智能水滴算法研究

智能水滴算法是模拟自然界中河水与周围环境相互作用的过程而提出的一种智能计算方法。文章首先描述智能水滴算法的原理,然后综述智能水滴算法在多个研究领域的应用,最后对智能水滴算法进行总结与讨论。     

毛细管气相色谱法同时测定三磷酸胞苷二钠中5种有机溶剂残留量

研究建立了同时测定三磷酸胞苷二钠中乙醇、丙酮、氯甲醚、甲苯、苯乙烯5种有机溶剂残留量的毛细管气相色谱法。样品以乙腈为溶剂,经DB-FFAP(30 m×0.32 mm×0.25μm)毛细管柱分离,氢火焰离子化检测器检测,这5种有机溶剂呈良好的线性响应,平均回收率在98.3%~99.5%,精密度RSD在0.21%~1.92%,最低检出限可达5.0~7.5 mg/kg。本方法简单、灵敏、准确,完全能满足药品中所述有机溶剂残留量的测定要求。     

Thermoplastic extrusion—the mechanism of the formation of extrudate structure and properties

Systems processed by thermoplastic extrusion can be regarded as heterophase polymer melts of incompatible water-plasticized biopolymers. In the process of thermoplastic extrusion, proteins and polysaccharides are melted at high pressure and temperature below the temperature region of their thermal decomposition. Dispersed particles of these systems can be deformed in flow. The mixed-melt anisotropic structure, formed in flow, is fixed by rapid conversion of the melt jet that lets the extruder die from a viscous state to a rubber-like state and then to a glassy state caused by cooling and drying. Incompatibility of proteins and polysaccharides in their water-plasticized melt mixtures impacts on structure formation and texturization during thermoplastic extrusion. Presented at the 20th ISF World Congress and 83rd AOCS Annual Meeting and Expo, May 10–14, 1992, Toronto, Ontario, Canada.     

电解法处理利福霉素SV钠废渣分离液的研究

根据电化学原理，采用电解法，利用铁屑与炭粒作电极，处理利福霉素SV钠药渣分离液，讨论各种因素对分离液污染物作效果的影响，COD去除率可达91．8％左右，脱色率可达95％左右。     

Structural and Mechanical Properties Changes of Ethylene‐α‐olefin Copolymer Blends Induced by Thermal Treatments and Composition

Summary: Blends of single‐site catalysed ethylene‐α‐butene (C₄VLDPE) and ethylene‐α‐octene (C₈VLDPE) copolymers were prepared by melt extrusion. The phase morphology, thermal and mechanical properties of the blends have been investigated by differential scanning calorimetry (DSC), scanning electron microscopy (SEM), tensile test and dynamic mechanical analysis (DMA). Depending on the composition and thermal history, significant differences in structure and behaviour were found. It was also found that some degree of co‐crystallization occurred for quenched blends; whereas most of the oven slowly cooled blends showed two well‐defined melting peaks, indicating that the slow cooling favoured partial segregation of the fractions with different degrees of branching to form two morphologies. Moreover, SEM revealed morphology of the thinner crystals distributed in‐between the thicker sheaf‐like crystals for the slowly cooled blends with 20–50% C₈VLDPE. Therefore, the synergism in mechanical properties for the blends with 20–50% C₈VLDPE is due to a combination of larger crystal size, more complete phase separation and interfacial interaction produced by the segregation effect of the slow cooling treatment. DMA studies showed that the storage modulus increased as the addition of C₈VLDPE and modulus for the slowly cooled blends are about twice those measured for the quenched ones, indicating higher stiffness of the blends. The smooth shift of β relaxation temperature with addition of C₈VLDPE for both sets of blends confirmed the miscibility in the amorphous phase.

SEM image of the C₄VLDPE‐C₈VLDPE (50/50) blend after oven slow cooling treatment.     

工业循环冷却水用BC－653杀生剂的抗菌性能测定

本文对ＢＣ－６５３杀生剂进行了室内抗菌实验，着重阐述了投药量对杀菌率的影响。结果显示该杀生剂与国外同类产品杀菌力基本一致。     

超滤膜等离子体改性分离大豆蛋白的研究

分别用氧气和氩气等离子体对醋酸纤维素超滤膜进行表面改性,用大豆分离蛋白溶液进行超滤实验,结果表明等离子体处理后膜的接触角变小,亲水性能大大增强,超滤过程可以在保持截留率不变的情况下使膜的透水率增大2～3倍,同时膜的抗污染性能增强。研究发现在相同的等离子体反应条件下,氩气的处理效果优于氧气。     

Functionalization of carbon support and its influence on the electrocatalytic behaviour of Pt/C in H2 and CO electrooxidation

Chemical modification of Carbon Vulcan XC-72R for fuel cell applications has been undertaken. Treated carbons were used as carriers for the deposition of Pt nanoparticles and used as electrocatalysts. The influence of the carbon treatment, as well as that of the Pt nanoparticles generation and their deposition route has been studied. The behaviour of the electrocatalysts in the CO and hydrogen oxidation reaction (HOR) has been studied. It was observed that carbon pre-treatment lead to difference behaviour in the CO oxidation reaction compared with the performance over non treated supports. In this way, CO oxidation was controlled by the nature of the support rather than by the nature of the Pt particles alone.     

现场总线技术在非能动压水堆核岛中的应用

本文结合非能动压水堆核电控制系统结构,详细介绍Profibus现场总线和Modbus现场总线在非能动压水堆核电控制系统中的应用,包括两种现场总线技术的结构配置及和现场智能仪控设备的连接,并简要分析现场总线技术在核电行业应用的优点和需克服的技术问题。