硫酸盐浆厂污水处理工程及单元技术特点

本文简略介绍云南某硫酸盐浆厂污水处理工程采用的国内不多见的污水单元技术，并对其先进性和实用性效果进行评价和探讨。     

Acidogenic fermentation of blended food‐waste in combination with primary sludge for the production of volatile fatty acids

The performance of a laboratory‐scale anaerobic acidogenic fermenter fed with a mixture of blended kitchen food‐waste and primary sludge from a sewage treatment plant was investigated for the production of volatile fatty acids (VFA). The operating variables for acidogenic fermentation were kitchen food‐waste content (10 and 25 wt %), hydraulic retention time (HRT: 1, 3 and 5 days), temperature (ambient: 18 ± 2 °C, and mesophilic: 35 ± 2 °C) and pH (varied from 5.2 to 6.7). The experimental results indicated that effluent VFA concentrations and VFA production rates were higher at ambient temperature than at mesophilic conditions. The net amount of VFA with 10 wt % food‐waste increased up to 920 mg dm^?3 with an increase of HRT, but contrasting results (a decrease of 2610 mg dm^?3) were found due to the conversion of VFA into biogas in the case of 25 wt % food‐waste, which increased significantly at HRT of 3–5 days. In terms of biogas composition (CO₂ and CH₄), the organic matter was converted into CO₂ through the oxidative pathway by facultative species at low temperature while mesophilic temperature and optimum pH (6.3–7.8) played a pivotal role in increasing rate of conversion of VFA into biogas by methanogenesis. Rates of VFA production and their conversion are dependent on the food‐waste content in the mixture. Yet, the higher concentration of food‐waste (25% compared with 10%) did not produce VFA proportionally due to the increased rate of conversion of VFA into gaseous products. The maximum VFA production rate (0.318 g VFA_produced g^?1 VS_fed day^?1) was achieved in the 10 wt % food‐waste at ambient temperature and at a 5‐day HRT. Copyright © 2005 Society of Chemical Industry     

储罐负压排泥技术

油田每年都有大量的储罐需要进行清罐排泥作业,通过对几种常用排泥方法的比较,认为负压排泥装置具有安装简单,操作方便,排泥效率高,排泥费用低等特点,文章详细介绍了储罐负压排泥装置的结构、原理以及安装与操作方法,并提出负压排泥装置使用的注意事项。     

活性污泥数学模型入流组分测定及应用

阐述了活性污泥1号模型人流组分的分析方法，并用这些方法测定了西安市城市污水水质。实验结果表明测定方法操作简单、准确可靠，能为利用模型进行污水处理厂的设计、模拟及管理提供入流组分分析依据，     

Physicochemical characteristics and leachability of scale and sludge from Bulalo geothermal system, Philippines

Scale and sludge from Bulalo geothermal field, Philippines, have been characterized by whole rock analysis, radioactivity counting, size analysis, light microscopy, scanning electron microscopy, and X-ray diffraction. Their leachability was assessed by regulatory leaching procedures and by sequential extraction. Both scale and sludge consisted mostly of oxides of Si, Al, and Fe with no radionuclides detected. The scale had 10% S content. Sulfides and silicates were important phases in both samples having size ranges from submicron to 2 mm. Geothermal soils at Bulalo have higher than normal soil levels of As, S, Cu, Cr, Zn, and Pb but regulatory leaching tests indicated that these elements are not released. However, the sequential extraction showed that As, Cu, and Zn were leachable under extreme conditions.     

SBR工艺污泥膨胀的纠正方法

在对国内外有关资料的研究基础上，介绍了几种应对SBR反应池内污泥膨胀的措施。着重叙述了氯化法和无机合成絮凝剂法的应用注意点及如何定量运用这两种方法，同时给出了相应的工程实例。     

二氧化氯处理油田回注水工艺

针对中原油田回注水中细菌易产生抗药性,难以控制的问题,提出了应用二氧化氯处理油田回注水工艺。经室内评价及现场试验,二氧化氯可杀死回注水中的细菌,控制微生物生长,同时该工艺可降低现有回注水污泥残渣产出量的50%,减少污泥对环境的污染,提高注水水质。     

热带城市垃圾典型组分的热解特性研究

对热带城市垃圾的几种典型组分进行了热解实验，得到了它们的失重曲线，通过对失重曲线进行分析，得到了这几种典型组分的热解规律，并通过建立热解动力学模型，求出了其中两种组分的活化能E和频率因子A。     

城市燃气管网设计若干问题的探讨

分析了哈依燃气管道工程在施工及管理过程中存在的问题，并就如何解决这些问题提出了建议。