The distribution of nutrient elements in cell wall and other fractions of the herbage of some grasses and legumes

The distribution of 10 nutrient elements was assessed in three fractions of herbage samples of perennial ryegrass, tall fescue, white clover and lucerne. The cell wall fraction, prepared by mechanical disintegration of undried material, contained the following proportions of the total herbage content of the major elements: N, 2.9–16.4%; P, 3.0–6.9%; S, 3.6–17.2%; Ca, 11.3–51.8%; Mg. 6.4–27.6% and K, 0.1–1.7%. Substantial though more variable proportions of the trace element cations, Fe, Mn, Zn and Cu were also present in the cell wall fraction. The extent to which the elements were soluble in water was assessed by analysis of the water-insoluble fraction prepared from freeze-dried samples of each herbage. The proportions of the total herbage content of the major elements soluble in water were: N, 30–57%; P, 80–92%; S, 35–71%; Ca, 48–69%; Mg. 65–83% and K, 90–96%. With the trace element cations the proportions soluble in water were more variable, though they were generally less than 70% of the total. The extent to which the various elements were soluble in 80% aqueous ethanol was assessed by analysis of the insoluble fraction prepared from freeze-dried materials. With each of the major elements, smaller proportions of the total herbage content were soluble in 80% ethanol than in water, which may reflect in part the lower solubility of proteins and pectin. With the trace element cations, the differences in solubility between 80% ethanol and water were generally small and inconsistent.     

景电高扬程灌区水价改革实践及思考

水价是水商品价值的体现。由于多方面的原因，水价改革的进程与水商品生产经营的市场化供求关系还不相适应，致使现行水价不能体现水资源的市场需求价值。回顾总结景电灌区水价调整改革的实践，可以为西北高扬程灌区水价改革提供借鉴。     

微量Si在W—7Ni—3Fe重合金中的行为

研究了掺到原料Ｗ粉中微量Ｓｉ（４００ｐｐｍ）在Ｗ－７Ｎｉ－３Ｆｅ重合金中的分布及在液相烧结过程中的行为。结果表明，Ｓｉ主要以固溶形式分布在Ｗ晶粒中。Ｘ射线光电子能谱（ＸＰＳ）分析发现，在掺杂Ｓｉ的Ｗ－Ｗ及Ｗ－基体相界面富集ＳｉＯ２和Ｎａ２ＳｉＯ３在未掺杂试样的断口表面发现了较弱的ＷＯ２的ＸＰＳ谱，而在掺杂合金中未发现ＷＯ２。     

滴灌系统叠片过滤器离散型流道结构水力性能试验及内部流场模拟

为获得叠片流道内部水流流动特性,解决叠片过滤器水头损失较大的弊端,通过室内试验对比了传统叠片过滤器和具有离散型流道结构的叠片过滤器在不同流量下的水头损失,并采用Fluent19.0对清水条件下2种不同流道结构叠片过滤器内部流场分布规律进行数值模拟。结果表明:流道内部流量模拟值与试验设定值最大相对误差为4.8%;随着流量的增大,传统叠片过滤器产生的水头损失更为明显,与传统叠片过滤器相比,离散型流道叠片过滤器产生的水头损失在最大流量下降幅为20.8%;对不同流道进行内部流场分析,得出同一流量下离散型流道的平均过流断面面积大于直线型流道,过流断面面积越大,则流速越小,水头损失也越小,离散型流道内部局部水头损失占主导地位,凸台的离散排列降低了沿程水头损失。研究结果可为叠片流道的设计和结构优化提供参考。     

宁夏汉延渠灌区灌溉水利用系数测算分析与评价

农田灌溉水利用系数表示从水源引水被农作物吸收利用的过程,是反应灌区灌溉用水效率的一项指标。本文以汉延渠灌区为例,综合考虑宁夏的气候环境、土壤类型、灌溉制度及作物种植结构等因素,选取典型渠段和样点灌区,分别采用"连乘法"和"首尾法"计算宁夏汉延渠灌区2018—2019年的灌溉水利用系数,并对其进行对比分析评价,从而确定灌区适宜的计算方法。     

Screening model for assessing ‘cost’ of minimum flow requirements in the Svartå River,Sweden

The minimum flow requirements in the Svartå River in Sweden are directed at maintaining fishlife and providing suitable dilution for waste flows. The implications of varying the minimum flow requirements in the river are examined using a mixed integer optimisation model. The model is formulated as a modified method-of-weights technique with the economic issues of hydro-electricity generation, irrigation and urban water supply placed in the objective function and the minimum flows specified within the constraint set. The integer component of the model is required to model the operating policy at the major flow regulation facility in the system and the restricted validity of the irrigation permits. Application of the model shows that in dry years where competition between minimum flow levels and the other economic uses, is most intense, the levels achieved by the various economic objectives are only slightly reduced even with significant increases in the minimum flow requirements. Variations in minimum flow requirements of up to 45% only produce changes of 10% or less in the economic objectives. The lack of sensitivity of the objective levels is due primarily to the level of control exerted indirectly on the whole system in dry years by the release regulation policy and the restricted validity of the irrigation permits. In normal to wet years these policies are not as restrictive and more choice is available. In such years, however, there is generally sufficient water to satisfy all requirements and allocation is not a critical issue. The model itself is formulated generally so that a range of scenarios beyond those examined specifically in the paper can be considered.     

深海声速剖面对吊放声纳探测距离的影响研究

关于深海环境下声纳目标探测优化问题,针对传统吊放声纳的下放深度比较粗略,一般是在声道轴处上下一定的范围,并考虑目标可能的深度。简单地确定声纳探测深度,会严重减小声纳的有效搜索距离和搜索范围。利用射线模型仿真研究了深海中不同的声速剖面对吊放声纳探测距离的影响。通过分析深海不同声速剖面中的声传播特性,并对声纳、水声环境以及目标的模型化计算,利用射线模型仿真了几种不同声速剖面情况下吊放声纳的主动作用距离,最后分析了吊放声纳入水深度对深海目标主动作用距离的影响。仿真结果表明,改进方法可找到最佳的探测深度,并能够发挥声纳对目标探测性能,得到对不同环境下目标的最好探测。     

赣西浒坑钨矿床成矿岩体的磷灰石和锆石微量元素特征及其对成岩成矿的指示

赣西地区浒坑钨矿是我国华南钨、锡、铜多金属成矿区与中生代岩浆活动密切相关的典型矿床之一。对浒坑钨矿床中与成矿有关的白云母花岗岩开展了锆石U-Pb定年、磷灰石和锆石原位微量元素研究,结果表明：赋矿白云母花岗岩的成岩时代为（152.3±1.73）Ma;磷灰石具有特殊的“M”型REE球粒陨石标准化配分模式,富F和Mn,贫Cl和Mg;锆石具有高Th/U比值,REE球粒陨石标准化配分模式亏损LREE、富集HREE。锆石微量元素（Ce、U和Ti）温度计和氧逸度计结果表明,锆石形成于岩浆早期高温（800 ℃）和低氧逸度条件下。研究认为,浒坑赋矿花岗岩在演化初期经历了强烈的矿物结晶分异,矿床的形成可能与还原性高分异岩浆演化相关。     

Quantification of trace amounts of impurities in high purity cobalt by high resolution inductively coupled plasma mass spectrometry

An analytical method using high resolution inductively coupled plasma mass spectrometry (HR-ICP-MS) for rapid simultaneous determination of 24 elements (Be, Mg, Al, Ti, V, Cr, Mn, Fe, Ni, Cu, Zn, Ga, Ge, As, Se, Mo, Ag, Cd, Sn, Sb, Ba, Pt, Au, and Pb) in high purity cobalt was described. Sample digestions were performed in closed microwave vessels using HNO3 and HCl. The matrix effects because of the presence of excess HCl and Co were evaluated. The usefulness of high mass resolution for overcoming some spectral interference was demonstrated. The optimum conditions for the deter- mination were tested and discussed. The standard addition method was employed for quantitative analysis. The detection limits were 0.016-1.50 μg?g?1, the recovery ratios were 92.2%-111.2%, and the RSD was less than 3.6%. The method was accurate, quick, and convenient. It was applied to the determination of trace impurities in high purity cobalt with satisfactory results.     

金属材料中微量氢和氧的分析

叙述了惰性气氛熔化法测定金属材料中微量氢和氧的条件和方法。着重研究影响分析限的空白因素及降低空白的方法和分析限，制定出了Ｔｉ，Ｚｒ，Ｈｆ，Ｔａ，Ｎｂ，Ｗ，Ｍｏ，Ａｌ，Ｃｕ等及其合金中微量氢和氧的分析方法。