Mechanism and Optimal Application of Chemical Additives for Accelerating Early Strength of Lime-flyash Stabilized Soils

1IntroductionLime-flyashstabilizedsoil as a semi-rigid base mate-rial in highwayis widely usedin China.The goodintegri-ty,great bearing capacity,highstiffness and water-proof-ing quality areits special advantages.But itsinherent lowearly strength makes it…     

老铁矿寻求新发展

云浮市铁矿是个老矿山，在资源减少、设备陈旧、成本增加和效益骤降等困境中，坚持走“一业为主，多种经营”的路子，在革新挖潜的同时，拓展工、商、贸及房地产业等多元化经营，使老矿山旧貌换新颜，多种经营收益已超过矿山总收益的30％。     

Electrochemical Aspects of Electroosmotic Dewatering of Clay Suspensions

An attempt is made to elucidate the electrochemical aspects of the electroosmotic dewatering (EOD) of clays as reported in some recent work, especially that on interrupted DC power electroosmotic dewatering published by Rabie, Mujumdar and Weber (2). These authors showed that the dewatering by EOD stops after the DC power has been on for several minutes or hours; on interruption of their power and on short-circuiting of the electrodes, conditions can be created again for some further dewatering by DC power EOD. This discovery, of Rabie et al. is interpreted as a fuel cell effect and it is shown that it affords clues to several other electrochemical strategies for the possible enhancement of the efficiency of the EOD by DC power.

Further, the open circuit potentials observed by Rabie et al. (2) on the interruption of DC power are given an electrochemical interpretation which leads to quantitative estimates in agreement with the experimental values.     

Preparation and Properties of Sintering Additives Coated Si3N4 from Heterogeneous Nucleation Processing

The sintering additives such as Al2O3 and /or Y2O3 were coated on the surfaces of Si3N4 particles via heterogeneous nucleation processing using a buffered pH solution as the precipitation reagent .They nucleated and grew only on the surfaces of Si3N4 and did not form sol particles in solution by TEM observation .The isoelectric point(IEP) of coated Si3N4 was different from that of as-received Si3N4.The IEP of Al(OH)3-coated Si3N4 occurred at pH8.4, which is close to that of alumina .When Al(OH)3-coated Si3N4 particles were coated with Y(OH)3,the IEP of coated Si3N4 powder shifted from pH8.4 to pH9.2 ,similar to that of yttria.In addition ,the rheological data showed that Al2O3 and /or Y2O3 coated Si3N4 suspension is nearly Newtonian and that added Si3N4 suspension shows a shear rate thinning behavior.     

双重孔隙介质油藏中的吸渗排油作用

利用美国SSI公司研制的COMPN模拟软件对双重孔隙介质油藏一种重要的开采机理 吸渗排油进行了模拟研究,考察了一个基质岩块为四周裂缝所包围时.在驱动压力和毛管压力的不同平衡(驱动压力和毛管压力的相对大小)关系下的水驱油采收率和水驱油效率的变化规律.     

一种新型基于石英的热光型光开关

一种采用基于石英的平面光波回路技术（PLC）制造的热光型光开关正越来越引起关注，它具有低耦合损耗、高稳定性及适于大规模集成等优点。首先描述了采用热光相移器构成马赫-曾德于涉仪（MZI）结构的热光型光开关，然后讨论2×2MZI热光型开关的工作原理及基本特性，最后介绍了由2×2MZI热光型开关单元构成的大规模光开关阵列以及一种采用悬梁式结构热光相移器的低功率消耗的光开关。     

起重机吊钩拖动绕线电动机他励双高调速系统

本文提出励磁电流可自动控制的他励式双高调速系统设计方案。系统在提升特别是在下放重物时，具有较硬的机械性；在负载１０－１００％的变化范围内，可实现最大偏差Δｎｍａｘ／ｎｍｉｎ１００％≤１０％，调速范围Ｄ≥１０；在满载运行条件下，可节约电能８０％以上。     

The effect of particle distribution on damage formation in particulate reinforced metal matrix composites deformed in compression

Image analysis results are reported on the generation of damage in particulate reinforced metal matrix composites during compressive deformation. The technique allows the automated collection of data on the incidence of particle fracture and void formation in the matrix as a function of important microstructural parameters such as local particle volume fraction and particle size. There is a strong relationship between damage and the local volume fraction of the reinforcement proving that damage formation is accentuated in regions of particle clustering. With the SiC reinforced materials examined, there was observed to be a change in dominance of damage mechanism from particle fracture at low local volume fractions to void formation in the matrix within strongly clustered regions. The results are compared with finite element (FE) modelling of the compressive deformation of clustered particles using a simple cluster of equi-spaced particles. The FE results suggest that plastic flow is generally inhibited in clustered regions. In certain highly clustered configurations shielding is such that flow does not occur in the heart of the cluster even at high levels of average plastic strain. The modelling suggests that the change in dominance of damage mechanism is related to the dramatic increase in tensile hydrostatic stresses in the matrix with higher levels of particle clustering.     

两种不同界面结合强度碳/铝复合材料的内耗特性

本文研究了两种不同界面结合强度的碳/铝复合材料经不同次数加载热循环处理后的内耗值及内耗机制。弱界面结合的C/L2复合材料的内耗值变化主要由界面脱粘引起,而强界面结合的C/LD2复合材料的内耗值变化主要由位错运动所致。     

Li2O在保护渣中的作用

采用在不同玻璃性的两种基渣中加入Ｌｉ２Ｏ为研究Ｌｉ２Ｏ对保护渣粘度，熔化温度及玻璃性能的影响，并对Ｌｉ２Ｏ改善保护渣玻璃性的机理进行了探讨，提出了寻找高速连铸保护渣中Ｌｉ２Ｏ的代用物的一种方法。