用土壤含水层处理系统去除水库微污染有机物的试验研究

本文针对当前中国饮用水源污染以微污染为主的特点，以北京三家店水库原水和永定河河道砂为研究对象，设计了用于表征土壤含水层处理系统的一维土柱，进行污水净化效果的试验研究。结果表明，土壤含水层处理系统对三家店水库微污染水中的有机物有一定的去除效果，在0．12m／d的水力负荷条件下，对CODMo去除率虽然仅为15％，但是出水达到了地表水Ⅱ类水质标准；对BOD5的去除率达到了55％，可以被有效地去除。渗透速率相同时，水力负荷周期对去除效果的影响不明显，但在保证一定水力负荷的情况下，可适当延长落干期，恢复土壤的渗透能力，达到较好的处理效果。同时，土壤含水层处理系统的净化能力主要发生在土层50cm以内。     

对称配筋小偏心受压构件的截面设计

对小偏心受压构件在对称配筋情况下的截面配筋计算，提出用最佳一次逼近多项式简化基本公式，直接按二次方程求解ξ的近似方法，具有精度高，相对误差小，计算方便等优点，可供工程设计人员参考。     

道路边坡生态防护初探

随着我国经济实力的增强和人们环保意识的提高，国家已经十分重视道路建设中的生态建设和环境保护。通过对已建道路边坡防护方式进行分析，找出了存在的问题，提出改善和提高道路边坡防护的方法，并通过工程实例进一步得到验证。     

基于遗传算法的土钉支护结构优化设计研究

通过建立三维有限元模型,对土钉支护的变形和受力性能进行分析,得出土钉力的合理分布。在此基础上,考虑土钉支护的水平位移,采用遗传算法,对土钉支护的结构优化设计进行研究,建立了土钉支护结构的优化设计数学模型,并编制了相应的计算程序。通过算例分析,并与基于极限平衡分析的优化结果相比较,得出合理的土钉支护结构设计的参考结论。     

屋顶绿化配套技术研究

从绿化植物选择、种植土的配制、防排水措施，养护管理等方面介绍了“屋顶绿化配套技术研究课题”的主要成果。     

太钢不锈冷轧工程防腐蚀施工技术

防腐蚀施工工艺掌握的好坏，直接影响到工程投入生产后的使用寿命，为保证工程质量，以太钢不锈冷轧改造工程冷线防腐为例，对其常发生的质量通病进行认真分析，总结出一套行之有效的施工技术。     

长期酸化对红壤中活性固相铝库大小及亏损程度的影响

用连续分级提取和反复多次酸提取方法研究了长期土壤酸化对红壤固相铝库中铝含量及亏损程度的影响。研究结果表明:嵊县红壤的活性铝库大于永春红壤和屯溪红壤;因永春红壤和屯溪红壤的酸化程度大于嵊县红壤,前两者的有机铝库和无机铝库都比嵊县红壤的亏损,因此反复酸提取过程中铝的释放量也比嵊县红壤少;当高强度酸输入土壤后,弱键合的有机络合态铝可快速活化并亏损,剩余铝库因活性小而释放速率减小,但长期酸化过程中,动力学控制的低活性铝库的活化可能对铝的溶解量仍有重要贡献。     

Fracture toughness of thermoset composites reinforced by perfectly bonded impenetrable short fibers

The fracture toughness of brittle thermoset resins could be improved significantly by perfectly bonded tough, short fibers through both crack trapping and bridging effects. In this paper, the crack trapping effect was studied through the analysis of the change of strain energy associated with the crack propagation across a regular array of fibers, and the bridging effect was discussed based on the Andersson–Bergkvist model. The fracture resistance increases with the fiber volume fraction, and is independent of the elastic properties of the matrix, the crack length, and the cross-sectional diameter of the fibers.     

Deflection Calculation of FRP Reinforced Concrete Beams Based on Modifications to the Existing Branson Equation

Fundamental concepts of tension stiffening are used to explain why Branson’s equation for the effective moment of inertia Ie does not predict deflection well for fiber reinforced polymer (FRP) reinforced concrete beams. The tension stiffening component in Branson’s equation is shown to depend on the ratio of gross-to-cracked moment of inertia (Ig/Icr), and gives too much tension stiffening for beams with an Ig/Icr ratio greater than 3. FRP beams typically have an Ig/Icr ratio greater than 5, leading to a much stiffer response and underprediction of computed deflections as observed by others in the past. One common approach to computing deflection of FRP reinforced concrete beams has been to use a modified form of the Branson equation. This paper presents a rational development of appropriate modification factors needed to reduce the tension stiffening component in Branson’s original expression to realistic levels. Computed deflections using this approach give reasonable results with the right modification factor, and compare well with a more general unified approach that incorporates a realistic tension stiffening model. Comparison is made with the existing and past correction factors recommended by ACI 440 for predicting deflection of FRP beams. The method presently used by ACI 440 gives reasonable estimates of deflection for glass and carbon FRP reinforced beams. However, this method underestimates deflection of aramid FRP reinforced beams and is restricted to rectangular sections. A proposal is made for adoption of a simple modification factor that works well for all types of FRP bar and beam cross-sectional shape.