中原高温高盐油藏疏水缔合聚合物凝胶调剖剂研究

针对中原油田高温(>80℃)、高盐度(>50 g/L)、高硬度(>1 g/L)砂岩油藏,研制了地下成胶的高热稳定性聚合物凝胶调剖剂。所用聚合物为疏水缔合聚合物AP-P4,M=9.0×106,HD=27%,疏水基摩尔分数0.2%;交联剂为可生成酚醛树脂的3种化合物;调剖剂胶液用矿化度160 g/L的马寨油田污水配制;实验温度95℃。根据形成的凝胶黏度(95℃,1.1 s-1)确定交联剂各组分用量为:MZ-YL 0.429%,MZ-BE 0.060%,MZ-XS 0.012%;酸度调整剂用量0.12%;成胶时间10~15小时。2.5、3.0、3.5 g/L AP-P4的凝胶在95℃老化100天后黏度保持在~40 Pa.s及以上。初配制胶液在3000 r/min下剪切15分钟后黏度降低87.5%~89.0%,但成胶后和老化过程中凝胶黏度只比未剪切样降低17.1%~6.6%。3.5 g/L AP-P4的调剖剂对~1μm2的6支储层岩心的堵塞率在88.1%~95.8%范围,平均93.3%,造成的残余阻力系数在15.2~28.6范围,平均19.8,使渗透率级差2.3~8.0的4组双人造岩心的注水流量比发生不同程度的反转。认为该凝胶调剖剂高温下稳定性好的原因,是强化学交联密度低,因而凝胶脱水收缩作用弱。图2表5参5。     

NETWORK6000在脱离子水处理过程中的应用

脱离子水处理单元是一种顺序控制单元，对时序控制有严格的要求。文中介绍了一种新型的控制系统NETWORK6000在PTA装置脱离子水单元中的应用状况，为中小规模的装置应用提供了一种较典型的思路和借鉴，最后对系统的应用状况进行了评价。     

电子仪器发展趋势

本文在回顾了电子仪器近百年发展的历史的基础上,对国际电子仪器制造商、电子仪器行业及电子仪器本身的发展趋势,以及我国电子仪器的发展情况进行了分析归纳和总结.     

Fetal Neurobehavioral Development: A Tale of Two Cities.

Longitudinal neurobehavioral development was examined in 237 fetuses of low-risk pregnancies from 2 distinct populations-Baltimore, Maryland, and Lima. Peru-at 20. 24. 28. 32, 36. and 38 weeks gestation. Data were based on digitized Doppler-based fetal heart rate (FHR) and fetal movement (FM). In both groups. FHR declined while variability, episodic accelerations, and FM-FHR coupling increased, with discontinuities evident between 28 and 32 weeks gestation. Fetuses in Lima had higher FHR and lower variability, accelerations, and FM-FHR coupling. Declines in trajectories were typically observed 1 month sooner in Lima, which magnified these disparities. Motor activity differences were less consistent. No sex differences in fetal neurobehaviors were detected. It is concluded that population factors can influence the developmental niche of the fetus. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

略论贵州省化工企业职业教育的发展

从目前市场需求和就业率出发，进行形势分析，提出优化专业设置、加强实践环节、提高高职学院办学层次、推进“双证书”制度等改革方法，以促进化工职业教育的发展。     

我国电力光缆应用和市场的发展及问题

追溯了我国电力光缆应用的发展过程，讨论了在市场和产业的形成、发展中所出现的问题。     

GZF高压注水井口测试防喷器的研究与应用

针对高压 (2 5MPa以上 )分层注水井进行井下分层流量测试时 ,上顶力大 ,仪器下井困难 ,井口喷漏严重 ,测试工人劳动强度大等问题 ,研制了GZF高压注水测试井口防喷器。这种防喷器采用节流降压原理进行设计 ,主要由自动输送钢丝装置、节流降压密封装置和防喷管总成 3部分组成 ,是一种用于高压注水井下测试和投捞调配的井口辅助工具 ,具有井口防喷和输送钢丝两大功能。现场试验证明 ,该防喷器结构紧凑、安装使用方便、密封可靠 ,使用井口压力可达 35MPa,自动化程度高 ,可保证仪器顺利下井 ,同时还将高空人力手送钢丝改为远距离自动输送 ,操作灵活、简单安全。特别适用于低渗高压分层注水井的井下测试和投捞。     

应用吸水剖面资料确定吸水层动态残余油饱和度的方法

基于岩心长期注水试验资料，认识到吸水层的残余油饱和度的变化是一个缓慢减小的过程。文章给出了动态残余油饱和度的概念，提出了利用吸水剖面测井资料来确定动态残余油饱和度的方法。通过现场实测资料的解释，建立了动态残余油饱和度与吸水层每米累计吸水量的定量关系，为剩余油分布研究提供新思路。     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry     

内燃机车临时补水设备的设计与应用

针对内燃机车“途中缺水”故障 ,设计并安装临时补水设备 ,解决了电化区段临时补水的问题 ,满足了内燃机车“不停车、不停机”即可补水的要求。