化学强化生物除磷工艺及设计

本文介绍了一种新的化学强化生物除磷工艺及其设计实例，与Phostrip侧流除磷工艺相比，其工艺优势在于所有污泥均经释磷和厌氧选择处理，通过化学沉积释放的磷，从而消除了在污泥处置过程中产生的磷释放回到污水处理系统的问题；所有回流污泥经厌氧选择处理，含有较高浓度聚磷菌类微生物，从而具有较高的除磷效率。     

金属离子掺杂二氧化钛及水体光催化脱氮研究

采用溶胶-凝胶法制备了掺杂Ce^3＋、La^3＋、Ag^＋、Fe^3＋的TiO2光催化剂，以考察其薄膜和粉体形式对水中无机氮的光催化去除效果和活性．用所制备的催化剂对含氨氮-亚硝酸氮的混合液进行了光催化脱氮研究．本文利用UV—Vis吸收光谱、XRD和TEM对催化剂进行了表征．同时，对影响TiO2光催化效率的因素：如掺杂金属离子的种类、浓度、涂膜层数、反应液中有无Fe^2＋、不锈钢和玻璃载体、反应器的构型等进行了探讨，并对今后的研究进行展望．经过2h紫外光照射反应，实验最佳脱氮效果：金属离子掺杂TiO2薄膜型催化剂总氮去除率在30％左右，金属离子掺杂粉末型催化剂光催化最高总氮去除率可达41．7％．     

采用有机盐─石膏脱硫剂的烟气脱硫新工艺

介绍一种利用有机羧酸盐作为吸收剂、以熟石灰作还原剂的烟气脱硫系统，在日本投入生产运行，其脱硫效率达９０％以上。     

A_1-A_2-O-M工艺处理焦化废水的实验研究

采用厌氧-缺氧-好氧-复合(A1-A2-O-M)工艺处理焦化废水,考察了外加碳源和碱源对焦化废水COD和NH4+-N脱除效果的影响。试验结果表明:外加甲醇和碳酸氢钠对焦化废水的硝化和反硝化效果影响很小;不外加碳源和碱源时,焦化废水经处理后出水的COD和NH4+-N平均质量浓度分别为125.0mg/L和1.12mg/L,分别达到《污水综合排放标准》(GB8978-1996)中的二级标准和一级标准。     

The role ofAzolla in curbing ammonia volatilization from flooded rice systems

By the year 2020, an additional 300 million tons of rice are needed annually to meet the demands of a growing population. If our natural resource base is to be preserved, intensification strategies should rely on integrated nutrient management, making full use of biological nitrogen fixation. TheAzolla-Anabaena complex is amongst the most effective systems of fixing nitrogen. In this paper we present evidence from greenhouse studies on the potential ofAzolla to curb the volatilization of NH₃ following the application of urea to a mixedAzolla-rice culture, providing a new incentive for developing ways of integratingAzolla in intensive rice cultivation systems.The results of a series of short term greenhouse experiments show that a full cover ofAzolla can significantly reduce losses of applied urea-N from 45 and 50% to 20 and 13% for the 30 and 60 kg N ha^–1 treatments, respectively. About one-quarter of the applied N was tied up in theAzolla biomass. The applied N inhibitedAzolla growth as well as the amount of N fixed. Inoculation with smaller quantities ofAzolla allowing for more vigorousAzolla multiplication was equally effective in reducing NH₃ volatilization and doubled the amount of¹⁵N tied-up byAzolla. The reduction in NH₃ volatilization is largely related to the depression byAzolla of the floodwater pH, which in its absence may reach values between 9 and 10 as a result of algal activity.Early rice growth responded positively to urea as well as the large quantities of appliedAzolla and increased the yield potential of the crop. Smaller quantities ofAzolla alone were not effective in this regard. The conservation of fertilizer N byAzolla, particularly when it fully covered the water, was reflected in a synergistic effect on rice dry matter production, amounting to 9% at the 30 kg N rate and 16% at the 60 kg N rate. In all likelihood this interaction is attributable to the higher efficiency of the applied N. The benefits ofAzolla in conserving basal urea-N even in small quantities (200-500 kg fresh material ha^–1), outweighed competition for the applied N and may be as important as its BNF. The most promising integratedAzolla/rice management systems emerging from our studies should be given further attention under field conditions.     

Liquid-Phase Transport During Removal of Organic Binders in Injection-Molded Ceramics

A method has been developed for calculating hydraulic pressures induced by thermal expansion of liquid binders early in the removal cycle, when evaporative losses are negligible and fully saturated conditions prevail. Specific results were obtained for flat compacts containing a common wax binder, mixed with varying amounts of low-density polyethylne. In general, these results show how the risk of hydraulic fracture increases with heating rate and compact thickness. Although pressures are minimal when the binder consists entirely of wax, the continual addition of polyethylene eventually gives rise to unacceptable risk levels, even for relatively thin compacts. Binder removal at elevated temperatures is considered subsequently. In this case, vapor pressures eventually approach a critical level, thereby allowing mass removal by evaporation to overcome the effect of thermal expansion in maintaining full saturation. With the onset of void formation, the developing capillary pressure supersedes hydraulic pressure as the driving force in liquid transport. Besides representing capillary flow, the present formulation also accounts for thermal degradation of the binder during removal. The resulting system of equations was solved numerically for a variety of representative debinding conditions. Predictions for flat compact containing a balanced wax/polyethylene binder indicate that thermal degradation of the polyethylene can give rise to a marked improvement in debinding rates. It turns out, however, that this enhancement is far more effective in thinner compacts.     

黄磷的物理法脱砷新方法探索研究

针对我省黄磷精制现状,研究一种黄磷除砷新方法。利用高压静电场对工业黄磷进行处理,结果显示:在电场的作用下能分离除去砷,经三级处理脱砷率可达90%以上,黄磷回收率在99.9%以上。简要介绍了此处理方法的原理及工艺。     

氮化硅结合碳化硅管状制品的研制

简介了氮化硅结合碳化硅管状制品研制的必要性 ,确定了原材料及粒度配比 ,选择了合适的成型方法及添加剂 ,介绍了氮化烧成机理。研制出的制品其质量和使用性能接近同类进口产品 ,具有良好的市场前景和广泛的推广应用价值。     

Increasing urea-N efficiency for transplanted lowland rice by pneumatic injection: Yield and economics at the farm level

To increase the fertilizer-N efficiency in lowland rice (Oryza sativa L.) cultivation, new management practices are needed. Main cause of the present low efficiency is the low N recovery by plants, as a considerable part of the N applied is lost; deep placement techniques improve the recovery. A pneumatic injector, with which urea prills can be point-placed at a depth of 5–10 cm in paddy soils, was tested in 38 on-farm trials in 1989/90, mostly during the wet season. The experiments, located in Africa and Asia, focussed on differences in grain yield between conventional methods of broadcasting urea and injection by the pneumatic injector, at recommended N-rates. The study shows that the pneumatic injector is effective as a tool to improve the N fertilizer efficiency. The average yield increases per region, resulting from the use of the injector, ranged from about 250 to 1300 kg grain ha^–1. The value of the yield increase would allow most farmers to recover the costs of the injector within one season, even if labour was hired to carry out the injections. The average labour requirement of the injector was 40 hours ha^–1. In Indonesia, injection of prilled urea gave yields similar to those obtained with urea briquettes.     

硅通孔化学机械平坦化中铜去除的电化学与选择性研究

利用极化曲线测量法研究了甘氨酸和过氧化氢浓度及pH对硅通孔(TSV)化学机械平坦化(CMP)中铜腐蚀的影响。结果表明:甘氨酸对铜的腐蚀随其浓度增大而增强;随着过氧化氢浓度增大,铜腐蚀电位逐渐增大;在p H为10时铜的腐蚀效果最佳。CMP实验表明,在不同浓度的甘氨酸和过氧化氢之下,抛光速率可调,达1.9~5.8μm/min,铜表面粗糙度为5~29 nm,铜钽去除速率比为20~50。