安徽省长江干堤的几种加固措施

安徽省境内765km的长江干堤，由于均是在原来旧堤的基础上经逐年加高培厚的，修筑时均未按设计要求施工，致使堤身密实度不够，新老堤土之间结合不牢，在汛期高水位时易产生渗漏。20世纪70年代以来，安徽省高度重视对长江干堤渗漏隐患的处理，经过长期的实践，逐渐摸索出一套行之有效的除险加固方法，如锥探灌浆、灭杀白蚁、冲抓套吉、垂直铺塑防渗、粘土铺盖及压渗盖重等处理措施。使长江干堤的渗漏隐患得以基本消除，其具体作法可供类似工程借鉴。     

A geometry-based error estimation for cross-ratios

For choosing specific cross-ratios as 2D projective coordinates in various computer vision applications, a reasonable error analysis model is usually required. This investigation adopts the assumption of normal distribution for positioning errors of point features in an image to formulate the error variances of cross-ratios. Based on a geometry-based error analysis, a straightforward way of identifying the cross-ratios with minimum error variances is proposed. Simulation results show that the proposed approach, as well as a further simplified alternative, yield much better estimations of minimum error variances in terms of accuracy, cost, and stability compared with some other methods, e.g., the one based on the rule given by Georis et al. (IEEE Trans. Pattern Anal. Mach. Intell. 20 (4) (1998) 366). Some causes of the performance differences in the estimations are explained using a special configuration of point features.     

西北江三角洲来水来沙的非线性分形特征

根据西、北江干流高要、石角及西北江三角洲网河区顶点马口、三水四个水文站的流量和含沙量资料 ,应用非线性分形原理的R S方法 ,计算西北江干流及西北江网河区顶点四个水文站的流量、含沙量的赫斯特数H和分形维数D ;探讨西、北江干流来水来沙的分形特征及西北江三角洲的分水分沙规律。结果表明 ,流量的分维数略大于含沙量的分维数 ,三水站流量及含沙量的分维数与其上游的石角站流量、含沙量的分维数相差较大 ,与思贤的分水分沙造成西北江的水沙交换有关     

Oxidation of porous nanocrystalline titanium nitride. II. Scale structure and composition

We have used x-ray phase analysis to study the composition of the products of reaction between oxygen and nanocrystalline powders with particle sizes 15, 40, 55, and 80 nm, and also specimens pressed (and sintered) from them. The powders were oxidized in air at 100°C (400 h) to 500°C (5 min), while the sintered specimens were oxidized at 600–900°C for 15, 120, and 240 min. In all cases, in the initial oxidation step the oxynitride Ti(O_xN_y) is formed, which over time is oxidized to TiO, Ti₂O₃, Ti₃O₅, TiO₂ (anatase) and TiO₂ (rutile). In the range 600–800°C, formation of a continuous oxide layer and conversion of anatase to rutile slows down diffusion of oxygen in the scale. We have established that at 900°C, the growth rate of the scale thickness increases and so the reflections from the oxynitride are barely noticeable on the diffraction patterns taken from the surface of the oxidized specimen. In these diffraction patterns, along with strong reflections from the rutile, we also observed weak reflections from lower oxides and anatase, which may be due to reaction between oxygen and the titanium ions diffused to the scale surface. We have concluded that at T > 850°C, the mechanism for oxidation of TiN changes. This is due to superposition of counterdiffusion of titanium ions on the diffusion of oxygen. __________ Translated from Poroshkovaya Metallurgiya, Nos. 3–4(448), pp. 72–78, March–April, 2006.     

海洋石油平台水下夹桩器本体结构分析

水下夹桩器是一种广泛应用于海洋石油平台建设的液压夹具。水下夹桩器本体焊接在导管架上，支撑夹桩器液压缸。在水下夹桩器本体设计中，采用有限元法完成了对本体强度和刚度的结构分析；建立了有限元分析模型，用ANSYS软件进行结构分析，得到了分析结果，并将该结果与理论计算结果进行了比较，验证了有限元分析技术的有效性。设计结果满足工程要求，为改进和优化结构提供了理论依据，节省了分析计算时间。     

打括隧道监控量测结果的一元非线性回归分析

针对黄织铁路工程打括隧道923延米V级围岩土质地段,根据施工中的地质动态对打括隧道初期支护中监控量测结果进行一元非性线回归分析,以制定科学施工方案和确定合理支护参数,保证工程质量和作业的安全性。     

A limit analysis of nonlinear elastic lateral displacements of thin-walled reinforced and prestressed beams

An incremental iterative process based on direct energy minimization is presented for a limit analysis of nonlinear elastic lateral displacements and twists of reinforced and prestressed beams. Problems encountered with the constitutive relations are discussed and two possible material models are presented.     

Sensitivity analysis of the scattering parameters of microwave filters using the adjoint network method

A novel approach is presented to calculate the sensitivities of the scattering parameters of microwave filters obtained with the full‐wave mode‐matching (MM) technique. Using only the MM simulation of the original network, the sensitivities of the scattering parameters with respect to all designable parameters are obtained. The adjoint network method (ANM) is applied to the generalized scattering matrices of the different filter components. This guarantees good accuracy of the calculated sensitivities. The implementation details are discussed for N‐resonator ridge waveguide filters. Excellent agreement is obtained between the sensitivities calculated using ANM and those obtained using the expensive central differences. © 2006 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006.     

Minimum spanning trees made easier via multi-objective optimization

Many real-world problems are multi-objective optimization problems and evolutionary algorithms are quite successful on such problems. Since the task is to compute or approximate the Pareto front, multi-objective optimization problems are considered as more difficult than single-objective problems. One should not forget that the fitness vector with respect to more than one objective contains more information that in principle can direct the search of evolutionary algorithms. Therefore, it is possible that a single-objective problem can be solved more efficiently via a generalized multi-objective model of the problem. That this is indeed the case is proved by investigating the computation of minimum spanning trees.This work was supported by the Deutsche Forschungsgemeinschaft (DFG) as part of the Collaborative Research Center Computational Intelligence (SFB 531) and by the German-Israeli Foundation (GIF) in the project Robustness Aspects of Algorithms.     

单桩腿有限元分析

为保证桩腿在冬季冰区海域的安全使用,对桩腿结构进行冰载荷作用下的强度分析。应用ANSYS软件建立桩腿、地基、冰相互作用的仿真计算模型,实现桩腿的力学分析。对桩腿进行了强度校核,计算出冰载荷作用下桩腿的变形及其应力状态。计算结果表明,桩腿在此冰载荷作用下强度满足安全要求。