利用微波介电加热和微波干燥水解法制备TiO2微粒

利用微波介电加热和微波干燥条件下TiCl4直接水解的方法制备出平均尺寸为40m，粒径分布窄，均为球形且形态均一，团聚较少，金红石型的TiO2纳米粒子，其内部品粒平均大小为17nm。而传统加热和干燥条件下形成的纳米微粒平均为60nm，粒经大小不均一，形态较不规则，团聚严重。微波加热和干燥方法具有清洁、快速均匀高效、环境友好的优点，推广前景良好。TiCl4水解法经济便利，适于工业化生产。     

严重非均质油藏高渗条带的识别方法

胡状集油田属于严重非均质油藏,在注水开发后表现为油井见效快、含水上升快,并且很快在注采井间形成高渗条带,影响开发效果。如何对高渗条带识别,成为改善严重非均质油藏开发效果的关键。本文通过沉积微相法、测井评价方法、示踪剂监测分析法、动态分析法等多种方法,开展对高渗条带识别的研究,为下步措施安排提供了可靠的调整依据。     

High solids content emulsions. III. Synthesis of concentrated latices by classic emulsion polymerization

Two different methods of producing bi‐ and trimodal latices of a mixture of methyl methacrylate, butyl acrylate, and small amounts of acrylic acid were tested. It is shown that a combination of concentrating blends of seed particles by semibatch reaction, followed by a nucleation of small particles plus a second semibatch phase allowed us to obtain stable latices with solids contents over 65% and viscosities of below 2500 mPa s^?1 with little coagulum formation. The key parameter in determining latex stability, coagulum formation, and viscosity appears to be the the particle size distribution, and especially its modification attributed to secondary nucleation. Because it is not possible to eliminate water‐soluble monomers from the polymerization recipe, secondary (homogeneous) nucleation must be minimized by careful addition of the free‐radical initiator and choice of monomer feed flow rates. The nucleation of the third population in the trimodal latices is best accomplished with a mixed surfactant system because renucleation by anionic surfactant alone leads to detrimental changes in the particle size distribution (PSD) resulting from excessive flocculation of particles. In addition, it was found that the viscosity of the final products was not sensitive to small changes in the ionic strength of the latex, although neutralization to a pH of 6 effectively doubles the final latex viscosity. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 1916–1934, 2002; DOI 10.1002/app.10513     

Elucidation of the miniemulsion stabilization mechanism and polymerization kinetics

Styrene/hexadecane miniemulsions were polymerized at 50°C using a redox initiator. The miniemulsions and their corresponding latexes were characterized in terms of size, polymerization rate, and surface properties. The resulting data were analyzed to elucidate the miniemulsion stabilization and polymerization mechanisms. It was found that the free surfactant concentration exceeded the critical micelle concentration when large amounts of surfactant (60 mM sodium lauryl sulfate) were used, resulting in simultaneous micellar and droplet nucleation. Most surfactant was on the surface of the droplets (85%) or particles (95%). The fractional surface coverage was proportional to the surfactant concentration to the 0.55 power. Using a particle diameter equation, the number of particles was calculated to be proportional to the surfactant concentration to the 1.35 power. Through direct particle size measurements, a power of 1.38 was confirmed. The rate of polymerization was determined by reaction calorimetry to be proportional to the number of particles to the 0.59 power, in contrast to classical Smith–Ewart kinetics for conventional emulsions (1.0 power). The average number of radicals per particle was estimated from the rate and number data, and varied with the particle diameter to the 0.97 power. The observed kinetic dependencies were validated through an extension of Smith–Ewart theory. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 3987–3993, 2003     

大颗粒煤燃烧传递动力学破碎理论模型

研究了大颗粒煤燃烧中的颗粒破碎现象，理论分析了大颗粒煤的着火过程和颗粒破碎过程，建立了大颗粒煤燃烧传递动力学破碎模型，对褐煤、烟煤和无烟煤三个典型煤种进行了燃烧初期数值模拟，指出了大颗粒煤燃烧时着火和颗粒破碎的内在联系。     

Interaction of inositol phosphate with calcite

The interaction of myo-inositol hexaphosphate with calcite was studied to evaluate the adsorption mechanisms and the electrochemical modifications induced by interaction of a molecule at such a high-charge density. In addition to quantitative information through the construction of adsorption isotherms, FT-IR and Laser Doppler Velocimetry - Photon Correlation Spectroscopy (LDV-PCS) were employed to investigate the nature of the adsorbent-adsorbate bonds and to determine the electrophoretic mobility and size of the particles before and after sorption. The experiments were also run with orthophosphate (Pi) for comparison. The amount of sorbed P increased to reach a plateau at 17.8 mol m^-2 for inositol hexaphosphate (IHP) while for Pi rose 1.4 mol m^-2 but at C_e > 610^-4 M it had a sharp increase reaching 155 mol m^-2. As expected, for Pi, adsorption predominated up Ce 610^-4 M by covering about 20% of total surface. The adsorption occurred at sites that behaved as nucleus of formation of the clustering of Ca- and PO₄-ions with the ending formation of calcium phosphate precipitates at C_e higher than 610^-4 M. The reaction of inositol hexaphosphate with calcite involves, besides adsorption, precipitation of Ca salts and hence calcite dissolution also at the lowest added IHP concentrations, accounting for the large amount retained by calcite. Sorption of IHP on calcite caused aggregation of particles at low concentrations followed by an increase of their negative charge and hence re-dispersion at higher concentrations. These results indicate a great IHP-fixing capacity of calcite that can affect its accumulation in soils and P bioavailability, and a considerable change of calcite electrochemical properties and particle size distribution that can modify aggregate stability.     

基于改进粒子群优化算法的BP神经网络在大坝变形分析中的应用

BP神经网络以其对非线性系统的强大映射能力而被广泛应用于模糊性、随机性强的大坝变形预测分析中。传统的BP神经网络由于初始权值和阈值的随机性,容易导致网络在训练过程中极易陷入局部最小值,同时存在网络收敛速度慢等缺点。针对传统算法的不足,采用改进的粒子群算法(IPSO)对BP网络的初始权值和阈值给予优化,建立大坝变形预测的IPSO-BP模型,并与PSO-BP网络模型进行对比。结果表明,改进的IPSO-BP模型具有收敛速度更快、预测精度更高的优点。该方法可供大坝安全监测和预警分析参考。     

采用复合分散剂制备高表观密度聚氯乙烯树脂

介绍了高醇解度、高粘度聚乙烯醇 6 35与分散能力较强的其它分散剂按一定配比复合后的使用情况 ,结果表明 :采用复合分散剂 ,可在保持PVC树脂具有适当孔隙率的前提下 ,提高其表观密度 ;采用KH2 0 /6 0SH5 0复合分散剂在 10L釜中制得的PVC树脂表观密度约为 0 .4 6g/mL ;采用 6 35 /B72或 6 35 /F5 0复合分散剂制得PVC树脂的表观密度可比采用通用分散体系提高 10 %～ 15 % ,且水油比减少 ,增塑剂吸收量提高。分析了影响树脂表观密度和颗粒形态的主要因素     

流行性出血热病毒在地鼠肾细胞中增殖动态的形态学及形态发生学研究

用普通电镜及免疫电镜对流行性出血热病毒(EHFV)不同毒株感染地鼠肾细胞(GHKC)的形态及形态发生学特点、其特征性包含体的形态及感染细胞超微结构的改变,以及感染后不同天数的病毒增殖动态进行了观察。     

生物活性无机颗粒增强聚乳酸材料的制备方法

无机颗粒增强聚乳酸复合材料能有效的改善聚乳酸的力学性能，并赋予其生物活性。本文系统介绍了各种无机颗粒增强聚乳酸复合材料的制备方法，并对其优劣性进行了初步探讨。