Two-level optimal output feedback stabilizer design

The paper addresses the design of two-level power system stabilizers using an optimal reduced order model whose state variables are torque angles and speeds. The reduced order model retains their physical meaning and is used to design a two-level linear feedback controller that takes into account the realities and constraints of electrical power systems. The two-level control strategy is used, and a global control signal is generated from the output variables to minimize the effect of interactions. The effectiveness of this controller is evaluated and a multimachine system is given as an example to illustrate the advantages of the proposed method. Responses of the system with a two-level scheme and an optimal reduced order scheme are included for comparative analysis.     

门式脚手架在已建高层建筑外装修中的应用

介绍门式脚手架在已建高层建筑外排栅中的整体搭设和应用实例。     

DG抗高温隔离液在古深1井的应用

古深1井是大庆油田在古龙地区的一口风险探井,设计井深5 500 m,实际完钻井深为4 739 m。钻进过程中,多次出现塌、漏、卡等事故,造成井径不规则。为平衡压力,压稳地层,更好地隔离钻井液和水泥浆,提高顶替效率,设计采用DG抗高温隔离液。DG抗高温隔离液抗高温可达150℃,密度调节范围宽,抗高温悬浮稳定性好,失水量少,与水泥浆和钻井液相容性好。古深1井采用双级注水泥工艺,固井施工过程十分顺利,隔离液密度均匀,泵送容易,无发泡现象。从声幅测井情况来看,水泥面上部与隔离液交界处界面清楚,水泥环胶结良好,水泥返高达到了设计要求,混浆过渡段短,固井质量合格。     

重油纳米化助燃效果研究与表征

将复配的分散剂加入重油中制备得到重油纳米颗粒，采用氧弹热值对比法对所研制的纳米化重油进行实验室评价。研究结果表明，纳米化后的重油燃烧性能得到了改善，在掺水量为3％～12％时，重油的燃烧效率提高了2．5％～6．1％。通过TEM观察，纳米化后的重油呈水包油（O／W）型乳液结构，油水界面清晰，界面膜较厚，乳化油粒径约为20～50nm，油水分散均匀，并且分散后的重油粘度增幅小，掺水量在15％以内，粘度增幅不超过20％，并且随着掺水量的增加，乳化重油的粘度逐渐减少。另外，乳化重油稳定性好，室温下至少可保存6个月，在80℃下存放3天未发生破乳现象。     

残留奥氏体对1500MPa级新型低碳Mn-Si-Cr系合金钢冲击韧度的影响

15 0 0MPa级无碳化物贝氏体 马氏体复相钢的第一类回火脆性开始温度高于 36 0℃。实验表明 ,这并非由于贝氏体 马氏体复相韧化 ,而是与无碳化物贝氏体中的膜状残留奥氏体有关。无碳化物贝氏体中机械稳定性较高的残留奥氏体可能是导致无碳化物贝氏体 马氏体复相钢第一类回火脆性开始温度升高的直接原因。     

关于成都膨胀土地区边坡稳定性的探讨

成都市三环路建设中 ,膨胀土边坡稳定性研究是大家关心的重要课题。膨胀土边坡土体中的吸力变化直接影响到其稳定性 ,参照“人工神经网络技术”中的吸力经验公式 ,以三环路东一B标段的路堤边坡为例 ,采用“条分法”进行预测分析 ,并有针对性地进行防护处理取得了较好的效果。     

加氢润滑油基础油光安定性研究进展

加氢处理基础油与溶剂精制基础油相比具有硫、氮含量低，颜色浅，粘度指数高，挥发性低，饱和烃含量高，对添加剂的感受性好等优点。但是，加氢处理润滑油基础油的一个明显缺点就是其光安定性差，即在有氧条件下通过光照（有时也需加热），油品颜色加深、透明度变差，继而有絮凝物或沉淀生成。文章综述了国内外有关加氢润滑油基础油光安定性的原因和解决办法的研究进展情况。     

The effect of additives on the thermal stability of poly(vinyl chloride)

The effect of a range of organic additives on the thermal stability of poly(vinyl chloride), both with and without a chloroparaffin extender, was studied using a number of experimental techniques. Of the additives used the best overall balance was provided by pentaerythritol, which increased stability when the extender was present and had no effect when it was absent. The congo red test emerged as the most suitable technique, being consistent and inexpensive and able to screen several additives simultaneously. Isothermal differential thermal analysis correlated with the congo red test but required more expensive equipment, was time-consuming and demanded good mixing of the poly(vinyl chloride) compound to give reproducible results. Thermogravimetry was not sufficiently sensitive and the heat stability test was the least useful of all.     

Stability Criteria of Underground Workings under Zonal Disintegration of Rocks

Using the energy approach as the base, the criteria are developed for brittle rock failure in outcropping in the workings driven in the rock masses of different degree of disturbance. A method is presented for estimating the stability of workings under conditions of zonal disintegration.     

注硼中子寿命测井注硼工艺优化设计

注硼中子寿命测井是一项水淹层测井新技术 ,对老油田的产层分析评价、剩余油含量估算等方面发挥了重要的作用。但测井施工时 ,往往由于注硼工艺不当导致硼酸的渗吸量难以准确反映地层可动水的含量 ,从而产生解释上的困难和误区。在渗流与扩散理论相结合的基础上 ,结合华北油田的施工实践 ,介绍了确定注硼管柱、硼酸用量、注硼压力以及硼酸扩散时间的基本原则和实际经验 ,为工艺的优化设计提供了一些方法与思路