Adaptive control in a heating vessel: A comparative study

This paper presents experimental results obtained in temperature adaptive control of a heating vessel. A non-linear model of the process showed that the feed flow rate causes severe variations in time constant and process gain. An extended horizon self-tuning controller and two different model reference adaptive controllers were tested. The influence of design parameters on control performance for each algorithm was assessed. The control system was disturbed with load and setpoint changes.     

Basic concept and decentralized autonomous control of super‐distributed energy systems

New small‐scale dispersed generation systems, such as fuel cells and micro gas turbines, have made remarkable advances lately and they will be applied practically in the near future. Although a large number of researches on the introduction of small‐scale dispersed generation systems have been carried out, only a small number of small‐scale dispersed generation systems are considered in these researches. Therefore, little is known about problems to be solved when a large number of small‐scale dispersed generation systems are introduced into electric power systems. This paper deals with a super‐distributed energy system that consists of a great number of dispersed generation systems such as fuel cells, micro gas turbines, and so on. The behavior of a customer with a dispersed generation system is simulated as the Ising model in statistical mechanics. The necessity of a distribution network in super‐distributed energy systems is discussed based on the Ising model. The feasibility of decentralized autonomous control using vicinity information is also investigated on the basis of stability analysis of the Hopfield neural network model. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 151(1): 43–55, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10368     

Series resonant ZCS‐PFM DC‐DC power converter with high‐frequency high‐voltage transformer link for high‐power magnetron drive

This paper presents a single lossless inductive snubber‐assisted ZCS‐PFM series resonant DC‐DC power converter with a high‐frequency high‐voltage transformer link for industrial‐use high‐power magnetron drive. The current flowing through the active power switches rises gradually at a turned‐on transient state with the aid of a single lossless snubber inductor, and ZCS turn‐on commutation based on overlapping current can be achieved via the wide range pulse frequency modulation control scheme. The high‐frequency high‐voltage transformer primary side resonant current always becomes continuous operation mode, by electromagnetic loose coupling design of the high‐frequency high‐voltage transformer and the magnetizing inductance of the high‐frequency high‐voltage transformer. As a result, this high‐voltage power converter circuit for the magnetron can achieve a complete zero current soft switching under the condition of broad width gate voltage signals. Furthermore, this high‐voltage DC‐DC power converter circuit can regulate the output power from zero to full over audible frequency range via the two resonant frequency circuit design. Its operating performances are evaluated and discussed on the basis of the power loss analysis simulation and the experimental results from a practical point of view. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 153(3): 79–87, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20126     

Optimal Control of Solar Sludge Dryers

Optimal control (OC) methodology is used to develop a control policy for a batch-operated solar sludge dryer with ventilation as the dominant control. Batch performance criteria and instantaneous optimization criteria are developed for two economic environments: quota limited and capital limited. The general formulation, as well as simplifications resulting from the multiplicative form of the evaporation (drying) rate model, are presented. The multiplicative form results in a single constant number, called here “control intensity,” which is used to guide the on-line control decisions. These decisions turn out to be independent of the dry solids content (DSC) of the sludge. Further simplification, by assuming a strictly constant weather, is used to demonstrate the general effects of the economic and physical (weather) environment on the solution.

The OC approach is used to address, via simulation under realistic weather conditions, several design, operation, and pricing problems. In particular, the following have been considered: sizing of the ventilation fans, determination of a fair fee for sludge disposal, finding the best final DSC, and evaluating the effect of the price of electricity. Regarding the particular location represented by the data, it has been shown that the installed capacity of the ventilation fans should be increased and that there seems to be sufficient economic incentive for solar drying.     

Multiobjective dynamic load-dispatching method for optimal operation of power systems

A new practical method is proposed which gives a quasi-optimal solution of the dynamic load-dispatching problem formulated by a multiconstraint multiobjective optimization problem. Here, the multiple constraints are rate reserve constraints and power flow ones, and the multiple objectives are fuel cost and CO₂ emission. The proposed method is an integration of the following three techniques: (1) “Group Dispatch Scheme,” which is developed by the authors, is used to satisfy a violated constraint easily. This scheme consists of three steps. The first step is to classify all generators into two groups. One is the group which should be more loaded to satisfy the violated constraint, and the other is the should-be less loaded group. The second step is to add some load to the former group, and to subtract the same load from the latter. The third step is to dispatch each group load to each groups generators, respectively; (2) the dynamic load-dispatching algorithm is used which provides, in practical time, quasi-optimal generation trajectories; (3) the conventional weighting parametric method is used to obtain a Pareto optimal solution of multiobjective problems. The effectiveness of the method is clarified by a computer simulation on the actual power system of Kansai Electric Power Company.     

Expert system for dispatch control in restoration of ehv power system after complete blackout

Present-day power systems operate with high reliability, and it is rare that a blackout will extend over an entire system swiftly and securely. This paper considers automatic power supply to loads after a complete blackout of a system. First, taking into account characteristics of generators, loads, and initial power sources, a method is proposed of allocating several generators to each load in parallel to the system and supplying power to the load sequentially. Second, to remove the imbalance between supply and demand of power, a method is proposed of adjusting the amount of supply and generation according to a present imbalance and the sum of past ones. Third, to automatically issue orders for start-up, parallel, follow-up, stand-by, and stoppage of generators, several rules for each power station are set and an expert system is made based on them. Finally, the expert system is applied to a model power system, and it is verified that it can restore loads without any trouble for a complete blackout which occur at any time of a day and in any restoration pattern.     

强化会计内部控制促进高校科学管理

建立和强化完善的会计内部控制体系,对于高校优化资源,促进科学管理有着重要意义.针对当前高校会计内部控制的不足,提出了若干解决对策.