quadratic. Quadratic_ACOEDE provided better-fit solution due to fluctuations of the economic indicators. The ACOEDE model plans the energy demand of Turkey until 2025 according to three scenarios. The relative estimation errors of the ACOEDE model are the lowest when they are compared with the Ministry of Energy and Natural Resources (MENR) projection.