纯化水系统中灭菌方法的应用及比较

分别采用二氧化氯溶液和臭氧水溶液对制药厂纯化水系统的贮罐和管道进行灭菌处理,比较灭菌效果和操作过程,最终认定臭氧水溶液灭菌方法在灭菌效率和水资源节约等方面优于二氧化氯溶液,适用于制药厂水系统管路、贮罐的灭菌处理.     

Ozonolysis of polybutadienes with different microstructure in solution

The reaction of ozone with 1,4‐cis‐polybutadiene and polybutadiene having the following linking of the butadiene units: 1,4‐cis (47%), 1,4‐trans (42%), 1,2 (11%) was investigated in CCl₄ solution. It was found out by means of IR‐spectroscopy and ¹H‐NMR spectroscopy that the basic ozonolysis products of both elastomers are ozonides and aldehydes. The aldehyde:ozonide ratio was 11 : 89 and 27 : 73 for E‐BR and BR, respectively. In addition, epoxide groups were detected, only in the case of BR, and their yield was about 10% of that of the aldehydes. On the basis of BR ozonolysis it was established that the ozonide yield from 1,4‐trans units is about 50%. By using the aldehyde yields, an evaluation was made of the efficiency of ozone degradation of the two polybutadienes, according to which the respective value of BR is considerably higher than that of E‐BR. A reaction mechanism is proposed, which explains the formation of the identified functional groups and the differences in the ozone degradation of the studied elastomers. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 427–433, 2007     

臭氧生物活性炭工艺处理饮用水时各阶段的特点

论述了臭氧生物活性炭工艺中的臭氧发生系统、臭氧尾气处理系统、臭氧预氧化及后氧化、生物活性炭滤池各阶段的应用现状及特点。指出：臭氧发生系统采用氧气为原料来提高臭氧浓度，臭氧质量分数可达6％左右；由于电加热分解臭氧尾气反应速度快，可在1．5～2s内完全分解，应是今后自来水厂臭氧尾气处理技术应用的重点；臭氧预氧化一般采用静态混合器或水射器单点投加，投加量为1～2mg／L，接触时间为1～4min；臭氧后氧化一般采用微孔曝气盘以微气泡的形式多点投加，水中臭氧余量控制在0．2～0．4mg／L，接触时间大于10min；生物活性炭滤池对苯类化合物和相对分子质量在500～1000范围内的腐殖质去除率达70％～86．7％。     

生物滤料滤池处理姚江微污染水源水

通过中试试验,考察了不同滤料介质的生物滤池对于姚江微污染水源水的处理效果。结果表明,双层生物滤料滤池能够有效地去除有机物、氨氮等污染物质,可以延长滤池反冲洗周期,并能在短时间内恢复到正常处理能力,适合于传统滤池的改造。采用颗粒活性炭-石英砂滤料滤池的综合处理效果优于同类型的颗粒活性炭-沸石滤料滤池,通过加入少量臭氧(0.8～1.0mg/L)可以提高生物滤池的去除效果。     

载锰氮化碳催化臭氧法降解水中草酸研究

草酸是废水中多种有机物氧化降解的中间产物,与臭氧反应速率很低,难以直接氧化去除。本研究通过热解法煅烧不同摩尔比例的三聚氰胺与醋酸锰(Ⅲ)二水合物,制备出不同负载量的载锰氮化碳催化剂,并研究了不同条件下载锰氮化碳催化臭氧法对草酸的降解效果,考察三聚氰胺与醋酸锰摩尔比、催化剂投加量、p H值、臭氧浓度等因素以及叔丁醇对草酸去除效果的影响。实验结果表明:相对于单独臭氧氧化而言,载锰氮化碳催化臭氧法可以极大的提高草酸的去除率,在投加0.15 g/L三聚氰胺与醋酸锰20∶1的催化剂后,草酸在60 min的TOC去除率可达到89.1%。叔丁醇加入对草酸的去除率影响较小,表明·OH在载锰氮化碳催化氧化草酸的过程中起作用但不是唯一因素。     

Effect of advanced chilling methods on lipid damage during sardine (Sardina pilchardus) storage

Slurry ice is a biphasic system consisting of small spherical ice crystals surrounded by seawater at subzero temperature. Its effect on lipid damage (hydrolysis and oxidation) was evaluated during the chilled storage of a fatty fish species, sardine (Sardina pilchardus). Slurry ice treatment was checked alone and in combination with ozone and compared to traditional flake icing during a 22‐day storage. Different lipid damage indices (free fatty acids, FFA; peroxide value, PV; thiobarbituric acid index, TBA‐i; fluorescent compounds, FR) were checked and compared to sensory assessment and nucleotide degradation (K value). According to lipid hydrolysis (FFA) and oxidation (PV and FR) developments, slurry ice showed an inhibitory effect (p <0.05) on lipid damage during storage, as well as an inhibition of nucleotide autolytic degradation. Ozonised slurry ice did not provide differences (p >0.05) from slurry ice alone when considering lipid hydrolysis, nucleotide degradation and some lipid oxidation indices (PV and FR), although a higher (p <0.05) TBA‐i was observed at day 22 of storage when compared to flake ice and slurry ice treatments. However, a lower (p <0.05) fluorescence development was observed for fish treated under ozonised slurry ice when compared to traditionally iced fish. Sensory assessment showed a higher shelf life for fish samples treated under ozonised slurry ice than for their counterparts under slurry ice (15 d versus 12 d), while flake icing led to a far shorter shelf life (5 d). According to sensory and biochemical (lipid matter and nucleotide) analysis, slurry ice has proved to be a promising technology for damage inhibition and quality retention in a fatty fish species such as sardine. Ozonised slurry ice was also shown to be useful, since a longer shelf life was obtained in the present experiment and a pro‐oxidant effect of ozone on sardine lipids was not proved.     

Kinetics of hydrogen peroxide bleaching of ALCELL® derived pulp

In this study, a kinetic model of the final bleaching stage with hydrogen peroxide in a totally chlorine free (TCF) bleaching sequence for ALCELL® processed pulp was developed. The model was based on the rate of chromophore destruction characterized by the decrease in the light absorption coefficient of bleached pulp at 457 nm, C_K. Based on the fact that the chromophore destruction proceeds rapidly in an initial phase followed by a much slower reaction during which a “floor-level” chromophore concentration is approached asymptotically, we propose that the hydrogen peroxide stage of the ALCELL® derived pulp in the studied TCF sequence consists of two distinct phases. The initial phase is a very fast reaction. The rate equation of the second phase was determined as: which is valid in a pH range of 10.5 to 11.5 and a temperature range of 60 to 92.5°C.     

Advancements in the design and validation of an air pollution integrated assessment model for Spain

This paper describes the design and application of the Atmospheric Evaluation and Research Integrated model for Spain (AERIS). Currently, AERIS can provide concentration profiles of NO₂, O₃, SO₂, NH₃, PM, as a response to emission variations of relevant sectors in Spain. Results are calculated using transfer matrices based on an air quality modelling system (AQMS) composed by the WRF (meteorology), SMOKE (emissions) and CMAQ (atmospheric-chemical processes) models. The AERIS outputs were statistically tested against the conventional AQMS and observations, revealing a good agreement in both cases. At the moment, integrated assessment in AERIS focuses only on the link between emissions and concentrations. The quantification of deposition, impacts (health, ecosystems) and costs will be introduced in the future. In conclusion, the main asset of AERIS is its accuracy in predicting air quality outcomes for different scenarios through a simple yet robust modelling framework, avoiding complex programming and long computing times.     

臭氧氧化法除地表水有机物试验研究

本文阐述臭氧化法除地表水有机物的重要意义，实验结果表明：臭氧氧化有机物的总氧化速率受活化控制，影响氧化率的最高显著因素是温度，其次是ｐＨ，接触时间等，臭氧很容易氧化腐植酸，在３０℃，ｐＨ９．０～１０．０，７ｍｉｎ内，ＣＯＤ去除率可达６０％以上，对邯郸热电厂生产处理也取得良好效果，３５℃，ｐＨ７．４～７．６，１０ｍｉｎ内，ＣＯＤ去除率可达６７％，可望将臭氧化水处理工艺应用于电厂水处理。     

水中高压脉冲放电机理与效能

水中高压脉冲放电是一种具有潜力的新型水处理技术，这是由于高压脉冲放电具有许多独特的性质。放电过程中会产生许多有利于去除污染物的复杂的物理以及化学反应。作者介绍了一些基本原理，同时综述了近来国内外高压脉冲放电水处理技术的研究发展状况，高压脉冲放电过程的催化强化去除污染物的机理以及灭菌去除污染物的效能。