高温预析出对Al-Zn-Mg系铝合金时效硬化和应力腐蚀的影响

研究了高温固溶后降温处理工艺对中强可使预析出LC52和7039铝合金的组织、时效硬化和应力腐蚀的影响。金相观察发现,高温预析出可优先在晶界处产生,并提高随后时效状态下晶界析出相的不连续分布程度,温度降低到一定程度晶内和晶界产生大量析出。合金拉伸性能和应力腐蚀结果表明,预析出在保持强度和塑性的同时,可提高抗应力腐蚀性能。而预析出温度降低,合金强度呈下降趋势。     

Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

黄河下游河道萎缩致灾机理探讨

本文基于水力学原理，结合实体模型试验及原型实测资料分析，探讨了黄河下游河道萎缩的概念、致灾效应和致灾机理。分析表明，河道萎缩是造床过程中河道排洪输沙功能衰退的一种演变现象，其致灾效应是使洪水涨率增大，同流量下洪水水位不断抬升。致灾的现象主要表现在畸型河势增加、工程险情增多、直接造成工程损失及滩区经济损失等。试验研究揭示，主河槽宽度缩窄造成洪水水位涨幅增大，河底平均高程抬升和过水断面面积减小造成洪水水位起涨的基准面抬升是河道萎缩致灾的主要原因。河道萎缩致灾效应的大小与萎缩模式有关，其中以“集中淤槽”模式所形成的致灾效应尤为明显。     

Response of Vietnam coastal upwelling to the 1997-1998 ENSO event observed by multisensor data

In this paper, we examine the behavior of the Vietnam coastal upwelling during the 1997-1998 El Niño-Southern Oscillation (ENSO) event. The baseline is 4 years of National Oceanic and Atmospheric Administration (NOAA) satellite Advanced Very High Resolution Radiometer (AVHRR) sea surface temperature (SST) data taken from 1997 to 2000. Comparison of upwelling images to simultaneous ERS-2 (European Remote Sensing Satellite) wind fields indicates that the summer monsoon winds constitute a major generation forcing. During the 1997 El Niño, the monsoon winds enhanced the upwelling and induced the upwelling center to move southward. During the 1998 La Niña, the monsoon winds weakened the upwelling. In contrast with the tropical Pacific, in the study area, La Niña implies a warm event and El Niño a cold event. We use empirical orthogonal function (EOF) methods to analyze the spatial and temporal variance of the upwelling. The three principal modes account for 37%, 15%, and 8% of the total variance, respectively. The first EOF modes reveal that the SST variance in the north and south subregions underwent a positive-negative sign switch in summer 1997. The second EOF modes represent the monthly evolution in normal years. The third modes seem to be sensitive to the 1998 La Niña event. Simultaneous TOPEX/POSEIDON and ERS-2 altimeter data provide further evidence for our analysis. Comparison with California coastal upwelling and mid-Atlantic Bight (MAB) coastal upwelling indicates that the Vietnam coastal upwelling is the most intensive one.     

In‐Situ Observation of the Formation of MnS during Solidification of High Sulphur Steels

A Confocal Scanning Laser Microscope equipped with a gold image furnace was used to directly observe the precipitation of MnS during solidification of high sulphur steels under isothermal conditions in the temperature region 1440 to 1480°C on the free surface of the steel melt. For the case of Al‐killed steels, below 1480°C MnS particles were found to precipitate with Fe forming simultaneously around them. This MnS containing structure continued to grow rapidly (264 μm/s) as a surface film. The film gradually changed, as the level of S in the melt decreased, into a eutectic structure (with lamella spacing of 2 μm) as predicted by thermodynamics. In Si‐ killed steels there was significantly lower tendency to form MnS both in terms of time until precipitation occurred and growth rate.     

种分Δαk与种分首槽αk的关系

针对烧结法和拜尔法种分槽的 Δαk 变化进行了概述 ,阐述了种分 Δαk 与种分首槽 αk 的关系。     

Plasma Sprayed Hydroxyapatite Coatings with Nano-hydroxyapatite Prepared by Ultrasonic Precipitation Process

Nano-particle hydroxyapatite （ HA ） was prepared with a novel ultrasonic precipitation process and the as-prepared nanopowder was used to produce hydroxyapatite （ HA ） coatings on titanium substrate via plasma spraying. The phase and the microstructare of the coating were characterized by X- ray diffraction （XRD） and scanning electron microscopy （SEM）. Results showed that spherical particles could be prepared by ultrasonic precipitation process; and a corresponding dense HA coating with molten surface and low-porosity cross-section structure was acquired. During the plasma spraying process, new phases of Ca3 （ PO4 ）2 and Ca2 P2O7 were generated. After heat-treating at 800℃ for 1 h, the contents of Ca3 （ PO4 ）2 and Ca2 P2O7 decreased while HA content increased. Tensile adhesion tests showed that the plasma sprayed coating prepared with the spherical nanoparticles exhibited high tensile bond strength.     

一种探测二维电磁目标的新方法

电磁目标的探测对通信而言有着十分重要的意义。本文描述一种收敛迅速、结果准确、抗强随机噪声的探测二维电磁目标的新方法。首先从体等效原理出发得到一个积分方程组，此方程组可求解散射问题。随后，对此方程组求变分，变形后得到散射场变化与介电参数变化之间关系的矩阵方程，即反演方程。文中列举了几个例子，通过数值实验结果证明本法收敛速度快、反演精度高、适应复杂目标的能力强，能抗强随机噪声干扰     

弹丸外弹道优化设计初始点的选取

在弹丸外弹道优化设计中,需对优化设计变量赋于初始值.初始值选取得如何,对整个优化计算所耗机时、迭代点收敛到哪个极值点上等等,影响很大.该文对初始值的选取原则、选取方法等作了讨论,所得结果也可作为对弹丸主要结构参数选优的预估.