Al2O3—TiB2陶瓷刀具材料的高温氧化及其对刀具耐磨性能的影响

研究了Ａｌ２Ｏ３－ＴｉＢ２陶瓷刀具材料在１０００℃下的氧化行为，用ＸＲＤ、ＳＥＭ分析了氧化后的相组成及显微结构。结果表明：Ａｌ２Ｏ３－ＴｉＢ２陶瓷材料在１０００℃空气中氧化增重符合抛物线规律；随ＴｉＢ２含量的增加，该材料的抗氧化能力下降。     

Development of temperature compensated high elongation resistance strain gauges for use up to 250°C

The paper describes the development and evaluation of temperature compensated high elongation resistance strain gauges for use from room temperature to 250°C. These gauges could be temperature-compensated on steels with coefficient of thermal expansion α = 11 ppm/°C. Thermal output within 250°C was about 1 μm/m/°C and maximum standard deviation of 5 gauges was 34 μm/m. Strain limit was > 4% at room temperature and at 250°C. Gauge factors of different strain ranges at R.T. and at 250°C are tabulated. Some applications are stated.     

Distribution and Fate of Escherichia coli in Lake Michigan Following Contamination with Urban Stormwater and Combined Sewer Overflows

Escherichia coli distribution and persistence in nearshore Lake Michigan were assessed following heavy rains and sanitary sewer overflow (SSO) and combined sewer overflow (CSO) events over a 5-year period, including an 18-day period following 25.4 cm of rainfall in which intensive studies were conducted following multiple CSO and SSO events. E. coli levels in the Milwaukee estuary and harbor following SSO and CSO events ranged from 10⁴ to nearly 10⁵ CFU/100 mL, which were significantly higher (p ≤ 0.05) than levels following rainfall alone. Sites outside of the breakwall but within the contamination plume (e.g., within 2 km of the harbor) were an order of magnitude lower. Locations 2–5 km from the harbor ranged from below detection limits, of < 1 to 5 CFU/100 mL. E. coli levels corrected for dilution based on specific conductivity measurements were lower than what would be expected for loss due to dilution alone, suggesting a combination of die-off and dilution, were responsible for the rapid disappearance of these organisms outside of the harbor. E. coli and fecal coliforms measured concurrently demonstrated that fecal coliforms could be recovered longer than E. coli in the open waters of the lake. E. coli isolated directly from sewage treatment plant influent were found to have a marked increase in antibiotic resistance traits for ten antibiotics commonly used in the human population compared with isolates from two animal sources of fecal pollution. However, E. coli obtained from sewage impacted water (n = 2,513) and from stormwater impacted water (n = 1,465) collected the previous year when there were no sewage overflows, were found to have no significant difference (p < 0.05) in the frequency of resistance when comparing the two conditions. E. coli survival characteristics and population dynamics are most likely influenced by multiple factors in complex systems such as the watershed/estuarine/lake environments of the Great Lakes.     

S—135钢板热轧工艺研究

S—135钢板是水电站用高强耐磨不锈钢板,既要求强度高、韧性好,又要求耐磨、耐蚀性强,生产难度较大。除我厂外,目前国内尚无其它厂家能够生产这种钢板。该钢板在加热轧制,冷却过程中要解决很多技术难点。我们通过采用特殊的控制轧制和控制冷却工艺,很好地解决了诸多技术难点,使S—135钢板的开发研制取得了成功。为电站用高强度耐磨不锈钢生产提供了宝贵的经验,也为控制轧制及控制冷却技术在中板生产行业的应用起到了积极的推动作用。     

Effect of Microstructure on the Accelerated Creep of 20CrMoV12‐1 and P 91 Steels

In the initial part the change of microstructure for steel X20 CrMoV 121 is discussed in terms of the distribution of carbide precipitates and its effects on accelerated creep resistance and hardness are presented. In the following, experimental results of microstructure and accelerated creep resistance are presented for the steels X20CrMoV 121 and P91 annealed for up to 8760 hours at 650°C and 750°C before the testing. A similar evolution of the distribution of carbide particles of a size above 102 nm is found for both steels, while the accelerated creep resistance is diminished much stronger for the steel X20CrMoV 121. This difference is due to a greater stability of NbC than that of VC precipitates, both related to the evolution of the chemical composition of complex chromium, molybdenum and iron carbide particles.     

Measuring the load eccentricity in helical compression springs

An experimental device able to detect the load eccentricity in helical compression springs is described. The theory underlying the resolution of measured bending strains of the apparatus into effective load eccentricity is discussed. Laboratory results are offered for heavy duty springs and compared to theoretical estimates retrieved from the literature.     

一个高电阻值测量电路

介绍一种新的高阻测试方法，可满足对高达１×１０＾１６Ω的测试要求。测试结果显示，对于１×１０＾１３Ω重复误差优于±２％。高阻测试电路通过接口与６８０９微机配套使用，操作简便，读数直观，便于长时间重复测量。     

避雷器接地电阻的测量与预测方法

介绍了避雷器三极法测量接地电阻的接线、测量原理及测量电压的选取,根据测得的历史数据建立了基于回归分析的接地电阻变化趋势预测模型,并通过标准离差检验证明了该预测模型可用于实际接地电阻的预测。实践表明,该测量与预测方法切实可行,能在一定程度上避免因接地电阻超标而引发的雷击事故。     

液压支架工作状态模糊识别系统研究

针对目前综采工作面液压支架压力监测系统只能监测综采工作面压力,不能对液压支架工作状态进行识别的问题,设计了一种液压支架工作状态模糊识别系统。该系统可对现有的综采工作面液压支架压力监测系统监测到的压力数据进行模糊识别,根据模糊识别输出值即可判断液压支架的5种工作状态,即降架、移架、升架、增阻、卸压保持;当液压支架处于增阻工作状态且增阻时间过长时,该系统可及时通知液压支架操作工增大液压支架压力,辅助实现顶煤破碎。测试结果验证了该系统的可行性。