Adaptive simulated annealing particle swarm optimization algorithm

Particle swarm optimization is widely used in various fields because of the few parameters to be set and the simple calculation structure.In order to improve the optimization speed and accuracy of the PSO,and to avoid falling into the local optimal solution,an adaptive simulated annealing PSO is proposed,which uses the hyperbolic tangent function to control the inertia weight factor for nonlinear adaptive changes,uses linear change strategies to control 2 learning factors,introduces the simulation annealing operation,set a temperature according to the initial state of the population,guide the population to accept the difference solution with a certain probability according to the Metropolis criterion,and ensure the ability to jump out of the local optimal solution.To verify the effect of the algorithm proposed in this paper,7 typical test functions and 5 algorithms proposed in the literature are selected for comparison and testing.According to the average value,standard deviation and number of iterations of the optimization results,the algorithm proposed in this paper has greatly improved the iteration accuracy,convergence speed and stability so as to overcome the shortcomings of particle swarm optimization.     

Continuous size fractionation of magnetic nanoparticles by using simulated moving bed chromatography

The size fractionation of magnetic nanoparticles is a technical problem, which until today can only be solved with great effort. Nevertheless, there is an important demand for nanoparticles with sharp size distributions, for example for medical technology or sensor technology. Using magnetic chromatography, we show a promising method for fractionation of magnetic nanoparticles with respect to their size and/or magnetic properties. This was achieved by passing magnetic nanoparticles through a packed bed of fine steel spheres with which they interact magnetically because single domain ferro-/ferrimagnetic nanoparticles show a spontaneous magnetization. Since the strength of this interaction is related to particle size, the principle is suitable for size fractionation. This concept was transferred into a continuous process in this work using a so-called simulated moving bed chromatography. Applying a suspension of magnetic nanoparticles within a size range from 20 to 120 nm, the process showed a separation sharpness of up to 0.52 with recovery rates of 100%. The continuous feed stream of magnetic nanoparticles could be fractionated with a space-time-yield of up to 5 mg/(L∙min). Due to the easy scalability of continuous chromatography, the process is a promising approach for the efficient fractionation of industrially relevant amounts of magnetic nanoparticles.     

Simulated Microgravity Inhibits the Proliferation of Chang Liver Cells by Attenuation of the Major Cell Cycle Regulators and Cytoskeletal Proteins

Simulated microgravity (SMG) induced the changes in cell proliferation and cytoskeleton organization, which plays an important factor in various cellular processes. The inhibition in cell cycle progression has been considered to be one of the main causes of proliferation inhibition in cells under SMG, but their mechanisms are still not fully understood. This study aimed to evaluate the effects of SMG on the proliferative ability and cytoskeleton changes of Chang Liver Cells (CCL-13). CCL-13 cells were induced SMG by 3D clinostat for 72 h, while the control group were treated in normal gravity at the same time. The results showed that SMG reduced CCL-13 cell proliferation by an increase in the number of CCL-13 cells in G0/G1 phase. This cell cycle phase arrest of CCL-13 cells was due to a downregulation of cell cycle-related proteins, such as cyclin A1 and A2, cyclin D1, and cyclin-dependent kinase 6 (Cdk6). SMG-exposed CCL-13 cells also exhibited a downregulation of α-tubulin 3 and β-actin which induced the cytoskeleton reorganization. These results suggested that the inhibited proliferation of SMG-exposed CCL-13 cells could be associate with the attenuation of major cell cycle regulators and main cytoskeletal proteins.     

陕北无定河流域土壤侵蚀与植被覆盖和降雨关系研究

基于2000—2014年陕北无定河流域日降水、DEM、土壤类型、MODIS NDVI等数据,利用修正通用土壤流失方程(RUSLE)估算了流域土壤侵蚀情况,定量分析了植被覆盖和降雨在土壤侵蚀中的作用,结果表明:(1)无定河流域土壤侵蚀以微度侵蚀为主,平均占流域面积的88.35%,各土壤侵蚀等级面积比例随等级的升高而降低。2000—2014年微度侵蚀面积比例为下降趋势,轻度及以上等级面积比例均为上升趋势。(2)不考虑降雨因子影响时,无定河流域仍以微度侵蚀为主,且为增加趋势,而其他土壤侵蚀等级均为下降趋势。不考虑植被覆盖因子时,流域土壤侵蚀与模型计算结果的变化趋势基本一致。(3)植被覆盖对土壤侵蚀面积比例和变化速率的贡献率分别为13.67%和24.55%,而降雨作用达到86.33%和75.44%,表明降雨是流域土壤侵蚀的主要动力和控制因子,降雨变化主导着流域土壤侵蚀变化过程。     

路径长度受限的随机需求VRP的模型和算法

路径长度受限的随机需求VRP在生产、生活中有着广泛的应用。给出了路径长度受限的随机需求VRP问题的线性整数规划模型,在不允许部分服务和仅能服务失败一次的策略下设计了一个启发式算法。该算法以离散优化中广泛应用的扫描算法为基础生成服务的一个初始可行方案,然后利用模拟退火算法改进得到近似最优解。对需求为二项分布的50个结点、1个服务中心的问题进行了数值试验,数值结果表明该算法对求解路径长度受限的随机需求VRP是有效的。     

烷烃中少量芳烃的固定床和模拟移动床吸附

在实验研究烷烃中少量芳烃的固定床吸附动态过程和模拟移动床吸附动态过程的基础上,用固定床和模拟移动床线性推动力模型进行了模拟计算,可得到如下结论:在本文的实验条件下,固定床吸附动态模型和模拟移动床吸附动态模型拟合的结果均与实验值相符;但从技术性能指标和技术经济指标两个角度都反映出对脱除烷烃中的少量芳烃的吸附分离过程,用固定床吸附过程比模拟移动床吸附过程更具有可行性。这些结果为在直链烷基苯的生产过程中,降低循环烷烃中芳构化物的含量,实现延长脱氢催化剂的寿命,提高烷基苯的产量提供了技术基础。     

一种检测单晶炉热场温度的新方法

为去除单晶炉热场温度测量信号中的低频干扰、提高温度信号的估计精度,本文提出了一种基于跨维模拟退火(trans dimensional simulated annealing,TDSA)的单晶炉热场温度检测方法.该方法首先将AIC(Akaike information criterion)信号个数判断准则纳入采样机制中以便对干扰个数采样估计,进而利用所设计的基于信号频谱和轮盘赌思想的Metropolis Hastings机制对相应个数的干扰频率进行采样,最后设计了混合均匀和高斯采样机制对单晶炉热场温度进行采样估计.仿真和单晶炉工程实验结果表明,该方法在干扰个数未知的情况下,能够有效地抑制低频干扰、准确检测单晶炉热场的温度.     

模糊控制器在窑炉温度控制系统中的应用及计算机仿真

对陶瓷工业窑炉中的温度模糊控制问题进行了探讨,提出了模糊控制器在窑炉温控上的具体应用方法,并进行了计算机仿真,仿真结果表明模糊控制效果良好,具有较好的应用前景。     

设计降雨特征对城市内涝模拟结果的影响分析

降雨是城市内涝的主要诱因之一,不同降雨特征对于城市内涝风险的影响也有所区别。为了进一步挖掘降雨特征对城市内涝风险的影响,采用综合流域排水模型（InfoWorks ICM）构建了我国南方某城市的内涝模型,系统分析了设计降雨的雨型和历时特征对城市内涝模拟结果的影响。在4个重现期的3种降雨雨型和3个降雨历时条件下,共计36个不同降雨情景对研究区的内涝情况进行模拟。通过对比不同模拟情景下的积水深度、积水面积以及积水量等结果发现：在相同降雨雨型和重现期条件下,降雨历时对积水深度的影响有一定的差别;在不同降雨雨型和降雨历时模拟情景中,积水点的位置基本保持一致,而积水面积受降雨雨型和降雨历时的双重影响;峰值积水量受降雨雨型影响较大,受降雨历时影响较小,而积水总量受降雨历时影响较大,受降雨雨型影响较小。研究中量化分析了不同设计降雨特征对城市内涝模拟结果的影响,旨在为合理地开展城市内涝预警以及应急管理等工作提供依据。     

北京市雨水收集利用蓄水池容积计算与分析

基于北京市1984—2013年的日降雨资料,以北京林业大学林业楼及其周边绿地为研究区,设置3种用水情景(冲厕、绿地灌溉及冲厕+绿地灌溉),采用连续模拟法,分别绘制3种用水情景下雨水收集利用工程的雨水截留率、自来水替代率、供水保证率以及效益费用比变化曲线,并通过综合分析这些曲线的变化特征确定雨水蓄水池最佳设计容积(60~82 m3)。同时采用设计暴雨法计算1~5年不同重现期的蓄水池设计容积(77~248 m3)。结果表明,连续模拟法计算过程相对复杂,但可用于综合衡量雨水收集利用工程的雨洪管理效益,以及缓解水资源短缺效益、供水可靠性及经济可行性分析。