纳米棒状氧化铁红的制备及表征

以尿素为沉淀剂,采用缓慢滴加方式,用均匀沉淀法制备了纳米棒状氧化铁红。考察了Fe^2＋浓度、反应时间、反应温度、尿素与Fe^2＋物质的量比等因素对产品粒径、形貌及收率的影响,并用TG,XRD,IR,UV-VIS,TEM等对样品进行了表征。确定了制备纳米棒状氧化铁红的最佳工艺条件：Fe^2＋浓度为0.50 mol/L,反应时间为180 min,反应温度为80℃,尿素与Fe^2＋物质的量比为20∶1,在此条件下制得前驱体,将前驱体在350℃下煅烧2 h,即可得到纳米棒状氧化铁红。样品的XRD,TEM表征结果为六方晶系的纳米棒状α-Fe2O3,其长轴约为300-500 nm,短轴约为20-40 nm,产品收率为75.90%,颜色为鲜红色,含质量分数5%样品的清漆对紫外线具有很好的吸收性能,而对可见光具有良好的透明性,其透光率在85%以上,可作为透明氧化铁红颜料使用。     

稀土掺杂红色长余辉发光材料的研究进展

介绍了稀土掺杂红色长余辉发光材料的研究进展,总结了硫化物、硫氧化物、钛酸盐等基质体系的红色长余辉发光机制。及传统的高温固相法以及溶胶-凝胶法、燃烧法等稀土红色长余辉材料的制备技术,提出了对红色长余辉材料今后发展的看法。     

丙烯腈悬浮床催化水合制备丙烯酰胺的催化剂研究

考察了丙烯腈悬浮床水合制备丙烯酰胺的各种催化剂性能，研究了雷尼铜（Ｒａｎｅｙ Ｃｕ）催化剂的三种影响因素：铜铝成分的比例、冷却成型方式和添加组分的影响及催化剂的再生性能。结果表明：喷雾法制备的雷尼铜［Ａｌ∶Ｃｕ＝５２∶４８（质量比）］催化剂比普通雷尼铜催化剂活性高１０％，强度高２４％，并具有良好的再生性能，适于作为悬浮床催化剂     

WALL AND PARTICLE-SHAPE EFFECTS ON HEAT TRANSFER IN PACKED BEDS

The effective radial thermal conductivity and apparent heat transfer coefficient for a packed bed were experimentally determined for beds of spheres, full cylinders and hollow cylinders, for flow rates giving particle Reynolds numbers in the range 100-1000, and for tube to particle diameter ratios of 5-12. Over these ranges the radial Peclet number Pe_r showed significant dependence on solid conductivity, gas flow rate and particle shape, while the wall Biot number Bi showed significant dependence on tube to particle diameter ratio, gas flow rate and particle shape. These dependencies were predicted well by equations incorporating the effects of these variables into individual gas and solid phase parameters, which were then combined to give the effective or lumped parameters     

PA66阻燃改性研究

通过卤系、氮系、磷系等阻燃体系对尼龙（PA）66进行阻燃改性研究，开发出一种赤磷与无机阻燃剂共用的复配阻燃体系。结果表明，当加入 赤磷10份、无机阻燃剂10份、玻纤30份时，利用该阻燃体系阻燃的PA66，其燃烧性能达FV－0级，拉伸强度大于100MPa，缺口冲击强度大于9kJ/m^2，综合性能优良。     

EXTERNAL FLUID HEATING OF A POROUS ED

This work deals with the thermal analysis of externally heated porous beds of finite length. A one dimensional model was developed that includes conduction and storage in both the fluid and bed, convective exchange between the fluid and bed, and the effect of adsorption/desorption in the bed. This model results in two coupled differential equations for the fluid and bed temperatures as functions of four independent dimensionless parameters. These equations were solved numerically using finite difference approximations. A truncation error analysis was carried out to maintain an accurate solution. The method of normalization is such that the results of this analysis are of use in bed design when the breakthrough characteristics in finite length beds are of interest. A method to measure bed thermal performance is defined and a means to optimize bed thermal performance is presented. An experiment was conducted to validate the numerically obtained results. A comparison of numerical to experimental results is presented     

二氧化氯催化氧化处理活性艳红染料废水催化剂的制备与应用

研究了二氧化氯催化氧化用催化剂的制备条件与催化剂性能。实验结果表明，在工业催化剂载体上负载Cu^2+活性组分的催化剂制备优化条件为：w(Cu²⁺)=6%，焙烧温度500 ℃，焙烧时间4 h。用此催化剂进行二氧化氯催化氧化处理COD为2 700 mg·L^-1的活性艳红染料配制废水时，COD去除率达75%；催化剂寿命与再生实验表明，该方法在技术与经济上都具有较强实用性。     

铁泥氧化制备颜料铁红的研究

以工业废渣铁泥为原料,经拌酸氧化制备铁红颜料,探讨了酸的种类、浓度及用量和氧化温度及时间对产品质量的影响。结果表明,较佳的工艺条件为:硫酸浓度60%,硫酸与铁泥质量比1∶1.2,氧化温度800℃,氧化时间2.0 h,得铁红产品,质量符合油漆、涂料等对铁红颜料的要求。     

氯霉素在聚茜素红薄膜修饰电极上的伏安行为及其测定

研究了聚茜素红薄膜修饰电极(PARE)对氯霉素(Chloramphenicol,CAP)的电催化作用,并应用于对微量CAP的定量检测。实验结果表明:在0.010mol/LHCl+1.0×10-4mol/LCu2++0.10mol/LNaCl测定体系中,CAP的浓度在1.0×10-9mol/L～1.0×10-8mol/L范围内与它的氧化峰电流呈良好的线性关系,线性方程和线性相关系数分别为:ip(μA)=-0.188×10-8CCAP(mol/L)-7.62,γ=0.9997,检出限可达5.0×10-10mol/L。CAP的标准回收率为95.9%~102.9%,八次平行样品测定结果的相对标准偏差3.2%。     

温度影响下压实红粘土持水特性研究

通过渗析法和水汽平衡法研究不同温度控制下干密度1.7 g/cm~3压实红粘土持水特性(SWRC:soil water retention characteristics)。试验结果表明:20℃下干密度1.7 g/cm~3压实红粘土进气值约为110 k Pa;试样控制的温度越高,压实红粘土样持水能力越低,土样进气值随着温度升高而减小,且呈线性关系;Van Genuchten(1980年)土水特征模型能很好的描述干密度1.7 g/cm~3压实红粘土持水特性曲线。