含多孔物质硝胺发射药的温感特性

研究了多孔物质对于硝胺发射药在不同初温下的燃面调节作用，由于多孔物质的孔结构及其与基体界面状况的改变，使发射药低温燃面增大，而高温燃面减小，这有利于降低燃速温度系数．     

Ce,Eu双掺BSO晶体光折变效应研究

在ＢＳＯ晶体中同时掺入Ｃｅ和Ｅｕ离子，生长了Ｃｅ：Ｅｕ：ＢＳＯ晶体，对晶体的二波耦合和四波混频性能了测试。结果表明，Ｃｅ和Ｅｕ离子对晶体的光折变效应起到了增强的作用。     

Critical review of available correlations for two-phase flow heat transfer of ammonia

Although ammonia has been used for decades as a refrigerant of choice for selected large- and small-scale applications, no formal database is available on heat transfer of ammonia. A critical review of the published literature on heat transfer of ammonia is provided in this paper. The available correlations for in-tube and external boiling/evaporation and condensation heat transfer of ammonia are discussed and evaluated where possible. Supported by the findings of this effort, research areas of relevance that can contribute to expanded use of ammonia as an environmentally friendly refrigerant are suggested.     

Prediction of evaporation heat transfer coefficient and pressure drop of refrigerant mixtures

A study on the prediction of heat transfer coefficient (HTC) and pressure drop of refrigerant mixtures is reported. HTCs and pressure drops of prospective mixtures to replace R12 and R22 are predicted on the same cooling capacity basis. Results indicate that nucleate boiling is suppressed at qualities greater than 20.0% for all mixtures and evaporation becomes the main heat transfer mechanism. For the same capacity, some mixtures containing R32 and R152a show 8.0–10.0% increase in HTCs. Some mixtures with large volatility difference exhibit as much as 55.0% reduction compared with R12 and R22, caused by mass transfer resistance and property degradation due to mixing (32.0%) and reduced mass flow rates (23.0%). Other mixtures with moderate volatility difference exhibit 20.0–30.0% degradation due mainly to reduced mass flow rates. The overall impact of heat transfer degradation, however, is insignificant if major heat transfer resistance exists in the heat transfer fluid side (air system). If the resistance in the heat transfer fluid side is of the same order of magnitude as that on the refrigerant side (water system), considerable reduction in overall HTC of up to 20% is expected. A study of the effect of uncertainties in transport properties on heat transfer shows that transport properties of liquid affect heat transfer more than other properties. Uncertainty of 10.0% in transport properties causes a change of less than 6% in heat transfer prediction.     

Performance of absorption refrigeration cycle at maximum cooling rate

The influence of irreversibility of finite-rate heat transfer on the performance of an absorption refrigerator is investigated using an endoreversible cycle model with continuous flow. The cooling rate is adopted as an objective function for refrigerator optimization. The maximum cooling rate and the corresponding coefficient of performance are derived. The optimal performance with respect to heat transfer areas of the refrigerator is analysed. In addition, certain significant conclusions are reached.     

高功率CO2激光器换热性能的研究

高功率CO2气体激光器的换热性能好坏是器件长期稳定运行的关键环节之一。本文以板翅式热交换器为例阐明了热交换器的计算和设计方法。     

Radiation transmission through a composite pure water layer of uniform and depth-dependent extinction characteristics

The paper describes the calculation of the beam solar radiation transmission across the uniform salinity upper convecting zone (UCZ) and the salinity stratified gradient zone (GZ), when the extinction coefficient is not only wavelength but also salinity-concentration dependent, assuming that the effect of scattering to be negligible. The results are useful in determining the effects of dissolved salt ions on pure water transmission, at least according to the existing measured data in the literature.     

Investigation of the Interaction of Sodium Chloride and Two Amino Sulfonic Acids,HEPES and MOPSO,by EMF Measurements

Ionic interactions in the two systems NaCl-HEPES (N-2-hydroxyethylpiperazine-N′-2-ethanesulfonic acid) and NaCl-MOPSO (3-(N-Morpholino)-2-hydroxypropanesulfonic acid) have been studied in terms of their mutual influence on the respective activity coefficients of each component. Activity coefficients for each component of the two systems and for corresponding buffers are calculated from emf measurements of solutions containing NaCl, the aminosulfonic acid, and its conjugate base in a NalSE/solution/AgCl-Ag cell at 5, 15, 25, and 37 °C.     

Compact equivalent circuit model of two‐layer spiral inductors

A compact lumped‐element equivalent circuit model of two‐layer integrated spiral inductors on silicon substrates is developed in this article. Based on this proposed model, excellent agreements are achieved between the measured and simulated S‐parameters for different inductors. Also, both self‐ and mutual inductances of two‐layer inductors are accurately extracted, and their overall performances are understood clearly. © 2003 Wiley Periodicals, Inc. Int J RF and Microwave CAE 13: 148–153, 2003.     

Modeling of Moisture Behavior of Wood Planks in Nonvented Flat Roofs

A computer model was extended and adapted to simulate the hygrothermal behavior of building envelope-wood components. The model was used to predict moisture movement in wood planks forming the decks of nonvented flat roofs insulated with cellulose. The gradient of water potential was considered as the driving force for moisture movement in wood. The model required the determination of convective heat- and mass-transfer coefficients, the sorption curves, the effective water conductivity for different wood species, and the hygrothermal conditions within the assembly to characterize the mass-conservation equation. Once these parameters were integrated in the computer model, this approach was then validated by carrying a simulation of the drying process of wood planks using experimental data from a large-scale test.