An inverse solution methodology for estimating the diffusion coefficient of gases in Athabasca bitumen from pressure-decay data

An inverse solution methodology is developed for the estimation of diffusion coefficient of gases in highly viscous, oil-sands bitumens from isothermal, pressure-decay measurements. The approach involves modeling the rate of change in pressure using the diffusion equation for the liquid phase coupled with a mass balance equation for the gas phase. The inverse solution framework is utilized to arrive at two graphical techniques for estimating the diffusion coefficient. Both techniques involve the determination of the slope of a straight line resulting from plotting the experimental data in accordance with the developed model. An advantage of the proposed techniques is that the diffusion coefficient is estimated directly, i.e. without making it an adjustable parameter. The novelty of the proposed method is in its simplicity as well as its ability to isolate portions of the pressure-decay data affected by experimental fluctuations. The effect of the initial pressure on the predicted diffusion coefficient and pressure-decay profile was also investigated. The diffusion coefficients of CO₂, CH₄, C₂H₆ and N₂ in Athabasca bitumen at 50–90 °C and about 8 MPa were estimated and compared with literature values.     

S1240一次呼叫转移命令不成功故障的排除

对S1240交换机一次呼叫转移命令不成功故障排除的过程进行了分析。     

Observer-based monitoring of thermal runaway in microwaves food defrosting

Despite its energetic interest, the use of microwaves for the thawing or temperage of food products presents a major drawback called thermal runaway. This is mainly due to the important gap between the dielectric properties of water in solid and liquid phases. A monitoring approach of the temperatures inside a foodstuff during microwave defrosting is therefore proposed to, in a first step, detect the critical phenomena of thermal runaway, and, in further work, to control it. An observer allowing to estimate the internal temperatures from the temperature of the surface has been developed. An Extended Kalman Filter, because of its simplicity of design, has been chosen, but this choice is not exclusive. The heat transfer with phase change and microwave effects is represented by a nonlinear distributed parameters system, and the observer is based on a standard finite volume scheme. The approach is experimentally carried out and validated during the defrosting of a block of tylose.     

Copper(II) removal from aqueous solutions by fly ash

The removal of Cu(II) by adsorption on fly ash has been found to be concentration, pH and temperature dependent. The kinetics of adsorption indicates the process to be diffusion controlled. The Langmuir constants have been calculated at different temperatures, and the adsorption has been found to be endothermic (ΔH = 15.652 kcal mol^?1). The maximum removal is observed at pH 8.0, and variation in adsorption with pH has been explained on the basis of surface ionisation and complexation.     

正压冲固基础海洋平台冰激振动动力响应

正压冲固基础海洋平台是一种新型平台桩基结构形式。采用三维有限元的数值分析方法,建立了正压冲固平台的三维有限元模型。基于冰激强迫振动理论提出动冰载荷的计算方法,根据海冰破碎长度和冰速确定冰载周期,冰强度限制的水平冰力作为冰力峰值,得到的动冰载荷用于正压冲固平台的动力响应分析,并依照规范计算了6倍桩径处刚性固定时的动力响应。三维有限元方法计算得到的动力响应大于6倍桩径刚性固定时的计算结果,结构安全性评估偏于安全。     

贯流式水轮发电机集电环短路原因分析及改善措施

白石窑水电厂1～4号发电机组在投运初期,集电环曾多次出现绝缘降低甚至短路的非正常现象。通过分析,引发故障的原因主要是碳刷架、集电环绝缘结构设计欠妥、运行环境恶劣以及机组的振动过大。针对上述原因,改进了绝缘结构设计上的不足,加强巡视和维护检查,装设工业电视监控,加装碳粉回收装置,对受油器进行防漏油或喷油技术处理,加强清污力度、提高发电水头以便减少机组振动,从内外因加以防范和改善后,问题得到了标本兼治,取得了理想的效果。     

大块式动力基础的振动分析与加固处理

根据一大块式曲柄连杆机构的机器钢筋混凝土基础的振动测试与振动分析 ,诊断了基础发生工程事故的原因 ,并结合工程特点 ,在不改变基础设计的动力参数的情况下 ,确定了灌浆加固处理方法 ,并介绍了灌浆加固处理的效果。     

Simulation by Slepian method of plastic displacements of Gaussian process excited multistory shear frame

The object of study is a stationary Gaussian white noise excited multi-degree-of-freedom (MDOF) linear elastic, ideal plastic, linearly damped, statically determinate oscillator with several potential elements of ideal plastic yielding. Specifically the study is exemplified for a plane multistory shear frame with rigid traverses where all the connecting columns except the columns in one or more of the bottom floors have finite symmetrical yield limits. The white noise excitation acts on the mass of the first floor making the movement of the elastic bottom floors simulate a ground motion that interacts with the structure above the bottom floors. The method of study is so-called Slepian model simulation and is in principle the same for other statically determinate MDOF elasto-plastic oscillators of the considered type. The method is fast as compared to direct simulation and provides results that give good insight in the behavior of the plastic displacement response process.     

甲基丙烯酸三氟乙酰氧乙酯的聚合

对甲基丙烯酸三氟乙酰氧乙酯(TFAOEMA)的阴离子聚合及原予转移自由基聚合进行了研究。常用的阴离于引发剂如丁基锂、1，1-二苯基已基锂等很难引发TFAOEMA的阴离子聚合，而碱性较弱的引发剂如三乙基铝却容易引发，且产率较高。以氯化亚铜、五甲基二乙基三胺、溴代丙酸乙酯为引发体系的TFAOEMA的本体原子转移自由基聚合符合活性聚合特征。但在四氢呋喃为溶剂的原子转移自由基聚合中却存在活性中心失活现象。以末端含卤素的聚甲基丙烯酸甲酯为大分子引发剂，引发TFAOEMA的原子转移自由基聚合，得到了含氟双嵌段聚合物。     

Influence of the Transport Properties of the Crystal/Heat Transfer Surface Interfacial on Fouling Behavior

One method to reduce fouling is to extend the induction time by a defined modification of the interfacial interactions between the heat transfer surface and the crystalline deposit. Since these interactions are a result of both molecular and mechanical forces, two approaches for fouling mitigation have been developed: (a) Modification of the energy related properties of the heat transfer surface and (b) Modification of the geometry related properties of the heat transfer surface.