有关烧结部件表面问题的几个案例

烧结钢部件在生产过程中，尤其是烧结之后其表面有时会出现针孔、孔洞及斑痕等缺陷。本文结合PM生产的实际过程，总结了影响部件表面问题的各种因素，并举例分析如何诊断各种不同的表面问题及其解决方案。     

聚乙烯吡咯烷酮对酸诱导液相沉积体系中GeO_2颗粒形貌的影响

在室温下,通过酸诱导液相沉积的方法,制备出了二氧化锗(GeO2)颗粒。制得的GeO2颗粒通过扫描电子显微镜(SEM),透射电子显微镜(TEM)和X射线衍射(XRD)进行表征。实验结果表明,向前驱液中加入酸,可以诱导锗酸根离子转化成立方体型的GeO2颗粒析出。而向反应液中再加入少量的聚乙烯吡咯烷酮(PVP)后,会析出纺锤体型的GeO2晶体颗粒。     

原位合成SiC对铝基复合材料微观组织和力学性能的影响

以铝粉、硅粉、石墨粉为原料, 通过冷压真空烧结原位合成了含不同质量分数SiC颗粒的SiC/Al-18Si复合材料。利用X射线衍射仪, 扫描电子显微镜和能谱分析仪等设备手段表征了铝基复合材料的相组成和微观结构, 研究了原位合成SiC对复合材料微观结构、抗弯强度和显微硬度的影响, 分析了复合材料力学性能的变化规律。结果表明: 复合材料的基体相为Al相, 第二相为Si相和SiC相; 原位合成的SiC颗粒弥散细小的分布在Al基体中, 其颗粒尺寸主要分布在0.2~2.8 μm, 具有亚微米、微米级的多尺度特性; 随着SiC质量分数的不断增加, 复合材料的显微硬度增大, 同时颗粒的平均尺寸仅由0.81 μm增大到1.13 μm, 但仍均匀分布, 正是这种尺寸稳定性, 使得SiC/Al-18Si复合材料硬度远大于Al-18Si; 当SiC质量分数为30%时, 材料的显微硬度最高, 达到HV 134, 相较于Al-18Si提高了88%。     

化学气相沉积包覆燃料颗粒ZrC涂层的模拟计算

ZrC涂层是高温气冷堆包覆燃料颗粒最具潜力的一种阻挡层材料。本文利用热力学软件HSC-Chemistry5.0对化学气相沉积ZrC涂层进行模拟计算。结果表明,化学气相沉积ZrC涂层较佳工艺参数范围如下：原料气体中C/Zr比为0.5～1.5,H₂/Ar比为0.5～1.5,沉积温度为1450～1650℃。     

碳对铁及其合金超细微粒氧化特征的影响

采用ＣＯ２激光诱导Ｆｅ（ＣＯ）５－Ｃ２Ｈ４－ＮＨ３的气相分解反应制备了Ｆｅ、Ｆｅ－Ｎ和Ｆｅ－Ｃ－Ｎ超细微粒（微粒直径小于１００ｎｍ）,用透射电子显微镜、Ｘ光衍射、Ｏ／Ｎ和Ｃ／Ｓ测试仪及振动样品磁强计等研究了微粒的结构、表面形态、表面氧的状态及磁性能等;探讨了碳对微粒的氧化特征,特别是对微粒表面氧的形态及其磁性能的影响。结果表明,微粒表面氧的状态可分为吸附态和化合态,并且二者的含量随着微粒的种类不同而变化,碳对微粒表面氧的存在状态、微粒的氧化状况及磁性能具有决定性的影响     

Fe-Ni-Si基奥氏体时效合金的马氏体相变和形状记忆效应

It is well known that the morphologies of the α martensite formed from the γ phase in ferrous alloys are classified into five types of lath, butterfly, (225)A type plate,lenticular and thin-plate. Among those α martensites, onlythe thinplate martensite, which is characterized by containing a high density of transformation twins, has a potential of exhibiting a perfect shape memory (SM) effect.Recently the present authors found in Fe-Ni-Si alloys that the thin-plate martensite is formed by the introduction of fine and coherent γ-(Ni,Fe)3Si particles with a L12 ordered structure in the austenite matrix due to ausaging. In the present study, the SM properties of the ausaged Fe-Ni-Si alloys with the thin-plate martensite are investigated by a conventional bending-test. The effects of the addition of Co to the Fe-Ni-Si alloys on the martensitic transformation and the SM properties are also investigated. It is shown that while the ausaged Fe-Ni-Si ternary alloys exhibit an imperfect SM effect due to reverse transformation from stress-induced thin-plate martensite to austenite, the SM properties are improved by the addition of Co. An almost perfect SM effect is confirmed in the Fe-Ni-Si-Co alloys by heating to 1 100 ℃ after deformation at -196 ℃.     

TiO2／SnO2超微粒及其复合LB膜的紫外—可见光吸收光谱的研究

用胶体化学方法制备ＴｉＯ２／ＳｎＯ２超微粒,ＴｉＯ２／ＳｎＯ２超微粒及其复合ＬＢ膜的紫外－可见光吸收光谱研究表明：ＴｉＯ２／ＳｎＯ２超微粒具有量子尺寸效应使吸收光谱发生“蓝移”;ＴｉＯ２／ＳｎＯ２超微粒／硬脂酸复合ＬＢ膜具有良好的抗紫外性能和光学透过性能。     

P(MMA-AN)/TiO2复合粒子的制备及光催化性能

采用原位乳液聚合方法制备了基于共价键结合的P(MMA-AN)/TiO2复合粒子,红外光谱和热失重分析结果表明P(MMA-AN)在TiO2表面接枝率为15.9%。以甲基橙溶液为目标污染物,研究了P(MMA-AN)/TiO2复合粒子和TiO2对甲基橙的吸附和光催化降解甲基橙溶液的性能,结果表明:两种粒子对甲基橙的吸附都很少;在相同时间内,P(MMA-AN)/TiO2复合粒子对甲基橙溶液的降解性能优于TiO2,紫外光照180 min后,P(MMA-AN)/TiO2复合粒子对甲基橙溶液的降解率达到了88%,而TiO2仅为74%。     

The Use of Distinctive Monoclonal Antibodies in FMD VLP- and P1-Based Blocking ELISA for the Seromonitoring of Vaccinated Swine

The serum neutralization (SN) test has been regarded as the “gold standard” for seroconversion following foot-and-mouth disease virus (FMDV) vaccination, although a high-level biosafety laboratory is necessary. ELISA is one alternative, and its format is constantly being improved. For instance, standard polyclonal antisera have been replaced by monoclonal antibodies (MAbs) for catching and detecting antibodies, and inactive viruses have been replaced by virus-like particles (VLPs). To the best of current knowledge, however, no researchers have evaluated the performances of different MAbs as tracers. In previous studies, we successfully identified site 1 and site 2 MAbs Q10E and P11A. In this study, following the established screening platform, the VLPs of putative escape mutants from sites 1 to 5 were expressed and used to demonstrate that S11B is a site 3 MAb. Additionally, the vulnerability of VLPs prompted us to assess another diagnostic antigen: unprocessed polyprotein P1. Therefore, we established and evaluated the performance of blocking ELISA (bELISA) systems based on VLPs and P1, pairing them with Q10E, P11A, S11B, and the non-neutralizing TSG MAb as tracers. The results indicated that the VLP paired with S11B demonstrated the highest correlation with the SN titers (R² = 0.8071, n = 63). Excluding weakly positive serum samples (SN = 16–32, n = 14), the sensitivity and specificity were 95.65% and 96.15% (kappa = 0.92), respectively. Additionally, the P1 pairing with Q10E also demonstrated a high correlation (R² = 0.768). We also discovered that these four antibodies had steric effects on one another to varying degrees, despite recognizing distinct antigenic sites. This finding indicated that MAbs as tracers could not accurately detect specific antibodies, possibly because MAbs are bulky compared to a protomeric unit. However, our results still provide convincing support for the application of two pairs of bELISA systems: VLP:S11B-HRP and P1:Q10E-HRP.