Extraction of Anthocyanin Pigments from Purple Sunflower Hulls

The anthocyanin pigments in hulls of purple sunflower seeds were extracted using three solvent systems, 50:1:49 ethanol-acetic acid-water (EAW), 0.01M acetic acid (AAc), or water containing SO₂. Solvent, extraction time, size of ground hulls, pH of extracting solvent, hulls/solvent ratio, and concentration of SO₂ in water, were investigated. All were significant factors affecting yield of extracted anthocyanins. EAW and SO₂ were more effective extractants than AAc. Optimum conditions from response surface optimization for the extraction with sulphurous water were: SO₂ at 200 mg/L, hull size 20 mesh, extraction time 5 min at 22°C, and solvent/hulls ratio = 20.     

强度调制／直接检测（IM／DD）光纤通信系统色散限制的研究

通过引入归一化脉宽Ｐ和相对脉冲展宽因子ｑ，提出了一个适用于ＩＭ／ＤＤ系统中各种眼图恶化量ｘ和归一化脉宽Ｐ的色散限制改进公式。通过与其它理论的比较、计算机仿真和对实验数据的分析，验证了该公式的正确性，并给出了其它结果的限制条件。研究表明：当眼图恶化量ｘ为１ｄＢ左右时，对２．５Ｇｂ／；外调制信号（α＝０）而言，非色散位移光纤ＩＭ／ＤＤ系统的色散因子γ约等于０．７９，所对应的系统再生中继距离约为９００余公里。     

The mechanics of compressive kinking in unidirectional fiber reinforced ductile matrix composites

Three distinct stages of kink band formation and propagation exist in ductile matrix composites subjected to compressive loading. These stages are called incipient kinking, transient kinking and kink band broadening. Each stage involves a different deformation mode. The mechanics governing each stage are discussed. Incipient kinking, where the peak load is attained, and kink band broadening, where the load attains a steady-state, are important in structural design. Two design philosophies are presented. References to pertinent literature are made throughout.     

G.652光纤上的2.5Gbit／s色散受限系统

本文根据色散受限中继段长度的计算，对实际工程中１５５０ｎｍ波长２．５Ｇｂｉｔ／ｓ系统进行计算比较得出啁啾声引起的色散不容忽视，它使２．５Ｇｂｉｔ／ｓ成为色散受限系统。对１３１０ｎｍ波长６２２Ｍｂｉｔ／ｓ系统，当使用多纵模激光器时，往往也会成为色散受限系统。     

钢纤维混凝土在南钢大道工程中的应用

钢纤维混凝土是一种性能优良的新型复合材料，与普通混凝土相比，其抗拉、抗弯、抗裂及耐磨、耐冲击、耐疲劳等性能都有显著提高，它不仅可使路面厚度减薄，工程缝间距加大，改善路面的使用性能，延长路面使用寿命，而且还可节省工程造价，缩短施工工期。文中结合南钢大道路面工程实际，主要介绍了钢纤维混凝土的施工及质量控制要点。     

G.652光纤长途传输系统的色散补偿

针对当前国内长途传输光缆系统在扩容过程中，因光信号色散而影响传输质量的现象，结合实际工程建设，分析了光信号色散的危害及其成因，并提出了相应的解决办法及建议。     

硫铁矿沸腾炉内蒸发管组防磨技术的探讨

为减少磨损,沸腾炉内蒸发管采用加焊半圆形钢板防磨.探讨了沸腾炉内蒸发管加焊半圆形钢板的防磨机理.实际使用情况表明,加焊半圆形钢板防磨大大降低了维修费用,显著提高了防磨效果.     

Advanced modulation formats for more robust optical transmission systems

Interest in advanced modulation formats for optical communication systems has so far experienced two major waves. The first one was motivated by the potential to enhance receiver sensitivity of thermal noise-limited systems using coherent detection in combination with phase shift keying. It ended with the advent of optical amplification, enabling high sensitivities together with polarization insensitive, simple and stable direct detection. The second wave is still rolling, fueled by the potential of advanced modulation formats to increase robustness of optical transmission systems against signal distortions. Due to performance limitations given by direct detection and nonlinear effects in the transmission fiber, it is not decided yet, whether there will be widespread application in carrier networks.     

光波分复用技术及其应用

分析了波分复用系统的组成原理和几种分类方式,最后给出了一些基本应用形式。     

Mechanical and microstructure studies on the modification of CA film by blending with PS

DriedMusa paradiciaca (banana) stem and veins of the leaves, which were hitherto discarded as a waste, were collected and used as starting material for the preparation of cellulose and cellulose acetate. This cellulose acetate was mixed with polystyrene to form blend of cellulose acetate-polystyrene in order to provide enhanced stability and extended utility to the end products. The films of these composites or their individual partners were made separately and studied for their mechanical properties, chemical modification and morphological changes. We report here that banana stem is good source of cellulose and that cellulose completely undergoes modification upon esterification.