The Effect of Moisture Content on the Conversion of Ergosterol to Vitamin D in Shiitake Mushrooms

The distribution of ergosterol in different parts of shiitake mushrooms was studied in order to optimize the conversion of ergosterol to vitamin D₂ during drying. The effect of moisture on the conversion of ergosterol to vitamin D₂ was also investigated by adjusting the moisture content of fresh mushrooms to different levels in a large vacuum desiccator and subjecting them to UV irradiation at 290-320 nm wavelength, for 2 h. The moisture, ergosterol and vitamin D₂ contents were determined using standard procedures. It was found that the ergosterol content on a dry matter basis of fresh shiitake mushroom was highest in the gills (10.6 ± 0.99 mg/g DM), followed by the cap or pileus (5.34 ± 0.64 mg/g DM) and was least in the stalk or stipe (2.97 ± 0.56). The moisture content had a marked influence on the conversion of ergosterol to vitamin D₂, the best conversion taking place at a moisture content of about 70% on a wet basis.     

用热失重法确定水合粘土水分含量及存在形式

文章以蒙脱土为例，采用热失重法定性定量确定了水合粘土中结合水类型、界限及其相对含量，并与等温吸附法结果进行了对比。结果表明，用该方法得到的水合蒙脱土中各种水分的相对含量及总含水量与等温吸附实验结果相一致。热失重（25~250 ℃）分析结果表明，水合蒙脱土中水分子主要存在自由水、松散吸附结合水、紧密吸附水（强吸附结合水）3种状态，分别对应于25~75 ℃、75~120 ℃、120~230 ℃区间里的失水。从热失重（25~250 ℃）规律来看，仍存在两个明显的转折点p/ps=0.9、0.98，它们为粘土-水体系的两个特征湿度，前者为粘土表面强结合水与松散结合水（渗透结合水）之间的界限，后者为松散结合水与自由水之间的界限，这验证了等温吸附法确定的两个特征湿度及对粘土表面结合水界限划分的正确性。     

L520型智能中子仪测定农田土壤含水量的标定研究

通过对L520型智能中子仪测定农田土壤含水量的标定研究，在试验区草甸土类型的土壤中，在0～100cm的土层中得到了一条标定土壤含水量的回归直线，用此法测定土壤含水量较重量法快捷方便且误差小。     

Spatiotemporal aspects of jerky flow in Al–Mg alloys, in relation with the Mg content

The spatiotemporal aspects of the Portevin–Le Chatelier effect in Al–Mg alloys are investigated using direct observations of the sample surface with a digital camera. Optical measurements of the surface profile using a white light interferometer allow the estimation of the local strain and strain rate associated with the bands. The effect of Mg content on instability characteristics is analyzed. The reloading time is shown to depend on the Mg content only at the strain and strain rates where type C bands are observed.     

Crack Development in Individually Quick Frozen Cut and Peel Carrots

ABSTRACT:  Crack development during freezing (CDF) is one of the major challenges in individually quick frozen (IQF) cut and peel carrot processing. The effects of processing and freezer storage on crack development were examined on the cut and peel carrot variety, Sugarsnax. Carrot samples were removed from the major processing steps, the trans-slicer, the shaper, the blancher, and the dryer, and examined for crack development by measuring percentage cracked, crack morphology, total soluble solids, moisture levels, and membrane injury index immediately after processing. These parameters were also examined following 20 wk of standard freezer storage for cut and peels. Approximately 2% of nonprocessed carrots were cracked compared to 45% of carrots after the initial trans-slicing stage. As the processing continued, cracking decreased due to the removal of the outer epidermis to 16% of the finished product. This suggests that CDF was initiated at the 1st processing stage. Crack width and depth were 2.3 and 2.6 mm, respectively, at the trans-slicer stage and decreased to 1.1 and 1.8 mm at the end of the line. It was found that CDF was further exacerbated by freezer storage due to inefficient water removal at the dryer stage. Crack width and depth increased to 1.5 and 3.0 mm after 20 wk for freezer storage. Root size also played a role in CDF, suggesting that larger pieces are more susceptible to crack development. Total soluble solid concentrations did not play a role in crack formation during cut and peel processing.     

霍林河一号露天矿煤层灰分变化规律的研究

详细地论述了霍林河一号露天矿各煤层的灰分特征和同一煤层不同地段灰分的变化情况,揭示了各煤层灰分的变化规律,为露天开采提供了可靠的技术保证。     

A kinetic study on isothermal crystallization of palm oil by solid fat content measurements

Isothermal crystallization of plam oil was studied by means of differential scanning calorimetry (DSC) as well as by nuclear magnetic resonance spectrometry to monitor its solid fat content (SFC). The temperature of crystallization (Tc) varied from 0 to 30°C, depending on the method used. The plot of %SFC vs. time at 25°C was sigmoidal in shape. However, at lower temperatures, two consecutive curves were clearly visible. Results from DSC experiments showed the following interesting features. At each Tc, the crystals produced were of different compositions. From 0 to 8°C, the thermogram showed three peaks, with the first two peaks (I and II) sharp, and the third (III) rather broad. At elevated temperatures up to 20°C, peak II disappeared totally while peak III tended to shift toward peak I. Above 20°C, both peaks shifted downward to longer times. Peak I continued to be broadened, and then suddenly disappeared at Tc above 24°C. The melting thermograms of the crystals obtained above and below this cut-off point were distinctly different. Kinetic studies on isothermal crystallization based on the data of SFC measurements showed that the data fit well into the Avrami-Erofeev equation with n=3 over the first 70% of the crystallization.     

降低过滤机滤饼水分和细粒煤脱水浅析

根据对选煤厂细粒煤样的实验室优化脱水试验、工业试验及分析结果 ,对真空系统、气水分离器和分配头实施了技术改造 ,细粒煤脱水系统的运行状况得到显著改善 :圆盘真空过滤机滤饼水分降到 2 0 %左右 ,脱饼率在 95 %以上 ,每年的直接经济效益可达 30 0多万元     

沁水煤田瓦斯含量与地质因素的关系

为确实做好瓦斯的洲报工作，研究了沁水煤田地质因素与瓦斯含量的关系，辩证地分析了瓦斯的赋存规律。     

气体悬浮焙烧炉内衬烘炉曲线的确定

根据所使用的低水泥浇注料的性能，对中铝山西分公司检修厂4号焙烧炉制定了合理的烘烤曲线，提高了耐火内衬的质量，延长了内衬的使用寿命。