Optimal Control of the Primary Drying Stage of Freeze Drying of Solutions in Vials Using Variational Calculus

The problem of operating freeze drying of pharmaceutical products in vials placed in trays of a freeze dryer to remove free water (in frozen state) at a minimum time was formulated as an optimal control problem. Two different types of freeze dryer designs were considered. In type I freeze dryer design, upper and lower plate temperatures were controlled together, while in type II freeze dryer design, upper and lower plate temperatures were controlled independently. The heat input to the material being dried and the drying chamber pressure were considered as control variables. Constraints were placed on the system state variables by the melting and scorch temperatures during primary drying stage. Necessary conditions of optimality for the primary drying stage of freeze drying process in vials are derived and presented. Furthermore, an approach for constructing the optimal control policies that would minimize the drying time for the primary drying stage was given. In order to analyze optimal control policy for the primary drying stage of the freeze-drying process in vials, a rigorous multi-dimensional unsteady state mathematical model was used. The theoretical approach presented in this work was applied in the freeze drying of skim milk. Significant reductions in the drying times of primary drying stage of freeze drying process in vials were obtained, as compared to the drying times obtained from conventional operational policies.     

提取地震信号高频信息方法的若干问题

岩性油气藏勘探已成为当代油气勘探的重要组成部分,因此提取地震资料高频信息已成为一个重要研究课题。文中对分辨率、分频处理地震信号、波阻抗反演中的一些问题进行了较深入的讨论,并得出以下认识:1要提高垂向和横向分辨率,必须设法提高野外采集地震资料的频率;2地震分频处理是偏移后提高分辨率的常用方法之一,这种方法应该限定在地震波的有效频带内,而超出有效频带,可能会带来很多假像;3低频合成地震记录中高频反射系数存在不确定性。在基于模型波阻抗反演的方法中,反演结果受初始模型的影响非常大,初始模型是依据测井资料建立的,初始模型与实际情况越接近,反演效果就越好;否则,会产生模型化的现象;4在相对波阻抗数据体(相当于地震数据体)作为约束条件下的SP测井参数协克里金插值是正演过程,消除了模型化的问题,使反演结果更接近真实情况,提高了砂层真实的分辨率。     

CSTN-LCD用铬版清洗效果的改善

利用铬版清洗机对CSTN-LCD用铬版进行清洗处理,分析了清洗过程中出现的铬层脱落现象,铬层脱落与轴向喷射压力和水平切力密切相关,通过调整转速和喷射压力探索了安全使用条件:在转速不超过1000r/min,喷射压力低于0.5×105Pa的情况下使用铬版清洗机进行清洗是相对安全的。同时采用预清洗处理的方法满足清洁要求,使换线时间由平均3h缩短到平均1h以内,年产能提高270000片。     

井下乳化/水热催化裂解复合降黏开采稠油技术研究

实验考察了胜利孤东稠油井下催化水热裂解和乳化/催化水热裂解降黏效果。所用催化剂为水溶性铁镍钒体系,Fe3+∶Ni2+∶VO4+=5∶1∶1,100 g稠油与30 g 0.5%催化剂水溶液在240℃反应24小时。原始黏度(50℃)11.0和8.36 Pa.s的两种稠油裂解并静置除水后,黏度降低76.2%和75.6%,室温放置60天后降黏率下降小于3个百分点,气相色谱显示裂解后轻组分明显增加,红外光谱显示稠油组分发生脱羧反应且芳环数减少。讨论了稠油催化水热裂解反应机理。所用化学助剂JN-A在油水中均可溶,耐温达250℃,耐矿化度达50 g/L,其水溶液以30∶100的质量比与稠油混合时形成低黏度的O/W乳状液。当水相含1.0%JN-A和0.5%催化剂时,两种稠油水热裂解后的反应混合物为O/W乳状液,黏度仅为319和309 mPa.s,静置除水后的稠油降黏率增加到86.5%和87.3%,其中的轻组分含量进一步增加。该井下乳化/催化水热裂解复合降黏法成功地用于孤东两口蒸汽吞吐井,稠油井作业后初期采出的原油黏度由~9 Pa.s降低到1 Pa.s左右,随采油时间延长而逐渐升高,约50天后超过4Pa.s。图2表6参5。     

Fifty Years On: Brown v. Board of Education and American Psychology, 1954-2004 An Introduction.

Introduces the current issue of the American Psychologist, which examines the ramifications of the Brown vs. Board of Education decision and its sequelae over the last 50 years, with a special focus on the mixed role of psychological research and practice. Despite the great strides toward a more just society since May 17, 1954, inequities remain in schooling, in social relations, and in economic opportunity. How will history judge American psychology 50 years from now vis-a-vis the possibilities it helped create via Brown? The articles in this special issue suggest several important directions of research and action our field will need to take if the verdict of history is to be a positive one. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

双级染料激光放大器泵浦能量分配的数值研究

用染料激光放大器的横向稳态泵浦理论，对不同的入射光能量选择不同的增益计算方法，研究了双级染料放大器的泵浦能量分配比例、泵浦光总能量和信号光能量大小对激光增益的影响。计算结果表明，对于其他参数确定的放大系统，存在着最佳的泵浦能量分配比例，可获得最大增益输出。通过自编程序的计算，可方便地找出特定系统泵浦能量分配比例的最佳值。     

Use of X-ray computed microtomography to understand why gels reduce relative permeability to water more than that to oil

X-ray computed microtomography (XMT) was used to investigate why gels reduce relative permeability to water more than that to oil in strongly water-wet Berea sandstone. XMT allows saturation differences to be monitored for individual pores during various stages of oil, water, and gelant flooding. The method also characterizes distributions of pore size, aspect ratio, and coordination number for the porous media. We studied a Cr(III) acetate–HPAM gel that reduced permeability to water (at S_or) by a factor 80–90 times more than that to oil (at S_wr). In Berea, the gel caused disproportionate permeability reduction by trapping substantial volumes of oil that remained immobile during water flooding (i.e., 43.5% S_or before gel placement versus 78.7% S_or after gel placement). With this high trapped oil saturation, water was forced to flow through narrow films, through the smallest pores, and through the gel itself. In contrast, during oil flooding, oil pathways remained relatively free from constriction by the gel.     

Quality Control for Scalable Media Processing Applications

Many media processing applications create a load that varies significantly over time. Hence, if such an application is assigned a lower processing-time budget than needed in its worst-case load situation, deadline misses are likely to occur. This problem can be dealt with by designing media processing applications in a scalable fashion. A scalable media processing application can run in multiple qualities, leading to correspondingly different resource demands. The problem we consider is to find an accompanying quality control strategy, which minimizes both the number of deadline misses and the number of quality changes, while maximizing the quality of processing. We present an initial approach to the above problem by modeling it as a Markov decision process (MDP). Our model is based on measuring relative progress at milestones. Solving the MDP results in a quality control strategy that can be applied during runtime with only little overhead. We evaluate our approach by means of a practical example, which concerns a scalable MPEG-2 decoder.     

Reconfigurable hardware implementation of a phase-correlation stereoalgorithm

This paper describes the implementation of a stereo-vision system using Field Programmable Gate Arrays (FPGAs). Reconfigurable hardware, including FPGAs, is an attractive platform for implementing vision algorithms due to its ability to exploit parallelism often found in these algorithms, and due to the speed with which applications can be developed as compared to hardware. The system outputs 8-bit, subpixel disparity estimates for 256× 360 pixel images at 30,fps. A local-weighted phase correlation algorithm for stereo disparity [Fleet, D. J.: {Int. Conf. Syst. Man Cybernetics 1:48–54 (1994)] is implemented. Despite the complexity of performing correlations on multiscale, multiorientation phase data, the system runs as much as 300 times faster in hardware than its software implementation. This paper describes the hardware platform used, the algorithm, and the issues encountered during its hardware implementation. Of particular interest is the implementation of multiscale, steerable filters, which are widely used in computer vision algorithms. Several trade-offs (reducing the number of filter orientations from three to two, using fixed-point computation, changing the location of one localized low-pass filter, and using L1 instead of L2 norms) were required to both fit the design into the available hardware and to achieve video-rate processing. Finally, results from the system are given both for synthetic data sets as well as several standard stereo-pair test images.     

企业中层管理人员培训的思考

以分析企业中层管理人员培训的现状为突破口,阐述了中层管理人员培训需求分析的思路和方法。在此基础上对培训内容进行整体设计,指出针对此类培训应采用的培训方式和评估方法。以期对企业中层管理人员的培训起到一些启发和借鉴作用。