铍材应力常数的X射线法测试

在X2001应力分析仪上采用悬臂梁加载法测试了可以用于铍的X射线应力测试的5个衍射晶面的应力常数。结果表明,铍的5个衍射晶面的应力常数差异较大，在进行X射线应力分析时．应采用相应衍射晶面的应力常数，才能获得准确的应力分析结果。由于X射线对铍有较大的穿透深度，必须考虑X射线穿透深度对应力常数标定的影响。     

基于局部线性嵌入和支持向量机回归的TBM施工参数预测

依托吉林引松工程开展隧道掘进机（TBM）施工参数预测研究,提出TBM施工数据分段提取算法,提取上升段前30 s的总推进力、刀盘转速、推进速度、刀盘扭矩、刀盘转速电位器设定值、推进速度电位器设定值、贯入度、贯入度指数(FPI)、扭矩切深指数(TPI)9个参数作为输入;通过局部线性嵌入（LLE）完成对上升段数据特征的降维;基于支持向量机回归（SVR）建立TBM施工控制参数（推进速度、刀盘转速）和负载参数（总推进力、刀盘扭矩）预测模型. 分析是否结合前一掘进循环的FPI、TPI指数进行预测对预测效果的影响. 结果表明,上述方法在推进速度、刀盘转速、总推进力、刀盘扭矩的预测中均取得了较好的预测效果,平均预测绝对百分比误差均小于15%,验证了该预测方法的有效性,该方法可以为TBM现场施工提供指导.     

公路隧道钢筋混凝土衬砌碳化耐久性区划

为了构建公路隧道衬砌碳化耐久性的定量设计方法,对比各碳化深度计算模型与实测数据,选定衬砌碳化的最优模型;根据实测数据分析隧道环境温湿度与洞外大气关系,基于全国气象监测站的温湿度数据,建立公路隧道运营环境温湿度区划;考虑公路隧道CO₂的释放源项并参照实测数据,构建隧道运营环境CO₂体积分数的计算方法;以碳化劣化速率梯度相等为原则,对我国隧道碳化环境进行分区,结合分区推荐我国公路隧道衬砌碳化耐久性定量设计的具体方法. 研究发现：隧道环境湿度与大气湿度相当,隧道环境温度变化趋势与大气环境一致,两者均值接近. 公路隧道内部CO₂体积分数与CO体积分数呈线性关系. 云南、贵州区修建的隧道工程衬砌受环境影响较大,西藏、青海、内蒙古、黑龙江、吉林等地区的待建隧道在进行衬砌耐久性设计时可以忽略碳化影响,其余全国大面积区域隧道衬砌的碳化耐久性设计可以对应《混凝土结构耐久性设计标准》中环境作用等级中的“轻度”进行设计.     

RE型活化剂对氮碳共渗渗层性能的影响

研究了RE 型活化剂对45#、40Cr钢氮碳共渗的渗层硬度及深度的影响。结果表明:RE 型活化剂使渗层硬度和深度都得到了很大提高。     

高速公路连拱隧道施工监测及分析

依托作为河北省交通厅重点研究项目"高速公路复杂地层双连拱隧道施工控制工艺研究与应用"项目,以张石高速公路某连拱隧道为研究对象,通过对中导洞双侧洞法施工过程中现场测量的数据进行分析整理,得出了有关浅埋软弱岩体隧道一般施工监测的分析结果.     

高水头泄水建筑物侧墙掺气减蚀特性研究

工程中通常采用强迫掺气减蚀措施,防止泄水建筑物在高速水流作用下发生空蚀破坏,但在保护过流面底板的同时,忽视了对其侧墙的保护。为了减免位于高流速区域和低压区域侧墙发生空化空蚀,消除侧墙清水区,采用理论分析和物理模型试验研究方法,对龙抬头明流泄洪洞下游边墙掺气减蚀进行了研究,提出了在反弧末端加折流器（突扩）和突跌掺气方式。结果表明,采用突扩和突跌的掺气方式后,侧墙水流的出射角增大,侧空腔畅通,并直接和底空腔相连,有助于掺气坎后水舌的全断面的掺气,对侧墙和底板皆起到了很好的保护作用。     

Pathogenic Hydrogel? A Novel-Entrapment Neuropathy Model Induced by Ultrasound-Guided Perineural Injections

Entrapment neuropathy (EN) is a prevalent and debilitative condition caused by a complex pathogenesis that involves a chronic compression–edema–ischemia cascade and perineural adhesion that results in excessive shear stress during motion. Despite decades of research, an easily accessible and surgery-free animal model mimicking the mixed etiology is currently lacking, thus limiting our understanding of the disease and the development of effective therapies. In this proof-of-concept study, we used ultrasound-guided perineural injection of a methoxy poly(ethylene glycol)-b-Poly(lactide-co-glycoilide) carboxylic acid (mPEG-PLGA-BOX) hydrogel near the rat’s sciatic nerve to induce EN, as confirmed sonographically, electrophysiologically, and histologically. The nerve that was injected with hydrogel appeared unevenly contoured and swollen proximally with slowed nerve conduction velocities across the injected segments, thus showing the compressive features of EN. Histology showed perineural cellular infiltration, deposition of irregular collagen fibers, and a possible early demyelination process, thus indicating the existence of adhesions. The novel method provides a surgery-free and cost-effective way to establish a small-animal model of EN that has mixed compression and adhesion features, thus facilitating the additional elucidation of the pathophysiology of EN and the search for promising treatments.     

水下隧道穿越管道保护效果测试评价

本文通过对四川气田北干线涪江隧道穿越管道阴极保护电参数的现场测试，取得了实际可信的基础数据，验证了处于水下隧道洞内的穿越段管道，能得到陆上强制电流阴极保护系统的有效保护，保护电流所必经的岩石层和锚喷钢筋混凝土层对保护电流没有构成屏蔽的结论，对管道工程设计和运行管理具有指导作用。     

Electrochemical characteristics for redox systems at nano-honeycomb diamond

Electrochemical characteristics for several redox systems at diamond films with highly ordered nanometer-scale cylindrical pores (‘nano-honeycombs’) were examined with cyclic voltammetry (CV) and electrochemical impedance measurements. The cyclic voltammetric anodic-cathodic peak separations for these nano-honeycomb electrodes were in the same range as those for polished polycrystalline diamond films, indicating that the involvement of the oxygen-terminated surface of the nano-pore walls, which should give rise to large peak separations for certain redox couples was only slight. Moreover, the peak currents in the CV were not enhanced to the extent expected on the basis of the roughness factors of the nano-honeycomb films. Ac impedance plots results indicated the existence of a concentration gradient of the reactant in the nano-pores, which is in agreement with theoretical predictions for charge transfer reactions in porous electrodes. The average concentration of the reactant (Fe^2+/3+) inside the nano-pores was a factor of ca. 80 lower than that in the bulk electrolyte. The results of the impedance analysis also indicated an increase in the reaction resistances with decreasing pore diameters.     

薄板坯连铸浸入式水口结构数值模拟

使用有限元计算方法开展薄板坯连铸浸入式水口流场的研究 ,分别对水口不同浸入深度的流场分布、水口出口不同角度的流场分布进行计算。结果发现 :水口的浸入深度在 30 0mm时较为合理 ;水口的出口角度以R1 5、60°、45°为宜