基于不同爆轰产物的格尼速度估算新方法（英）

A new method for prediction of Gurney velocity of explosives is introduced in which energy output is correlated with the heat of detonation, the number of moles of gaseous products of detonation per gram of explosive and the average molecular weight of gaseous products. It is assumed that the CHNO explosive reacts to form products composed of N2 , CO, H2O, CO2, H2,O2 and C（s） as determined by the oxygen balance of the unreacted compound. Good agreement is obtained between measured and calculated values of Gurney velocity as compared to previous correlations which assumed the reaction products to consist of N2 , H2O, CO2 and either C（s） or O2.     

Increasing Raffinate Dewaxing Efficiency

The efficiency of dewaxing of wide and narrow distillation raffinates using different mixed solvents: acetone and methyl–tert–butyl ether (MTBE), acetone and toluene, methyl ethyl ketone (MEK) and toluene, is compared. Decreasing the cutpoints from 100–140 to 50–70°C increases the filtration rate by 2 and more times and the yield of dewaxed lube oil by 2.5–5% as a function of the solvent used.     

垂直井两相流动生产测井解释滑动模型

在两相流动模拟实验数据分析的基础上 ,提出油水两相和气液两相流动的滑脱速度的实验关系 ,进而确定垂直井两相流动生产测井解释的滑动模型。现场实际测井资料处理结果表明该模型有很好的应用效果     

Solving regularized least squares with qualitatively controlled adaptive cross‐approximated matrices

The adaptive cross‐approximation (ACA) technique is applied to accelerating an inverse‐problem solver that estimates charge distribution on a dielectric spacer. The ACA generates an approximated system‐matrix that enables us to carry out high‐speed inverse calculation. We designed an approximation procedure based on ACA with some additional concepts, that is, (a) partitioning of matrix based on algebraic information, (b) approximation quality control based on matrix norms, and so on. The tested solver (LSQR for regularized least squares) with ACA demonstrates about 10 times faster performance than that without ACA. © 2007 Wiley Periodicals, Inc. Electr Eng Jpn, 159(3): 10–18, 2007; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20326     

GPS在水面流速流向测量中的应用

传统的水面流速流向测量多采用经纬仪交会法,此法需要大量的人力和设备,工作量大且费时。近几年,随着全球定位系统(GPS)的广泛应用和实践,在一定范围内,采用GPS定位法替代经纬仪交会法施测水面流速流向。介绍了GPS定位法的测量原理、设备,以及测量方法。通过对GPS定位法的精度和优缺点的分析,得出采用GPS定位法施测水面流速流向具有较高的推广价值。     

应用磷灰石裂变径迹研究大民屯凹陷的古地温

为深刻认识辽河盆地古地温特征，利用裂变径迹分析方法，对大民屯凹陷钻井岩心中19块磷灰石样品的裂变径迹年龄和长度做了测试。结果表明，随井深增加，径迹年龄和平均径迹长度有减少、变短的显著趋势，ES3^4地层磷灰石裂变径迹表观年龄比地层年龄年轻得多，说明沉积后曾长时间处于退火带中，退火带古地温为74～130℃，有效加热时间为4l～45Ma，2300～4000m深度地层处于退火过渡带。将径迹长度分布特征与地史、热史模拟结果相结合，认为该区在ES4段末经历一次短时间迅速增温后，ES3^1亚段存在一个区域抬升降温的热事件过程，其后地层稳定下降，沉降幅度小、沉积物较薄，温度增加缓慢，古地温梯度高于今地温梯度，对生、排烃较为有利。     

用穿透法测量声速时初始点的选择问题

用穿透方法测量岩心或固体的声速时，从测量波形中确定纵波（或横波）的到达时刻（或称初始点）比较困难，当声波的频率比较低时，其误差对测量结果影响比较大。本文用相位分析的方法研究了初始点的选择问题。首先，用各向同性较强、均匀的汉白玉制作标准件，测量其不同传播距离的波形，再用相位补偿的方法得到其传播速度；其次，利用传播速度，可从不同距离的测量波形中确定初始点及其对应的测量系统的时间延迟常数；最后，确定波形的其他位置为初始点时对应的时间延迟常数，因此，我们可以根据实际测量波形的特点选择最佳的初始点，利用其对应的时间延迟常数得到比较精确的声速。模型测量结果表明，初始点位置不同，其对应的测量系统的时间延迟常数也不同，也即测量系统的时间延迟常数是与初始点的选择相对应的。     

Wind turbine response to parameter variation of analytic inflow vortices

As larger wind turbines are placed on taller towers, rotors frequently operate in atmospheric conditions that support organized, coherent turbulent structures. It is hypothesized that these structures have a detrimental impact on the blade fatigue life experienced by the wind turbine. These structures are extremely difficult to identify with sophisticated anemometry such as ultrasonic anemometers. This study was performed to identify the vortex characteristics that contribute to high‐amplitude cyclic blade loads, assuming that these vortices exist under certain atmospheric conditions. This study does not attempt to demonstrate the existence of these coherent turbulent structures. In order to ascertain the idealized worst‐case scenario for vortical inflow structures impinging on a wind turbine rotor, we created a simple, analytic vortex model. The Rankine vortex model assumes that the vortex core undergoes solid body rotation to avoid a singularity at the vortex centre and is surrounded by a two‐dimensional potential flow field. Using the wind turbine as a sensor and the FAST wind turbine dynamics code with limited degrees of freedom, we determined the aerodynamic loads imparted to the wind turbine by the vortex structure. We varied the size, strength, rotational direction, plane of rotation, and location of the vortex over a wide range of operating parameters. We identified the vortex conformation with the most significant effect on the blade root bending moment cyclic amplitude. Vortices with radii on the scale of the rotor diameter or smaller caused blade root bending moment cyclic amplitudes that contribute to high damage density. The rotational orientation, clockwise or counter‐clockwise, produces little difference in the bending moment response. Vortices in the XZ plane produce bending moment amplitudes significantly greater than vortices in the YZ plane. Published in 2005 by John Wiley & Sons, Ltd.     

樊口大闸加固工程中的爆破振动分析

在考闸墩上爆破开挖出新的闸门槽，在新浇混凝土附近进行底板爆破开挖，爆破振动对闸墩和新浇混凝土的影响值得重视；介绍了在樊口大闸加固工程中的爆破振动观测成果，并对爆破振动特性进行了分析。     

曲柄摇杆机构的三圆图解设计法

这里探讨了对给定行程速比系数K，摇杆摆角ψ，另外再给定摇杆长度l3(机架长度l4)、曲柄长度l1(连杆长度l2)等，找出如何运用辅助圆图解设计曲柄摇杆机构的方法。