CAD OF MILLIMETER WAVE OSCILLATORS WITH THE FDHB TECHNIQUE

In this paper the modelling, analysis and optimization of millimeter wave oscillatorsare investigated by using the a frequency-domain harmonic balance technique (FDHB), where theexternal-circuit impedances looking outside from the active device are calculated with a combinedtechnique of modes expansion, Galerkin, and collocation methods. The optimization results arein agreement with the experimental ones, which show the reliability of the presented model andoptimization.     

挟沙水流中沙粒对底壁湍流猝发的影响

本文在常规的边界层方程中保留了法向压力梯度项和增加了固粒对流体的使用项，结合Ｂａｔｃｈｅｏｌｒ对交界面提供的分析方法和小扰动稳定性理论，由理论分析和计算得到了包括沙粒之类的悬浮体的尺寸，比重，流动Ｒｅ数，两相速度差以及扰动波数与水流底壁湍流猝发角的关系，计算结果与Ｒａｓｈｉｄｉ等的实验结果相符。文中所得结果有助于进一步了解江河底部水流的流动特性以及泥沙的沉积和输运机理。     

Measurement of the tunnel rate in SIS' tunnel junctions as function of bias voltage

Cryogenic detectors with superconducting tunnel junctions can provide an energy resolution improved by at least one order of magnitude compared with standard semiconductor detectors. While the detection principle was already demonstrated many years ago, the past years were dedicated to the transition from the laboratory sample to practical detectors. Our most favored detector design gives rise to tunnel junctions with electrodes of unequal energy gaps. In such hetero tunnel junctions bias conditions can be established which cause a negative signal current. We report the experimental verification of this effect, and we discuss the yield of charge signal of cryogenic detectors based upon superconducting tunnel junctions.     

汛期采金船的缆绳牵拉

本文介绍了采金船渡汛时的停泊方向及采金船在洪水中可能产生拖曳力的估算方法，为了防止采金船汛期发生溜船事故，建议采用缆绳牵拉固船的措施，以保障采金船的汛期安全。     

山西塔儿山地区金成矿的构造控制因素

本文通过分析晋南塔儿山地区的构造特征，探讨了该区金成矿作用的构造控制因素。     

网络分解法的误差分析

网络分解法是求解电大尺寸复杂结构电磁问题的重要方法之一,关于网络分解法误差分析的研究有着重要的理论意义和实用价值.本文给出了网络分解法的误差估计,并对于脉冲基函数转换成三角基函数的情况给出了三角基函数个数的最优公式,数值结果表明了分析的正确性.     

Partial scan design and test sequence generation based on reduced scan shift method

This paper presents a partial scan algorithm, calledPARES (PartialscanAlgorithm based onREduced Scan shift), for designing partial scan circuits. PARES is based on the reduced scan shift that has been previously proposed for generating short test sequences for full scan circuits. In the reduced scan shift method, one determines proch FFs must be controlled and observed for each test vector. According to the results of similar analysis, PARES selects these FFs that must be controlled or observed for a large number of test vectors, as scanned FFs. Short test sequences are generated by reducing scan shift operations using a static test compaction method. To minimize the loss of fault coverage, the order of test vectors is so determined that the unscanned FFs are in the state required by the next test vector. If there are any faults undetected yet by a test sequence derived from the test vectors, then PARES uses a sequential circuit test generator to detect the faults. Experimental results for ISCAS'89 benchmark circuits are given to demonstrate the effectiveness of PARES.     

一种新的带优先权控制的ATM交换结构

本文在Ｋｎｏｃｋｏｕｔ交换结构的基础上，探讨一种新的ＡＴＭ交换结构，使其本身带有优先权控制功能，以适应不同业务对信元丢失率及时延的不同要求。这种结构既能最大限度地有效利用系统资源，又能满足不同用户对业务质量的不同要求，并能降低交换结构复杂度。     

铯原子激光共振电离

用Ｎｄ：ＹＡＧ及其泵浦的染料激光进行铯原子三步共振电离。求解了非饱和共振过程速率方程，计算出基态和激发态共振吸收截面，给出电离效率分别与激发电离速率以及作用时间的变化关系，得到饱和激发电离的流量条件和通量条件。     

恢复地层剥蚀厚度方法综述

恢复地层剥蚀厚度是对盆地进行定量研究的重要基础工作。本文综述、评价了目前常用的恢复剥蚀厚度的方法,并对作者曾提出的天然气平衡浓度法作了进一步的阐述。