Aspects of moisture kinetics of coal bottom ash in concrete

The moisture kinetics aspects of composite granular material samples composed of natural sand and bottom ash (BA) from thermoelectric power stations and the use of this material in the production of durable concretes, in relation to water transport, are here discussed. The evaluations of the phenomenon of water absorption by capillarity and the loss of water through air drying until hygroscopic equilibrium, were carried out in accordance with classic procedures found in the literature and also newly developed procedures. The results showed that due to the high porosity of BA, the water absorption by capillarity along with the absorption velocity were higher in the compositions with greater BA content. The values for moisture equilibrium from air drying, absorption from capillarity and sorptivity obtained in the hygroscopic equilibrium tests, carried out on the same samples after absorption, were also higher in the samples with BA. These samples also requited a longer drying time.     

锌灰制备活性氧化锌新工艺

以炼锌厂废锌灰为原料，经硫酸浸取制备活性氧化锌，考察了工艺条件对锌浸出率的影响。实验结果表明：锌灰在50℃浸取，酸用量40g／L，可使锌的溶出率达92．8％。碱式碳酸锌最佳水解温度为40℃，水解时间为2h，pH为7．5时，溶液中锌质量浓度为10g／L，得到96％以上的水解率。采用该工艺制得的氧化锌符合HG／T2572-1994。     

海工高性能混凝土用复合胶凝材料的试验研究

在调查分析海工混凝土工程实例的基础上，试验研究了硅酸盐水泥中掺入矿粉、粉煤灰、硅灰等混合材料对海工混凝土性能的影响。研究结果表明，在硅酸盐水泥中掺加矿粉、粉煤灰、硅灰等混合材料可以改善海工混凝土的综合性能。矿物混合材料的复合掺入比单独掺入能更好地改善混凝土抗Cl^-侵蚀性能。海工专用复合胶凝材料生产时宜尽可能地采用多种混合材料。     

硫酸盐腐蚀粉煤灰混凝土后强度超声检测评定

为进一步研究混凝土受硫酸盐侵蚀的机理,以粉煤灰混凝土为研究对象,在高浓度硫酸盐溶液中进行加速腐蚀,并结合受硫酸盐腐蚀后混凝土强度变化规律,采用超声平测法对受腐蚀混凝土进行检测．研究结果表明,超声平测声速与损伤度之间有较好的回归关系．在此基础上,建立了腐蚀混凝土强度与声速之间的关系模型．     

脱硫渣用于加气混凝土生产的试验研究

通过对邯郸市某电厂脱硫渣的化学组成及稳定性分析,探讨脱硫渣掺量对制品性能的影响,试图将脱硫渣替代石膏和部分粉煤灰用于加气混凝土的生产。试验结果表明:当脱硫渣掺量为10%时,能有效的抑制加气混凝土的前期发气速度,而且通过适当延长发气时间,可使气孔分布更为均匀,其制品干体积密度和强度均满足加气混凝土砌块要求;当掺量超过15%时,由于脱硫渣自身的活性低,制品变得脆而易爆裂;若脱硫渣单一代替石膏作为缓凝剂,则缓凝效果较差。     

掺固硫灰干粉砂浆的性能研究

对掺固硫灰干粉砂浆的性能进行了研究。讨论了固硫灰细度、掺量及与粉煤灰复掺对干粉砂浆工作性能、力学性能和膨胀性的影响。结果表明：经预处理固硫灰可以应用于干粉砂浆中,且掺量为10%时效果最佳。固硫灰与粉煤灰等矿物掺合料复掺可以改善干粉砂浆性能。     

给水处理投药控制的非线性数学模型及仿真

为了更好地控制给水处理系统中的投药量,本文用机理建模及分布参数系统建模的方法,建立了可用于给水处理投药过程控制的数学仿真模型,该仿真模型包括了给水处理过程中混凝、絮凝、沉淀3步最基本过程,反映了水厂各设计参数对水处理投药控制效果的影响以及混凝药剂与絮凝池、沉淀池出水浊度之间的动态响应关系.仿真模拟了水厂原水浊度发生突变对絮凝池及沉淀池的出水浊度的动态影响,仿真结果与实际水厂数据相近.研究结果可以用来进一步研究水处理过程控制,为更深入研究适用于给水处理的非线性控制方法提供良好的模拟仿真分析平台.     

Strength and chloride resistance of blended Portland cement mortar containing palm oil fuel ash and fly ash

This paper presented a study on the strength and chloride resistance of mortars made with ternary blends of ordinary Portland cement (OPC), ground palm oil fuel ash (POA), and classified fly ash (FA). The mortar mixtures were made with Portland cement type I containing 0-40wt% FA and POA. FA and POA with 1wt%-3wt% retained on a sieve No.325 were used. The compressive strength and rapid chloride penetration depth of mortars were determined. The results reveal that the use of ternary blended cements produces ...     

Influence of fly ash on early-age cracking behavior of high-flowing concrete

The effects of quality and content of fly ash on the early-age cracking behavior of high-flowing concrete (HFC) were investigated. The early-age cracking behavior of the HFC was analyzed by combining the tests of evaporation capacity and electrical resistivity of the HFC. In these tests, a modified flat-type specimen was adopted. The results show that the HFC will have a lower evaporation capacity when it is mixed with fine fly ash, while it will have a higher evaporation capacity when grade III fly ash is used as mineral admixture. And the electrical resistivity rate of HFC reduces with the increase of the content of fly ash. A nonlinear relationship exists between the cracking time of HFC and the minimum electrical resistivity. The early-age cracking behavior of HFC with fly ash can be enhanced by appropriately increasing the fine particle content and MgO, K₂O, and SO₃ contents of fly ash. The optimal content of fly ash, which makes a satisfied early-age cracking behavior of HFC, is obtained. And when the content of fly ash exceeds a critical value, the early-age cracking behavior of HFC will rapidly decrease. Foundation item: Project(50478003) supported by the National Natural Science Foundation of China; Project(2002F007) supported by the Natural Science Foundation of Fujian Province, China     

Preparation and mechanical properties of polypropylene fiber reinforced calcined kaolin-fly ash based geopolymer

To improve the environmental benefits and solve the problems of large shrinkage and high brittleness, the partial replacement of calcined kaolin by fly ash as a raw material for geopolymer synthesis and the influences of polypropylene (PP) fiber on the mechanical properties and volume stability were investigated. The results show that compressive strength of the geopolymer containing 33.3%(mass fraction) fly ash by steam curing at 80 °C for 6 d is improved by 35.5%. The 3-day compressive strength, flexural strength and impacting energy of geopolymers containing 0.05%PP fiber increase by 67.8%, 36.1% and 6.25%, while the shrinkage and modulus of compressibility decrease by 38.6% and 31.3%, respectively. The results of scanning electron microscopy (SEM) and the appearances of crack growths confirm that PP fiber can offer a bridging effect over the harmful pores and defects and change the expanding ways of cracks, resulting in a great improvement of strength and toughness. Foundation item: Project(2006AA06Z225) supported by the National High-Tech Research and Development Program of China