关于解决黄牛鞋面革松面问题的探讨

本文讨论了在黄牛鞋面革生产过程中产生松面的原因，并经过多年的生产实践，摸索出解决松面问题行之有效的技术措施。     

On the applied stress dependence of the subgrain size

The present work studies the collection of experimental data from which Raj and Pharr (Mater. Sci. Eng., 81 (1986) 217) deduced a universal empirical dependence of the subgrain size on the applied stress. In accord with their result and some theoretical predictions the normalized subgrain size d_s/b was ssumed to be proportional to G/σ (G is the shear modulus, b the Burgers vector length, σ the applied stress). The evaluated factor of proportionality K₁, having the value within the interval from 0.76 to 180 in the inspected data sets, was discussed from the point of view of various factors which can influence the experimental data.     

鼓风引射式燃气燃烧器的计算

提出鼓风式射式燃气燃烧器的基本计算公式与计算结果，并进行结构尺寸与工况分析，确定各种因素对其的影响程度。     

河口水流、波浪、潮流、泥沙、河床变形二维数学模型

根据河口“波浪掀沙，潮流输沙”的泥沙运动机制，引入“波浪幅射应力”反应波浪对水体和泥沙的驱动力．考虑波浪对底部泥沙作用力、波浪对水流挟沙能力的影响及风场对水流和泥沙运动的影响．同时考虑泥沙粒径大小、水体含盐度、含沙量及水流紊动程度等因素对絮凝沉速的影响．用ＡＤＩ算法求解沿水深平均方程，破开算子法解悬移质不平衡输沙方程及河床变形方程，引入通度概念处理岸滩不规则边界，建立河口水流、波浪、潮流、泥沙、河床变形二维数学模型．通过实测资料及卫星摇感图像对所建数学模型进行检验，表明它可以较好地预测河口泥沙的运动     

泥沙输移矢量式及其应用

本文基于Parker等人泥沙输移矢量式的分析和研究，增加了上举力的作用，并考虑了泥沙颗粒受力非平衡条件，采用牛顿力学的矢量分析法，推导了泥沙输移的通用矢量式。经对公式简化，且用Ikeda和笔者试验资料的验证，证明计算值与试验值吻合较好。     

A polydispersed particle system representation of the porosity for non-saturated cementitious materials

In this paper, the porosity of cementitious materials is described in terms of pore size distribution by means of a 3-dimensional overlapping sphere system with polydispersivity in size. On the basis of results established by Lu and Torquato [B. Lu, S. Torquato, Nearest-surface distribution functions for polydispersed particle systems, Phys. Rev. A 45(8) (1992) 5530-5544] and Torquato [S. Torquato, Random Heterogeneous Media: Microstructure and Macroscopic Properties. Springer-Verlag: New York, 2001] providing relations for nearest-neighbor distribution functions, the volume fraction of pores having a radius larger than a prescribed value is explicitly expressed. By adopting an appropriate size distribution function for the sphere system, it is shown that the pore size distribution of cementitious materials as detected for instance by mercury intrusion porosimetry (MIP), which generally points out several pore classes, can be well approached. On the basis of this porosity representation, the evaluation of the capillary pressure in function of the saturation degree is provided. The model is then applied to the simulation of the saturation degree versus relative humidity adsorption curves. The impact of the pore size distribution, the temperature and the thickness of the adsorbed water layer on these parameters are assessed and analyzed for three model materials having different pore characteristics.     

高频脉冲电铸Ni-Co纳米复合块体微观结构分析

采用高频脉冲电铸工艺制备出了镍钴纳米复合块体材料，利用场发射扫描电镜、能谱和X射线衍射的方法，重点研究了复合块体沉积层的表面形貌、相结构和结晶取向。结果表明．高频率和润湿剂的添加对沉积层的细化有重要影响，高频脉冲电铸能够获得微观组织致密、均匀的复合块体材料。     

川中丘陵区一种新型小流域径流输沙模型的建立与应用

径流输沙模型对定量评价水沙的输出响应具有重要的意义。本研究在已有研究成果的基础上，通过对四川盐亭县林山西沟小流域的径流、泥沙进行现场观测与分析，提出含沙量单位线的定义及其确定方法，建立了适应该小流域的径流输沙模型。并应用实测资料进行比较，表明模型的模拟结果可靠，模拟过程确定性系数达0．8以上，为川中丘陵区小流域径流输沙过程的预测预报提供了一个新方法。     

西北江三角洲来水来沙的非线性分形特征

根据西、北江干流高要、石角及西北江三角洲网河区顶点马口、三水四个水文站的流量和含沙量资料 ,应用非线性分形原理的R S方法 ,计算西北江干流及西北江网河区顶点四个水文站的流量、含沙量的赫斯特数H和分形维数D ;探讨西、北江干流来水来沙的分形特征及西北江三角洲的分水分沙规律。结果表明 ,流量的分维数略大于含沙量的分维数 ,三水站流量及含沙量的分维数与其上游的石角站流量、含沙量的分维数相差较大 ,与思贤的分水分沙造成西北江的水沙交换有关     

高速钢高温形变诱发析出的研究

本文探讨了高速钢在高温形变过程中碳化物析出的行为及奥氏体组织状态对析出的影响。用透射电镜和扫描电镜分析了不同热处理状态奥氏体的组织结构,分析了高温形变过程中碳化物析出的部位,颗粒尺寸及形态。试验表明, 碳化物主要在奥氏体的缺陷处呈点状和点列状析出,大小为20mμ。处于回复状态的奥氏体缺陷诱发碳化物析出,析出碳化物钉札缺陷阻止再结晶进行。当再结晶驱动力较大时,由于动态再结晶充分发展,使缺陷大量消除,碳化物析出显著地减少。