聚合物降解产物伤害与糖甙键特异酶破胶技术

综述了钻井，完井，尤其是水力压裂作业中产生的多糖类聚合物伤害和应用糖甙键特异酶破胶，解除多糖类聚合物伤害的技术。第一节报道了聚合物降解产物造成的伤害，指出冻胶破胶液粘度低并不代表压裂液已从充填裂缝中充分返排，氧化破胶剂和普通酶破胶剂不能使多糖类聚合物充分降解，产生的大分子量，水不溶的降解产物可对地层造成伤害，消除伤害的办法是采用对糖甙键有特异性的各种水解酶作压裂液破胶剂或伤害地层处理剂。第二节报道了各种聚合物（纤维素，瓜尔胶，淀粉）糖甙键特异酶降解聚合物的机理。第三节报道了糖甙键特异酶（主要针对瓜尔胶）的应用性能测试及结果，包括岩心流动实验，含糖量和分子量测定，传导性测试。第四节介绍了糖甙键特异酶消除聚合物伤害和用作压裂液破胶剂的现场应用，包括选井原则，实施工艺要点及3个典型井例。     

内循环好氧三相流化床处理造纸中段废水

本实验采用内循环好氧三相流化床处造纸中段废水，经过一段时间的驯化，获得了稳定的出水。CDO去除经保持在65％以上，系统对进水污染负荷的变化具有较大的承受能力。出水Cl^-的浓度有所增加，说明驯化后的微生物可能对有抽氯化物具有一定的降解作用。水气比在1／120至1／140之间可获得最好的COD去除效果。后进行絮凝处理后，出水COD降为60－80mg/L,BODo 50-60/L，色度为100－150CU，挥发性酚的质量浓度小于0．0265mg／L。     

飞秒激光烧蚀研究进展

介绍飞秒激光烧蚀材料的机理论模型，阐述飞秒激光烧蚀的特性，揭示飞秒激光烧蚀的广泛应用前景。     

发电厂粉煤灰充填矿区塌陷坑方案可行性分析

介绍了煤矿塌陷坑的治理途径和复垦的意义。     

Quantitative demonstration and cost considerations of a software fault removal methodology

This paper presents a demonstration of a methodology for fault removal during software development. The methodology encompasses the entire development history, from system and software requirements generation to system test. Thus it considers not only the faults during software testing after formal configuration controls have been invoked, but also the faults discovered prior to that phase: during system and software requirements generation, preliminary design, detailed design and code and unit testing. The agents for fault discovery used in verification and validation are called activities, techniques and tools (AT & Ts) in this paper, each having a certain maximum potential or capability for fault discovery. The AT & Ts considered include the usual specification review activities, and also certain tools not normally applied in ‘standard’ software development, such as automated requirements aids. Application of the methodology yields numbers of residual faults as of each phase of development, including those remaining to be discovered during operations and maintenance. Some previous experience and data on residual faults correspond to these results, indicating that the methodology and choice of parameters are reasonable. The methodology also allows one to calculate a relative loss due to delay in fault discovery, which, as is well known, rises rapidly when faults are not discovered during the phase in which they are generated.     

高炉煤气脉冲布袋除尘技术的应用

介绍了韶钢6号高炉脉冲布袋除尘技术的工艺流程、主要设备、控制措施及节能效果。     

Modelling the effects of dam removal on migratory walleye (Sander vitreus) early life‐history stages

Many dams in the USA have outlived their intended purpose and an increasing number are being considered for removal. Yet, quantitative studies of the potential physical, biological and ecological responses are needed to assess dam removal decisions. In this paper, the responses of migratory walleye (Sander vitreus) to increased spawning habitat availability as a result of dam removal was studied by comparing scenarios with and without a high‐head dam in the Sandusky River (Ohio), a major tributary to Lake Erie. A conceptual, ecological model was proposed to define the relationship between hydrodynamics and walleye spawning, egg hatching, larval drift and survival. A mathematical, ecological model of the early life‐history stages was then developed and coupled with time series of depth and velocity predictions over the spawning grounds from a 1‐D hydrodynamic model. Model simulations were run for 1984–1993 for both the with‐ and without‐dam scenarios to assess the potential benefit of dam removal. The simulation results demonstrated that velocity, depth and water temperature are major factors influencing adult walleye spawning success. Without the dam, 10 times the amount of spawning habitat would be available for walleye to spawn. This increase in spawning habitat area resulted in up to five times the total egg deposition and seven times the larval output to the nursing grounds, based on the assumption that 5% of the walleye population of Lake Erie migrated up the Sandusky River to spawn. We concluded that the spawning habitat in the current condition (with the dam) is limiting and additional spawning habitat upstream could significantly increase the number of larval walleye drifting to Lake Erie. The model sensitivity analysis showed that the number of walleye migrating up the river in spring is the dominant factor for larval recruitment to the lake. Copyright © 2006 John Wiley & Sons, Ltd.     

The relationship between photo-catalytic performance and optical property over Si-incorporated TiO2

This study focuses on the relationship between photo-catalytic performance and optical property over Si-incorporated TiO₂. The Si-incorporated TiO₂ particles exhibited a pure structure of anatase having a particle size of less than 20 nm and surface area of more than 190 m²/g. The absorbance did not shift to a higher wavelength in spite of the incorporation of the Si ions, but the intensity of the photoluminescence (PL) curve was the smallest in the case of the 2.0 mol% Si-TiO₂, which was related to the recombination between the excited electrons and holes. Based on these results, the photodecomposition of methyl orange in the liquid reaction was enhanced over the 2.0 mol% Si-incorporated TiO₂ compared with that over pure TiO₂: Methyl orange at 10.0 ppm was completely decomposed after 100 min when 1.0 g of the 2.0 mol% Si-incorporated TiO₂ was used.     

Removal of As(V) Ions from Solution by Akaganeite bgr-FeO(OH) Nanocrystals

The original method is developed for producing the new inorganic sorption material of akaganeite bgr-FeO(OH). The material in question is characterized relative to arsenic contained in aqua. The possibility is established for removing arsenate ions from water by contemporary physicochemical methods.     

Method to Characterize the Air Flow and Water Removal Characteristics During Vacuum Dewatering. Part II—Analysis and Characterization

This is part II of a study reported earlier on a method to characterize the air flow and water removal characteristics during vacuum dewatering. This article presents experimental data and analysis of results from the use of a cyclically actuated vacuum dewatering device for removing moisture from wetted porous materials such as paper with the intermittent application of vacuum and accompanying air flow though the material. Results presented include sheet moisture content as a function of residence time and hence water removal rate under a variety of process conditions. Also, experimental results on air flow through the wet porous structure and hence the role and importance of air flow during vacuum dewatering are presented. Vacuum dewatering process conditions include exit solids content between 11 and 20% solid under applied vacuum conditions of 13.5 to 67.7 kPa (4 to 20 in. Hg). Regression analysis indicated that the exit sheet moisture content exhibited a nonlinear relationship with residence time with exit solids reaching a plateau after a certain residence time. Final moisture content correlated linearly with the average overall flow rate of air through the paper sample and the basis weight of the material.