A NEW HEAT-TREATMENT PROCESS FOR 2014 ALUMINUM ALLOY AND ITS MECHANISM

The plan of heat-treatment process for 2014Al alloy is designed using orthogonal method, the heat-treatment experiments are made and the mechanical properties are tested according to the designed plan. The effect of solid solution temperature, ageing temperature, ageing time on microscopic mechanism of the mechanical properties of the 2014Al alloy is studied using microscope, transmission electron microscope. The best heat treatment process of the 2014Al alloy is developed. The experimental results indicate that the strength σ_b, yield stress σ_(0.2), percentage elongation δ of the alloy reach separately 490～500 MPa, 450～490 MPa, 10～12％ adopting the new heat treatment process. Compared with GB, the strength increases 20～30％, the percentage elongation increases 30～40％. The mechanism of the new heat-treatment process is also discussed.     

试样长度对 13CrMo44钢管力学性能的影响

研究了试样长度对13CrMo44珠光体耐热钢管力学性能的影响，研究结果表明，随着L0升高，该钢管的伸长率下降并满足δ=16.9% 68.2%√F/L0关系，L0较短时，其对钢管的抗拉强度（σb)和屈服强度（σs)没有什么影响；L0较长时，钢管的σb和σs都稍有下降，解释了产生上述现象的原因。     

马来酸二异辛酯的合成

用对甲苯磺酸作催化剂。以顺丁烯二酸酐和异辛醇为原料，采用醇化学当量过最的方法制取马来酸二异辛酯。研究了催化剂、温度、醇酐摩尔比、反应时间等条件对反应产率的影响，确定了最佳反应条件，并指出合理的产率应该在98．0％-98．5％．     

莫莱石－堇青石滤料滤池在生产上的应用

本文对景德镇市黄泥头水厂进行了单层莫－堇滤料滤池和双层莫－堇－煤滤料滤池的生产性试验。试验结果表明：单层莫－堇滤池和双层莫－堇－煤滤池的周期产水量分别是单层砂滤池和双层砂－煤滤池的１．４倍和１．５倍，而且前两种滤池的出水水质优于后两种滤池。     

Methane Transport Capacity of Rice Plants. II. Variations Among Different Rice Cultivars and Relationship with Morphological Characteristics

Of the total methane (CH4) emitted from a rice field during the growing season 60–90% is emitted through the rice plants. We determined the methane transport capacity (MTC) of rice plants at different physiological growth stages using an automatic measuring system under greenhouse conditions. A total of 12 cultivars (10 inbred varieties and 2 hybrids) were studied in sets of two experiments and was distinguished into three groups according to the patterns of MTC development. MTC is generally increasing from seedling stage to panicle initiation (PI), but differs in the development from PI to maturity. While the hybrid showed a gradual increase in MTC, the inbred cultivars showed either minor changes in MTC or a drastic decrease from flowering to maturity. Among tall cultivars, Dular showed the highest MTC, followed by B40; the lowest MTC was found in Intan. High-yielding dwarf cultivars showed MTC in the descending order of IR72 > IR52 > IR64 > PSBRc 20. New plant type cultivars showed very low MTC with IR65600 exhibiting the smallest MTC at PI, flowering, and maturity. Hybrids (Magat and APHR 2) showed the largest MTC that continued to increased with plant growth. The MTC patterns were attributed to growth parameters and the development of morphological characteristics of the aerenchyma. These results suggest that in tall, dwarf, and NPT cultivars, increase in root or aboveground biomass during initial growth determines a corresponding increase in MTC. Once aerenchyma has fully developed, further increase in plant biomass would not influence MTC. However, in the case of hybrids, a positive relationship of MTC with root + shoot biomass (r = 0.672, p 0.05) and a total plant biomass including grain (r = 0.849, p 0.01) indicate continuous development of aerenchyma with plant growth, resulting in enhanced MTC. In all cultivars, tiller number, but not height, was linearly related to MTC, indicating that the number of outlets/channels rather than plant size/biomass determines the transport of CH₄. These results clearly demonstrate that rice cultivars differ significantly in MTC. Therefore, the use of high-yielding cultivars with low MTC (for example, PSBRc 20, IR65598, and IR65600) could be an economically feasible, environmentally sound, and promising approach to mitigate CH₄ emissions from rice fields.     

Influence of volatile matter and deposited carbon on coke yield from coals

The relations between coke yields and the volatile matter content of 30 individual and 30 blended coals were investigated. Coke yields and deposited carbon related to volatile matter content can be expressed in the following equations: CY (%) = 97.89?0.86 VMch+VMc; and DC (%)= ?2.24+0.16 VMch; where: CY=real coke yield; VMch = volatile matter content of charging coal; VMc=volatile matter content of coke, and in the case of <2%; DC = deposited carbon. The test results show excellent correlation with practice.     

新型CDCM催化剂在两段提升管催化裂化装置上的应用

CDCM催化剂在800 kt·a^－1两段提升管重油催化裂化装置（TSRFCC）上的应用结果表明,该催化剂具有活性高、目的产品选择性好、重油裂解能力强和抗重金属污染能力强的特点。能显著改善产品分布和提高产品质量，在操作条件基本不变的情况下，液态烃收率和总液收分别可提高2.80和0.60个百分点，同时汽油辛烷值和诱导期提高，液态烃中丙烯含量增加。     

Photocurrents and degradation rates on particulate TiO2 layers: Effect of layer thickness, concentration of oxidizable substance and illumination direction

Different routes for immobilization of TiO₂ on conducting substrates were compared to find active and stable photocatalysts, which could either be operated in open circuit (photocatalysis) or with applied electric potential (photoelectrocatalysis). The advantage of applying an electric potential was investigated. Polarization curves and photoelectrochemical degradation reactions served to characterize catalysts and to find a way of predicting the optimum synthesis conditions. The difference between front side (EE) and back side (SE) illumination is discussed as a function of layer thickness, as well as the influence of oxidizable substance concentration on photocurrents. Stability of catalysts was investigated in repetitive degradation experiments.     

FC-26高中油型加氢裂化催化剂的工艺研究

抚顺石油化工研究院研制开发的新一代FC -2 6高中油型加氢裂化催化剂 ,以W -Ni为加氢组分 ,以无定型硅铝为主载体 ,并添加改性分子筛。工艺研究及工业应用结果表明 ,FC -2 6催化剂活性及中油选择性高 ,稳定性好 ,原料适应性强 ,具有广阔的应用前景。     

稻草净防除稻田杂草试验

稻草净亩用５０￣１００克对稻田眼子菜、鸭舌草、甲叶薄等阔叶杂草有很好的防效，并用明显的增产作用。大田移载后１５天一次施药可以控制水稻田整个生育期的阔叶杂草。