网壳结构内扩安装法施工内力特性分析

本文针对目前国内常用的网壳内扩安装法，全过程跟踪分析了构件在用内扩法安装期间的施工内力特性及其变化规律，得出了网壳结构设计计算必须考虑施工内力的影响等重要结论。     

两种不同界面结合强度碳/铝复合材料的内耗特性

本文研究了两种不同界面结合强度的碳/铝复合材料经不同次数加载热循环处理后的内耗值及内耗机制。弱界面结合的C/L2复合材料的内耗值变化主要由界面脱粘引起,而强界面结合的C/LD2复合材料的内耗值变化主要由位错运动所致。     

Tribological issues in reducing piston ring friction losses

In this paper improvement in fuel economy by reducing piston ring friction is studied and reduction of piston ring tension and the use of two-ring packages are found to be effective. However, these can be accompanied by adverse effects such as excessive wear and increasing oil consumption, and measures to overcome these problems are studied in detail.     

含硫氰基团化合物的摩擦学性能及其摩擦化学机理研究

以三烷基磷酸酯络合硫氰酸钙为模型化合物研究了含硫氰基团的络合物的摩擦学行为，发现它有高的承载能力，良好的抗磨减摩性。用俄歇能谱（ＡＥＳ）、Ｘ－射线衍射（ＸＲＤ）、扫描电镜（ＳＥＭ）及Ｘ－射线能谱（ＥＤＸ）研究了摩擦表面元素组成及其可能物相。探讨了摩擦化学机理，认为化合物中的硫氰基团对摩擦学性能起主要作用，并在摩擦过程中发生类似于化学热处理中的硫氰共渗。     

连续驱动摩擦焊动态扭矩检测的新方法—VCMM法

连续驱动摩擦焊动态扭矩检测的新方法──ＶＣＭＭ法刘金合，罗键连续驱动摩擦焊扭矩是一个重要的工艺参数。摩擦焊扭矩是动态扭矩，具有时变性、速变性以及变化范围大等特点。现有的检测摩擦焊扭矩的方法均有一定的局限性’‘－’‘，本文提出了通过驱动主电机定子电压和...     

Microstructure and Mechanical Properties of Heat-treated GeSb_2Te_4 Thin Films

The effect of annealing on microstructure,adhesive and frictional properties of GeSb 2 Te 4 films were experimentally studied.The GeSb 2 Te 4 films were prepared by radio frequency(RF)magnetron sputtering,and annealed at 200℃and 340℃under vacuum circumstance,respectively.The adhesion and friction experiments were mainly conducted with a lateral force microscope(LFM)for the GeSb 2 Te 4 thin films before and after annealing.Their morphology and phase structure were analyzed by using atomic force microscopy(AFM)and X-ray Diffraction(XRD)techniques,and the nanoindention was employed to evaluate their hardness values.Moreover,an electric force microscope(EFM)was used to measure the surface potential. It is found that the deposited GeSb 2 Te 4 thin film undergoes an amorphous-to-fcc and fcc-to-hex structure transition;the adhesion has a weaker dependence on the surface roughness,but a certain correlation with the surface potential of GeSb 2 Te 4 thin films.And the friction behavior of GeSb 2 Te 4 thin films follows their adhesion behavior under a lower applied load.However,such a relation is replaced by the mechanical behavior when the load is relatively higher.Moreover,the GeSb 2 Te 4 thin film annealed at 340℃presents a lubricative property.     

聚醚合成工业齿轮油的研制

以聚醚为基础油辅以抗磨剂、抗氧剂、防锈剂等多种添加剂研制而成的KGW聚醚合成工业齿轮油具有优异的黏温性能和低温性能，优异的极压抗磨性，极优的减摩性能，可满足高负荷、强冲击等苛刻条件下各类齿轮传动装置的润滑要求。该系列产品达到国外同类油品质量水平。     

宽带激光熔覆WCP/Ni基合金梯度复合涂层组织与摩擦磨损特性

研究了铸造WC_P/Ni基合金梯度复合涂层组织与摩擦磨损特性。结果表明,梯度复合涂层与基材实现了良好的冶金结合,涂层内有γ-Ni枝晶组织,γ-Ni＋M₂₃C 6共晶组织以及凝固结晶析出的M₆C、M₂₃C₆、M₇C₃等块状或条状组织;随着铸造WC_P体积分数的增加,复合涂层摩擦系数减小,耐磨性增加。19-4试样的耐磨性最高值为4.61,是基材的3倍以上。梯度涂层的磨损机理为磨粒磨损与粘着磨损的复合作用。     

Internal-corrosion inhibitors for pipelines carrying deaerated heating water

The effect of internal-corrosion inhibitors on heating-system pipelines is investigated. Tests were conducted on a testing device for polarization measurements under conditions corresponding to the Rostov Heat-Supply System. The concentration of OEDP-zinc, which provides a high degree of protection from general corrosion, is determined. The reagent has been successfully incorporated into the Rostov No. 2 TPP. __________ Translated from élektricheskie Stantsii, No. 7, July 2007, pp. 37–43.     

Internal-corrosion inhibitors for pipelines in heat-supply systems carrying water with a high oxygen content

The reliability of heat-supply systems is determined primarily by internal corrosion of the pipelines. The concentration of oxygen in the water exerts a major influence on the corrosion. In systems with a standard oxygen content, OéDF-Zn is a highly effective corrosion inhibitor. However, there are systems in which the quality of deaeration of the make-up water of the heat-supply system is low (or deaeration is nonexistent), and the concentration of oxygen is considerably above the standard value. Classed among these systems, for example, are the HWS systems, which are incorporated into closed heat-supply systems. The oxygen concentration in these systems is analyzed to assess the situation. __________ Translated from élektricheskie Stantsii, No. 6, June 2007, pp. 35–39.