阿曼Daleel油田分支井钻井液技术研究

对Daleel油田作业5区三分支水平井DL-59井井下复杂情况分析,室内测定了引起复杂情况的Nahr Umr泥页岩地层的矿物组分和粘土矿物含量,优选了适应在该泥页岩地层215.9 mm造斜井段的钻井液配方中的各种处理剂,最后研制出钻井液配方,通过DL-73井应用后,取得了良好的防塌效果.     

Numerical characterization of a microscale solid-oxide fuel cell

In this study, a single unit of planar micro-solid-oxide fuel cell (μSOFC) is investigated numerically to evaluate the influences of flow channel design, oxygen composition, and thermal operating conditions on cell performance. Four flow channel designs are examined under the co-flow configuration: serpentine, double serpentine, rod bundle, and oblique rib. For all designs, the contacts areas of interconnect to electrodes are kept consistent to maintain the ohmic losses at the same level. To characterize the mass transport effects, there are three different compositions, 100% O₂, 50% O₂/50% N₂ and air, fed to the cathode inlet. Different thermal conditions, adiabatic and isothermal, are applied to the outer boundary of the μSOFC and the results are compared. The outcomes suggest that both thermal conditions and oxidant composition show remarkable influences on μSOFC performance. Under adiabatic conditions, the rise of cell temperature causes a decrease in reversible voltage, deteriorating the overall cell competence. When oxygen is diluted with nitrogen, local gas diffusion becomes dominant to the cathode reaction. Bulk flow, on the other hand, plays a minor role in cell performance since there is little deviation in the polarization curves for all flow channel designs, even at high current densities. For comparison, the flow visualization technique is employed to observe the transport phenomena in various flow channel designs. The flow patterns are found to resemble the concentration distribution, providing a useful tool to design μSOFCs.     

La3+掺杂对纳米TiO2微观结构及光催化性能的影响

以钛酸丁酯和氯化镧为原料,采用溶胶-凝胶法制备了La3+掺杂TiO2纳米粉体,讨论了不同掺杂浓度、不同热处理温度的样品催化降解刚果红染料实验中的光催化活性,并通过X射线衍射(XRD)、透射电镜(TEM)分析了La3+掺杂TiO2样品的相组成、晶胞参数和晶粒大小对光催化活性的影响.结果表明:La3+掺杂能够显著提高TiO2粒子的光催化活性,最佳掺杂浓度为100∶3 0,最佳热处理温度为600℃;La3+掺杂的TiO2的相组成是影响光催化活性的决定性因素;晶格膨胀程度及晶粒大小对光催化活性的影响,主要是在相组成相同或相近时才体现得比较明显.     

Effect of Hydrogen Heat Treatment on the Chemical Composition of Aluminum Nitride Powder

The effect of hydrogen heat treatment on impurity contents in aluminum nitride powder of different fineness is studied. Thermodynamic calculations are provided pointing to the possibility of forming gaseous hydrogen compounds with impurity elements. It is established that as a result of treatment the contents of impurity elements, i.e. oxygen, carbon, sulfur, are reduced by a factor of 3-13. The optimum hydrogen heat treatment regime is determined: a temperature of 1323 K and an exposure time of 30 min.     

我国金矿床氧化带的地质地球化学特征

根据氧化矿石的主要化学成分，应用ＦＡＳ图解进行氧化矿石的化学成分分类；通过对氧化带分带及发育型式的研究，建立了我国金矿氧化带形成的地质地球化学模式；对影响氧化带发育的因素进行了初步探讨。     

水溶液中硅酸溶解和胶结的实验研究

本研究了几种不酸ＰＨ值对硅酸胶结的影响。结果表明，草酸浓度增大时，硅酸胶结速度变缓，至ＰＨ３－４时，硅酸不再胶结；而ＨＣＬ浓度增大，虽然胶结速度变缓，但最终仍胶结。     

CH_4、CO_2与O_2制合成气的研究 Ⅱ工艺条件的影响

在固定床反应器中考察了１２％Ｎｉ－５％ＲＥ－２％Ｃｕ－２％Ｌｉ／Ａｌ２Ｏ３（ｍａｓｓ）催化剂在ＣＨ４、ＣＯ２与Ｏ２催化氧化重整制合成气反应中催化剂粒径、工艺操作条件（空速与温度）及原料气配比对反应的影响，确定了较佳的操作条件：催化剂粒径２０～４０目，反应最佳温度为８００℃，ＳＶ＝４×１０４ｍｌ／（ｇ·ｈ）。同时看到在不同的原料气配比的条件下该催化剂的活性亦很稳定，不仅达到了反应平衡，且产物Ｖ（ＣＯ）／Ｖ（Ｈ２）比有很强的调变性。     

The multi-structure of oxidized-reduced tungsten carbide surface(s)

The XPS of bulk tungsten carbide, partially oxidized WC surfaces at 373 and 573 K as well as tungsten trioxide have been reported. Bulk WC has been prepared from WO₃ as a starting material in a mixture of CH₄ (20%) and H₂ (80%) at 1150 K for 4 h, while partially oxidized WC surfaces were prepared by oxygen chemisorption on a clean WC surface at 200 K, then the temperatures were raised to 373 and 573 K respectively. The XPS of a freshly prepared WC reveals the presence of a small amount of WO₃ on the surface and a slightly higher concentration in the bulk. The oxygen-exposed fresh WC surfaces and surfaces treated at temperatures higher than 373 K show the presence of WO₃ in a considerable quantity depending on the length and the treatment temperature. Ar⁺ bombardment of this partially oxidized surface reduces WO₃ to WO₂ and W(0), while WC is partially reduced to W(0). Isomerization reactions of alkanes on oxygen-exposed WC surface occurs in reality on a composite surface structure containing WC, WO₃, WO₂ and elemental W(0).     

Hardness evaluation of epoxy resin filled with mineral waste

The care of the world environment poses many challenges to the proper disposal of mineral wastes. Particulate wastes can be used to modify the properties or lower the cost of polymers. The influence of an iron–silica rich waste on the hardness of an epoxy resin is evaluated in this work. It is shown that the hardness values are polymer dominated for volume fractions of waste lower than 0.30, but for higher volume fractions a useful increase in the hardness numbers can be achieved. The coarser the particles are the more heterogeneous is the microstructure of the composite. Nevertheless, particulate rich layers increase the hardness of the material several times. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 2178–2184, 2002     

Human urine - Chemical composition and fertilizer use efficiency

Stored human urine had pH values of 8.9 and was composed of eight main ionic species (> 0.1 meq L^–1), the cations Na, K, NH₄, Ca and the anions, Cl, SO₄, PO₄ and HCO₃. Nitrogen was mainly (> 90%) present as ammoniacal N, with ammonium bicarbonate being the dominant compound. Urea and urate decomposed during storage. Heavy metal concentrations in urine samples were low compared with other organic fertilizers, but copper, mercury, nickel and zinc were 10–500 times higher in urine than in precipitation and surface waters. In a pot experiment with¹⁵N labelled human urine, higher gaseous losses and lower crop uptake (barley) of urine N than of labelled ammonium nitrate were found. Phosphorus present in urine was utilized at a higher rate than soluble phosphate, showing that urine P is at least as available to crops as soluble P fertilizers.