A simplified cascade current‐source inverter interconnected to a single‐phase three‐wire distribution system and its application to electric energy storage systems with batteries

A novel current source inverter system interconnected to the single‐phase grid is proposed. It has the same construction as the conventional three‐phase current source inverter that is interconnected to the single‐phase three‐wire distribution system. Though the proposed circuit has no output transformer, it can be equivalently performed as the single‐phase double cascade inverter by diverting the pole transformer in the utility system. By controlling the appropriate scheme, the output currents can be obtained as the five‐level waveforms and their distortions can be decreased sufficiently. It is applied to the interactive electric energy storage system with batteries and the basic discharging characteristics are discussed experimentally. © 2004 Wiley Periodicals, Inc. Electr Eng Jpn, 150(2): 50–61, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10380     

Characteristics and classification of high-current fault arcs on distribution systems

When a fault occurs on transmission or distribution systems due to lightning or overvoltage, often an arc discharge occurs at the fault point. The arc discharge, which is caused by a fault current, has a high current, high temperature, strong light emission, etc., thus it sometimes causes heavy damages to electric power equipment. The arc discharge is influenced by the conditions around the arcs, i.e., gas, insulation materials, gap length, weather, etc. Also, the arc voltage along the arc column indicates the characteristics of the arc. If the voltage waveforms of the arcs caused by the fault on transmission or distribution systems are classified, it is possible to find the location and the equipment where the fault occurred. In this paper, the arc voltage data in 6-kV class XLPE cables and 6-kV class overhead lines are analyzed and an artificial neural network method is applied to classify the arc voltage waveforms. The results obtained from the six artificial neural networks developed show that the artificial neural network method is effective for classification of arc voltage waveforms if adequate input parameters are selected.     

人群头发元素分布及某些特征研究

本文介绍用堆中子活化分析法测定人群头发中I、Br、Mg、Mn、Cu、Na、V、Cl、Al、Ca、S等11种元素。研究人发中元素分布特征、相关性特征、性别年令分布特征。方法学中还从法庭科学应用角度介绍同一性识别中差异率和重合几率的双判据方法。     

Moisture Distribution and Dewatering Efficiency for Wet Materials

This review paper summarizes current research efforts toward a comprehensive view of wet material dewatering, considering the binding energy as the strength to hold water, and rupture energy given to remove moisture from materials.     

充油S-SBR加工行为的研究

在中试装置上合成相对分子质量分布较宽的充油S-SBR，考察不同环烷油和芳烃油填充量的充油S-SBR的流变性能和混炼行为。结果表明，增大油的填充量能提高充油S-SBR的流动性能，充芳烃油S-SBR相对于充环烷油的S-SBR对温度更敏感，宽相对分子质量分布的充环烷油S-SBR的混炼性能优于S-SBR1204及E-SBRl778，竟相对分子质量分布的充芳烃油S-SBR的混炼性能优于S-SBR1204，Solprene380和E-SBR1712。     

生物质中元素分布特征的聚类分析研究

测定了稻草秆、小麦秆、玉米秆、棉花秆、大豆秆、玉米芯、花生壳和柳树、松树、桦树、杨树、杉树 1 2个农业生物质和林业生物质种类 2 7个样品中主要元素 K,Ca,Na,Mg,Al,Fe,P和痕量元素 As,Cr,Co,Cu,Cd,Mn,Mo,Ni,Pb,Ti,Zn,V,Si,Ba,Be,Se,Sb,Ge,Hg的含量 ,并用SPSS聚类分析法分别进行了 R型和 Q型聚类研究 ,对这些元素在生物质中的分布特征进行了研究 .结果显示 :杨木、杉木和桦木与松木和柳木归成一大类 ,经济类作物黄豆秆和棉花秆分别归类后又归入一大类 ;农业生物质稻草秆和小麦秆、玉米秆被归入一类 ;虽然 2 7种生物质样品分别取自我国东北、华东、华北和西南地区 ,在地理位置上相距极远 ,但样品聚类谱系图表明 ,元素的分布特征与生物质的种类的关系显著 ,与产地的关系不明显 ,即元素的分布特征受种类的影响大 ,而受生长环境、气候、土壤条件的影响小 .     

Characterization of microporous-mesoporous MCM-41 silicates prepared in the presence of octyltrimethylammonium bromide

MCM-41 silicates prepared in the presence of octyltrimethylammonium bromide either by a conventional method or by post-synthesis hydrothermal treatment were characterized by nitrogen adsorption in a wide range of relative pressure from 10^-6 to 1. Hydrothermally restructured samples were found to have lower BET surface areas, lower external surface areas and thicker silica walls than the non-treated sample. More importantly, in addition to their characteristic mesopores (ca. 3 nm), they were shown to have considerable amounts of micropores. The relative amount of micropores and mesopores was shown to be dependent on the treatment conditions. Thus, it is demonstrated that the postsynthesis hydrothermal restructuring is a convenient synthesis route to MCM-41 silicates with bimodal pore size distribution involving controllable amounts of microporosity. This revised version was published online in July 2006 with corrections to the Cover Date.     

种子法制备聚合物乳液技术的进展

从建筑乳液的生产现状、自生种子法与外加种子法的区别、种子乳液的特点及外加种子法生产的乳液特性等方面介绍了种子法制备乳液技术的进展。     

HS2000分布式控制系统在小氮肥厂的应用

介绍了国产ＨＳ２０００分布式控制系统首次在山东禹城化工总厂尿素装置上成功应用的情况。     

Assessing the predictive capability of two‐phase models for the mechanical behavior of alumina/epoxy nanocomposites

A review of analytical modeling of particulate reinforcement is made as a prelude to the problem of microstructural inhomogeneity in nanocomposite materials. Noting the inevitability of dispersion nonuniformity, and variations in agglomerate morphology and filler‐matrix interaction, the need to question the application of such models to novel materials arises. Employing the mechanical properties of alumina/epoxy nanocomposites, with known dispersion characteristics, an evaluation of the predictive capability of various models for Young's modulus, strength, and failure strain is made. Comparison between models is accompanied by a discussion of the parameters used in the fitting of macroscopic behavior to microstructural features. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 98: 869–879, 2005