Prediction of the energy dissipation rate in ductile crack propagation

In this paper, energy dissipation rate D vs. Δa curves in ductile fracture are predicted using a ‘conversion’ between loads, load‐point displacements and crack lengths predicted by NLEFM and those found in real ELPL propagation. The NLEFM/ELPL link was recently discovered for the DCB testpiece, and we believe it applies to other cracked geometries. The predictions for D agree with experimental results. The model permits a crack tip toughness R(Δa) which rises from J_c and saturates out when (if) steady state propagation is reached after a transient stage in which all tunnelling, crack tip necking and shear lip formation is established. J_R is always greater than the crack tip R(Δa) and continues to rise even after R(Δa) levels off. The analysis is capable of predicting the usual D vs. Δa curves in the literature which have high initial values and fall monotonically to a plateau at large Δa. It also predicts that D curves for CCT testpieces should be higher than those for SENB/CT, as found in practice. The possibility that D curves at some intermediate Δa may dip to a minimum below the levelled‐off value at large Δa is predicted and confirmed by experiment. Recently reported D curves that have smaller initial D than the D‐values after extensive propagation can also be predicted. The testpiece geometry and crack tip R(Δa) conditions required to produce these different‐shaped D vs. Δa curves are established and confirmed by comparison with experiment. The energy dissipation rate D vs. Δa is not a transferable property as it depends on geometry. The material characteristic R(Δa) may be the ‘transferable property’ for scaling problems in ELPL fracture. How it can be deduced from D vs. Δa curves (and by implication, J_R vs. Δa curves) is established.     

动力配煤高温复合固硫剂研究

分析了高温复合固硫剂各成分的作用，实验研究了在不同配比的燃烧试验下，各成分对燃煤着火和燃烧以及对炉渣固硫的影响，得出了该煤种高温复合固硫剂的最佳配方。     

云南东川泥石流沟与非泥石流沟~(137)Cs示踪法物源研究

运用1 37Cs示踪法调查云南东川小江流域 6条泥石流沟、6条非泥石流沟和主河的泥沙来源。泥沙主要来源于冲沟侵蚀和滑坡崩塌堆积、坡耕地和草地。坡耕地和草地表层土壤1 37Cs平均含量分别为 0 9Bq m2 和1 98Bq m2 ,冲沟沟壁和滑坡崩塌堆积土体1 37Cs。作者通过 3种源地土体1 37Cs含量的比较 ,分析了细粒泥沙(<0 0 1mm)的来源。 6条泥石流沟冲沟侵蚀和重力侵蚀 (滑坡崩塌 )的相对产沙量变化于 90 2 %～ 1 0 0 % ,平均值为 95 1 % ,6条非泥石流沟的相对产沙量变化于 74 5 %～ 83 3% ,平均值为 78 9%。小江主河为 81 4 %。     

Kinetics of DyNi2 film growth by electrochemical implantation

Electrochemical implantation was performed at Ni electrodes to form DyNi₂ films at 0.55 V (vs. Li⁺/Li), 0.62 V, and 0.70 V for 0.5-5.0 h in a molten LiCl-KCl-DyCl₃ (0.50 mol%) system at 700 K. It was found that the DyNi₂ films grew linearly with time with coulomb efficiency of about 100%. The obtained growth rates were higher at more negative potentials, i.e., 0.47 μm min⁻¹ at 0.55 V, 0.32 μm min⁻¹ at 0.62 V, and 0.14 μm min⁻¹ at 0.70 V. On the analogy of the metal oxide growth, the observed rapid and linear growth of DyNi₂ films may be explained by the existence of the outer and inner DyNi₂ layers.     

A kinetic model for the acid-oxygen pressure leaching of Ni–Cu matte

A semi-empirical mathematical model for the acid-oxygen pressure leaching of Ni–Cu matte is presented, based on data from batch leaching experiments. The primary controlling factor in the leaching process is found to be galvanic inhibition of the more highly oxidized copper and nickel sulfide species by less oxidized species, particularly Ni alloy and Ni₃S₂. The leaching rate of many species is greatly reduced by the presence of one or both of these phases, and others will not commence leaching until neither is present. The mathematical model is based on first-order chemical reaction controlled rate expressions, as the reactions occurring are electrochemical in nature. Mass transfer effects are included only empirically. Some possibly diffusion-related phenomena are noted, although the model is not extended to incorporate these effects on a fundamental level. The model is verified and extended by the inclusion of several different factors that were tested experimentally. The effects of variations in O₂ flow rate and partial pressure, initial particle size, reaction pulp density and initial acid concentration were all studied, and included in the model. Variations in O₂ flow rate and partial pressure are found to affect the reaction rates via the dissolved oxygen concentration in the solution phase.     

灞河生态治理工程模型试验研究

通过模型试验 ,对位于西安市东郊因采沙使河道破坏严重的灞河河段进行了复现试验和研究 ,并以此为依据 ,通过优化比较为设计部门提供了合理的橡胶坝坝址和坝座高程。在此基础上 ,又对建坝后橡胶坝对上下游冲淤变化的影响进行了试验研究和分析 ,解决了工程设计中的一些关键技术问题     

Lower bounds on the information rate of secret sharing schemes with homogeneous access structure

We present some new lower bounds on the optimal information rate and on the optimal average information rate of secret sharing schemes with homogeneous access structure. These bounds are found by using some covering constructions and a new parameter, the k-degree of a participant, that is introduced in this paper. Our bounds improve the previous ones in almost all cases.     

Bedload Transport in Alluvial Channels

Hydraulic, sediment, land-use, and rock-erosivity data of 22 alluvial streams were used to evaluate conditions of bedload transport and the performance of selected bedload-transport equations. Transport categories of transport-limited (TL), partially transport-limited (PTL), and supply-limited (SL) were identified by a semiquantitative approach that considers hydraulic constraints on sediment movement and the processes that control sediment availability at the basin scale. Equations by Parker et al. in 1982, Schoklitsch in 1962, and Meyer-Peter and Muller in 1948 adequately predicted sediment transport in channels with TL condition, whereas the equations of Bagnold in 1980, and Schoklitsch, in 1962, performed well for PTL and SL conditions. Overall, the equation of Schoklitsch predicted well the measured bedload data for eight of 22 streams, and the Bagnold equation predicted the measured data in seven streams.     

被动累积~(222)Rn-~(222)Rn探测器

本文采用 2只扩散杯 ,一只选择渗透率较大的滤膜 ,使2 2 2 Rn和2 2 0 Rn能很容易的进入。另一只选择渗透率较小的滤膜 ,该滤膜只允许2 2 2 Rn进入 ,半衰期较短的2 2 0 Rn被阻挡在外面。通过不同滤膜扩散率的差异 ,改变探测器的空气交换率 ,从而达到同时测量2 2 2 Rn和2 2 0 Rn的目的     

TEMIC射频卡的速率自适应读卡算法

提出种基于TEMIC射频卡Manchester编码的速率自适应读卡算法,并对该算法进行了说明和示例。