W‐band physical layer design issues in the context of the DAVID–DCE experiment

This paper aims at focusing on the aspects concerning the physical layer design for an innovative satellite communication experiment. Such an experiment, denoted by the acronym DAVID–DCE (Data and Video Interactive Distribution—Data Collection Experiment) is based on the exploitation of the W‐band (75–110 GHz) for high‐bit‐rate satellite transmission. The potential advantages of using of the W‐band are mainly related to the great bandwidth availability, and to the absence of interference. Moreover, an expected result of the experiment is a substantive improvement in the communication system's performances in the presence of meteorological phenomena (e.g. rain) as compared with the more conventional Ka‐band satellite transmission. On the other hand, problems to be faced concern the non‐ideal behaviours of hardware devices employed for high‐frequency digital transmission. In particular, carrier recovery and timing recovery are the most crucial signal‐processing tasks to be carefully considered in the design of the physical level of the system, because they considerably suffer from hardware impairments. The purpose of this work is to illustrate the proposed solutions in terms of the most critical modulation, demodulation and synchronization design issues, together with the effects of non‐ideal behaviours of hardware components on BER performances. Copyright © 2004 John Wiley & Sons, Ltd.     

Optical and structural properties of MOVPE grown GaxIn1−xAs/InP strained multiple quantum well atructures

This paper presents a study of the structural and optical properties of strained GaInAs/ InP multiple quantum well (MQW) structures fabricated by LP-MOVPE. The composition of the Ga _x In_1−x As films ranged fromx = 0.17 tox = 1.0 and was determined by sputtered neutral mass spectrometry (SNMS) on thick layers. The structures of the MQW samples with well widths from 1.5 to 5 nm were investigated by high resolution x-ray diffraction (HR-XRD). Simulations of the diffraction patterns showed that transition layers of approximately 2 monolayer (ML) thickness with high lattice mismatch exist at the interfaces. Photoluminescence (PL) measurements indicate well widths of a multiple of a monolayer with local variations of one monolayer. The PL peak energies vary smoothly with the Ga concentration. These results were confirmed by optical absorption measurements.     

在建坝体中部分浆砌石的控制爆破拆除

某在建大坝部分浆砌石坝体因质量不合格须爆破拆除。保护余留坝体免受爆破影响是此工程的重点,为此,采用了小直径浅孔和微差爆破分层拆除方法,被拆除部分和被保护部分之间预留保护层。爆破施工过程中,利用超声波观测法和压水试验法判断被保护坝体是否受到了爆破震动的影响。根据判断结果,调整爆破参数,以减小爆破震动。文中论述了爆破参数的选择、保护层厚度的确定,同时介绍了安全控制技术、测点布置以及监测结果。     

某炼油厂一级浮床除盐系统阳床工艺特性及调整试验

论述了某厂一级除盐系统阳床工艺特性及调整试验过程，对存在问题进行分析并改进，得到了实际运行最佳方式和参数，取得良好效果。     

Feedback linearizing control of a fluidized bed reactor

The design of an adaptive nonlinear controller for the control of a fluidized bed reactor is derived by using exact linearization techniques. Reset action and parameter adaptation are used to make more robust the precise compensation of nonlinear terms, which is called for in the linearization technique. A nonlinear antiwindup mechanism is introduced to handle reset windup problem and to provide fast response without large overshoot. Simulation results show that the proposed adaptive controller guarantees good setpoint tracking. The developed estimation algorithm allows accurate estimation of the parameters for which the regressor component is not zero.     

主动约束层阻尼板结构动力学建模研究

将有限元法和GHM法相结合，给出了建立主动约束层阻尼（ACLD）板结构动力学模型的新方法。建模时，考虑到粘弹材料（VEM）的纵向位移影响，采用GHM方法描述VEM的本构关系，解决了VEM的力学特性随温度和频率变化的难点，避免因VEM的复杂本构关系而产生的微分积分方程。算例表明本文给出的建模方法是准确的，ACLD结构能够有效控制结构振动。     

多孔挡板流化床还原UO3反应器模型的研究

针对ＵＯ＿３的Ｎ＿２还原反应建立了多孔挡板流化床反应器模型。将多孔挡板床的每一级视为具有相似的流动状态，每一级的上、下段称为稀、密相段，分别用鼓泡床和活塞流模型描述。该模型的计算值与￠６３ｍｍ的多孔挡板床Ｈ＿２还原ＵＯ＿３的热态实验值能较好的吻合。还预计了还原温度、操作气速和挡板结构参数对固相转化率的影响，为该类反应器的工业设计、放大和优化提供了依据。     

挡土墙填土曲线破裂面的地震主动土压力分析

在地震作用影响下，墙后填土处于极限平衡状态时，假定破裂面为一条通过墙趾的旋轮线。从墙后土楔中取出一微薄水平层，研究其在水平惯性力下的平衡，得到的地震土压力分布和土压力合力作用点位置均与实验结果相吻合。     

Structure of interstitial assemblages in a regulated channel of the river rhine (France)

The interstitial assemblages of the River Rhine were studied in the Rhinau sector (France). The studied area is located in aVegulated channel of the river, controlled by a hydroelectric dam. Twenty stations were sampled in September 1988. Ten litres of interstitial water were pumped at 50 cm depth in each station using the Bou-Rouch technique. Interstitial waters were poorly oxygenated and the hyporheic fauna had three major characteristics: (1) microcrustaceans were dominant, (2) the insects were rare and (3) the stygofauna was absent. The richest stations were well oxygenated and did not correspond to any particular geomorphological features. These findings contrast with the situation observed on other large European rivers (Rhǒne, Danube) where the interstitial assemblages appear to be locally more diversified and rich in stygofauna.