高性能混凝土的尝试

针对普通混凝土耐久性差、寿命短等不足 ,结合实践试验 ,阐述了大掺量的粉煤灰制作高性能混凝土的试验方法 ,并对其试验效果进行了评析。指出了制作高性能混凝土的普遍可行性     

初春施工技术要点探讨

论述了初春施工这个特定的施工季节所具有的特征，从气候、施工人员、工程情况及受冻土体等方面对初春施工易出现的问题进行了分析，对施工过程及施工技术规律性问题做了细化性研究和探讨。     

时空效应规律在软土深基坑工程中的运用

阐述了时空效应规律在软土深基坑工程中的运用情况，实践证明，运用时空效应规律，能可靠而合理地利用土体自身在基坑开挖过程中控制土体位移的潜力而达到保护环境的目的。     

泥土中微量六氯环戊二烯的气相色谱分析

采用SE 3 0为固定液进行色谱柱分离 ,用外标定量法测定泥土中的微量六氯环戊二烯 ,结果最小检知量为 0 .18× 10 - 6 ,相关系数为 0 .99992。     

浅谈采用短木桩加土工网碎石垫层处理挡墙软基

结合工程实例，对采用传统的短木桩加新兴的土工合成材料——土工网及碎石垫层构成复合基础，处理河岸挡墙软基进行探讨，该方法在软土层厚度不超过4．0m的条件下，技术可靠，施工简单，工期短，造价低。     

Copper(II) removal from aqueous solutions by fly ash

The removal of Cu(II) by adsorption on fly ash has been found to be concentration, pH and temperature dependent. The kinetics of adsorption indicates the process to be diffusion controlled. The Langmuir constants have been calculated at different temperatures, and the adsorption has been found to be endothermic (ΔH = 15.652 kcal mol^?1). The maximum removal is observed at pH 8.0, and variation in adsorption with pH has been explained on the basis of surface ionisation and complexation.     

焦化加热炉空气预热器腐蚀结垢与预防

空气预热器运行的好坏直接影响到加热炉的热效率 ,文章结合焦化装置加热炉空气预热器的使用、维修、改进等 ,论述了预热器存在的露点腐蚀问题。同时提出从设计、操作、设备等方面采取有效措施 ,保障预热器的长周期高效运行。     

爆破飞石的外弹道研究

本文利用现代外弹道数学理论，考虑了飞石的反弹作用和空气阻力作用，建立了飞石飞掷的数学物理模型，由此推导出爆破飞石飞掷距离计算公式。     

Modified oil agglomeration process for coal beneficiation. III. Grinding and agglomeration using different szego mill designs

The simultaneous grinding/agglormeration process has been used to beneficiate Minto coal. Experiments with the Szego Mill, a planetary ring-roller mill with grooved rollers, have given good results. Different roller ridge/groove sizes have been tested and favourable oil-coal-water ratios established. Ash removal is closely related to grinding performance. Very short mill residence times, of the order of 10 seconds, are sufficient for microagglomerate formation. Considerable equipment and operating cost savings are possible with the modified process.     

The current and residual value of superphosphate for lupins grown in rotation with oats and wheat on a deep sandy soil

In a field experiment on a deep pale-yellow sand in a 600 mm per annum rainfall Mediterranean environment of south-western Australia, six levels of phosphorus (P) as superphosphate (O up to 546 kg P ha^–1) were applied once only, to the soil surface, before sowing lupins (Lupinus angustifolius). The lupins were grown in a continuous arable cropping rotation with, in successive years, oats (Avena sativa), wheat (Triticum aestivum), lupins. Five such rotations were started in the experiment from 1985 to 1989. The experiment continued until the end of 1990.The relationship between lupin seed (grain) yields and the level of P applied was measured in the year of P application for five successive years (1985 to 1989). The relationship had the same general form but it varied between years, largely due to different maximum yields (yield plateaux) in each year.The residual value of superphosphate applied three years previously was measured for lupins on two occasions (1988 and 1989) relative to superphosphate applied in the current year. The residual values was different in the two years. The superphosphate applied three years previously was about 30% as effective as freshly applied superphosphate in 1988, and 12% as effective in 1989.At each harvest, the relationship between grain yield and the P concentration in the grain differed for different species. However, for each species at each harvest, the relationship was similar regardless of when the P was applied in the previous years. Thus each species had the same internal efficiency of P use curve, and yields varied only with P concentration in tissue.Bicarbonate-extractable soil P was determined on soil samples taken in mid-July of 1989 and 1990. These soil test values were related to grain yields at harvest. The relationship between yield and soil test values had the same general form but varied for different species within years and for each species between years. It also varied for each species within years depending on the year the P was applied.