Silicon Nitride Derived from an Organometallic Polymeric Precursor: Preparation and Characterization

Partially crystalline Si₃N₄, with nanosized crystals and a specific surface area greater than 200 m²/g, is obtained by pyrolysis of a commercially available vinylic polysilane in a stream of anhydrous NH₃ to 1000°C. This polymer does not contain N initially. Crystallization to high-purity α-Si₃N₄ proceeds with additional heating above 1400°C under N₂. The changes in crystallinity, powder morphology, infrared spectra, and elemental compositions, for samples annealed from 1000° to 1600°C under N₂, are consistent with an amorphous-to-crystalline transformation. Although macroscopic consolidation and local densification occur at 1400°C, volatilization and accompanying weight loss limit bulk densification. The effect of temperature on specific surface area is examined and related to the sintering process. These results are applicable to pyrolysis, decomposition, and crystallization studies of ceramics synthesized by polymeric precursor routes.     

An improved light attenuation technique for measuring large interfacial areas

A laser-based light attenuation technique was successfully used to measure interfacial areas as high as 5832 m²/m³ and Sauter mean bubble diameter varying between 50 and 5600 μm. Good agreement between this approach and the photographic technique was obtained particularly at low gas holdups.     

Surface Areas of Nitrated Hydrotalcites

Hydrotalcites in the nitrate form were prepared using microwave irradiation in the hydrotreatment step. The surface area (BET) of nitrated hydrotalcites was evaluated. Solids were characterized by atomic absorption, X-ray diffraction and BET analysis. Thermal pretreatment temperature determined the surface area of the hydrotalcites.     

大面积水域浓度场测试方法及系统研究

针对大面积水域浓度场难以实现实时测量、测量精度不高等问题,采用了一种多通道荧光测试系统和方法。首先,基于单色光诱导荧光检测浓度(LIF)原理,使用探头获取离散点的浓度参数。然后,经总线或通信网络技术,将数百个测点连接起来。最后,通过数据总线或网络将采集的数据输送到中央测控计算机中,处理离散的数据后形成完整的浓度场。在恒定流浓度场中的试验结果表明,污染物测量相对误差均值不超过5%,单次测量相对误差最高值为8.33%,传感器线性度不超过5%,可检测的荧光素钠溶液浓度分辨率为0.001 ppm,系统测量稳定、精度较高。相较于其他浓度测量方法,该系统具有测量面积大、实时测量的优势,可为水污染防治等领域提供可靠的技术支撑。     

Experimental Investigation of Epoxy Bonded Polymethylmethacrylate Joints

This paper presents an experimental investigation into various aspects of epoxy-bonded polymethylmethacrylate (PMMA) and PMMA-to-aluminium joints. The effects of adhesive thickness, overlap area, surface roughness, and environmental exposure on the joint strength were studied. Results indicated that the joint strength was not directly proportional to the overlap area, while sanding had a positive effect on the joint strength. A negative effect was observed when adhesive thickness was increased. The fatigue behaviour of adhesively-bonded joints under dynamic loading was found to be independent of frequency, for the range of values tested; however, it was dependent on the test temperature with greater reduction in fatigue life observed in PMMA-to-aluminium joints at higher temperature. Empirical equations from which the fatigue life of joints can be predicted were obtained by regression analysis. Intermittent fatigue testing of the joints was also performed. The epoxy adhesive tested proved to be a satisfactory choice for outdoor exposure. The rate of degradation of the adhesive was slow with the adherend itself degrading at a faster rate than the adhesive or the bondline.     

Carbon Aerogels as Electrode Material in Supercapacitors

Due to their large specific surface area and their high electrical conductivity carbon aerogels are promising materials for electrodes in electrochemical double-layer capacitors (supercapacitor). The carbon aerogels were made via pyrolysis of resorcinol formaldehyde aerogels. The latter were prepared by supercritical and subcritical drying as well. The important findings of our investigation were, that the highest capacities of 46 F/cm³ were measured for samples with a density of about 800 kg/m³ pyrolyzed at 800°C. Also it was shown that RF-gels with molar resorcinol/catalyst ratios 1000 or higher can be dried subcritically without cracking or significant shrinkage. Carbon aerogels derived from these RF-aerogels have a small mesopore surface area, however an especially large micropore area. They provide electrical capacities which are most suitable for their use in supercapacitors.     

Epileptic seizure classification in EEG signals using second-order difference plot of intrinsic mode functions

Epilepsy is a neurological disorder which is characterized by transient and unexpected electrical disturbance of the brain. The electroencephalogram (EEG) is a commonly used signal for detection of epileptic seizures. This paper presents a new method for classification of ictal and seizure-free EEG signals. The proposed method is based on the empirical mode decomposition (EMD) and the second-order difference plot (SODP). The EMD method decomposes an EEG signal into a set of symmetric and band-limited signals termed as intrinsic mode functions (IMFs). The SODP of IMFs provides elliptical structure. The 95% confidence ellipse area measured from the SODP of IMFs has been used as a feature in order to discriminate seizure-free EEG signals from the epileptic seizure EEG signals. The feature space obtained from the ellipse area parameters of two IMFs has been used for classification of ictal and seizure-free EEG signals using the artificial neural network (ANN) classifier. It has been shown that the feature space formed using ellipse area parameters of first and second IMFs has given good classification performance. Experimental results on EEG database available by the University of Bonn, Germany, are included to illustrate the effectiveness of the proposed method.     

无线体域网技术研究现状与展望

无线体域网(WBAN)技术是当前重要的研究热点,可以应用于医院内患者实时监测和家庭健康护理领域,具有广泛的应用前景和巨大的市场潜力。WBAN对设备的可穿戴性和数据传输的可靠性、安全性提出了更高的要求,技术发展中存在一些需要深入研究和解决的问题。对WBAN关键技术的研究现状和产业化进展进行了综述,并对WBAN技术的未来研究和发展前景进行了展望。     

风拖曳力系数和曼宁系数对风暴潮流模拟的影响

利用0205号威马逊台风期间实测风暴增水和风暴潮流数据,采用NCEP FNL和台风模型风场的融合风场作为驱动项,建立了覆盖东海的三维风暴潮流数值模型,研究风拖曳力系数和曼宁系数对风暴增水和风暴潮流的影响。计算结果表明:(1)风拖曳力系数取值应考虑随风速变化。表层风暴潮流受风拖曳力系数影响较大,中层和底层风暴潮流基本不受影响。(2)风暴潮流结构在一定程度上取决于曼宁系数;曼宁系数对中层和底层风暴潮流影响大于表层,曼宁系数越大,底摩擦阻力越大,风暴潮流垂向分层越明显。(3)风暴增水和风暴潮流对曼宁系数的响应不同,建立模型时,应同时率定风暴增水和风暴潮流。     

自重施加方式对高拱坝廊道结构应力及配筋的影响

自重工况一般是高拱坝内廊道配筋设计的控制工况,由于高拱坝施工过程的特殊性及复杂性,有限元计算中自重有多种施加方式。结合工程实例,对高拱坝基础廊道结构进行三维有限元分析,比较不同自重施加方式对廊道结构应力及配筋的影响。研究结果表明:按整体自重考虑时,廊道结构应力及配筋面积明显偏小;全部按分缝自重考虑时,廊道结构应力及配筋面积明显大于按施工过程考虑自重的结果;为符合实际施工过程及结构承载规律,保证结构安全及经济合理,在拱坝结构的有限元计算中应按照施工过程考虑自重荷载。该研究成果对泄洪孔结构的应力分析也具有参考价值。