喷射轧制Fe-4.5%Si硅钢片的组织和性能

采用喷射成形和轧制工艺制备了厚度为0.5mm的Fe-4.5%Si高硅钢片，并对其密度、显微组织和电磁性能进行了测试分析，研究结果表明：在最佳的喷射成形和轧制工艺条件下，所制备硅钢片的磁感应强度B25为1.544T、B50为1.641T；铁损P1050为1.437W/kg、P1550为3.43W/kg，说明喷射成形轧制技术可以制备出高磁感应强度、低铁损的高硅钢片。     

氧化铝生产过程结疤溶解的研究

针对氧化铝生产过程结疤现象。研制出一种新型清洗溶剂，溶垢率可达95%，清洗效果达到《工业设备化学清洗质量标准》要求。     

吐丝圈径对大规格高碳盘条组织性能的影响

计算与分析了斯太尔摩冷线上盘条的吐丝圈径、搭接密度及"佳灵"装置横向布风曲线之间的关系,研究了吐丝圈径的大小对大规格82B盘条组织和性能的影响,确定了大规格82B盘条最小吐丝圈径应为980mm.     

人骨骼中~(228)Th、~(230)Th和~(232)Th含量的同时测定

本文介绍了用α谱仪同时测定人骨骼中~(228)Th、~(230)Th和~(232)Th含量的方法。样品用浓 HNO_3和 H_2O_3湿灰化,草酸钙共沉淀载带、CL-5208萃淋树脂和743阳离子交换树脂联合分离后,电沉积制源,在低温半导体α谱仪上测量。该方法对~(234)Th的全程回收率为95.0±1.7%,对铀和镭的去污系数分别为6.3×10~4和1.5×10~3,对~(228)Th、~(230)Th、~(232)Th 的探测下限分别为0.432、0.135和0.108Bq/kg(鲜重)。     

黄河流域委属大河控制站站网布局分析检验与调整

简要论述了黄河流域委属大河控制站的基本情况，通过资料分析，按“直线原则”计算了黄河大河控制站布站数目的上、下限，并调查分析落实了各河段近期和中长期治理开发对水资料的需求，确定各河段测站数目的采用值；对照现有站数，结合测站位置，功能，测验，生活条件等，逐段逐站进行审查，综合评估，决定测站的撤，迁，留，并对密度不足的河段提出了设站意见。     

南水北调西线工程水环境影响分析

南水北调西线工程调水后，引水坝址下游局部河段水量明显减少，但影响范围和程度十分有限。随着两岸环保力度的加大，排污量的减少，径流量减少对局部江段水质的不利影响，可得到控制。预估调水后下游水质不会发生类别变化。     

长江螺山站高水位流量关系和城陵矶（莲花塘）控制水位的研究

螺山站高水位流量关系是确定长江城陵矶（莲花糖）控制水位的基本依据，从基本的河道水力学规律出发，考虑涨落率修正、瞬时比降修正，计算各时段点的代表性比降，和相应糙率，求出均值，根据断面资料，得出高水位的稳定流曲线，并以各日流量转化的稳定流点，进行验证，精度很好，分析了河段区间流量对螺山站稳定流量的影响。阐明了螺山站稳定流量的变化情况和趋势，推求了各次大洪水的超额洪量，计算出莲花糖以上的总入流，根据现今的湖区及槽蓄容积进行洪水演进，计算1954年特大洪水的超额洪量，并分析节三峡水库拦洪后对长江中下游超额水量的影响；对莲花塘不同防洪控制水位进行了技术经济分析和评价，提出了抬高控制水位的具体建议。     

船闸直立墙基坑开挖与锚固施工程序

三峡船闸深槽开挖与锚固工程量大，工期紧，施工强度高，施工难度大。因此，合理的施工程序有利于边坡稳定和施工，是快速和高质量施工的关键。分析了永久船闸直立墙基坑开挖与锚固施工程序的复杂性和进行研究的必要性。介绍了设计阶段研究船闸开挖与锚固的施工程序。对施工过程中研究施工程序时考虑的因素，研究的主要内容以及实际采用的施工程序作了简要的分析，归纳和总结。     

Network topology and the theory of rubber elasticity

The earliest investigations on rubber elasticity, commencing in the 19th century, were necessarily limited to phenomenological interpretations. The realisation that polymers consist of very long molecular chains. commencing c. 1930, gave impetus to the molecular theory of rubber elasticity (1932-). according to which the high deformability of an elastomer, and the elastic force generated by deformation, stem from the configurations accessible to long molecular chains. Theories of rubber elasticity put forward from 1934-1946 relied on the assumption that the junctions of the rubber network undergo displacements that are affine in macroscopic strain. The theory of James and Guth (1947) dispensed with this premise, and demonstrated instead that the mean positions of the junctions of a ‘phantom’ network consisting of Gaussian chains devoid of material properties are affine in the strain. The vital significance of the distinction between the actual distribution of chain vectors in a network and their distribution if the junctions would be fixed at their mean positions went unnoticed for nearly 30 years. Experimental investigations, commencing with the incisive work of Gee in 1946. revealed large departures from the relationship of stress to strain predicted by the theories cited. This discrepancy prompted extensive studies, theoretical and experimental, during succeeding years. Inquiry into the fundamentals of polymer networks, formed for example by interlinking very long polymer molecules, exposed the need to take account of network imperfections, typically consisting of chains attached at only one end to a network junction. Various means were advocated to make corrections for these imperfections. The cycle rank ζ of the network has been shown (1976) to be the fundamental measure of its connectivity, regardless of the junction functionality and pattern of imperfections. Often overlooked is the copious interpenetration of the chains comprising typical elastomeric networks. Theories that attempt to represent such networks on a lattice are incompatible with this universal feature. Moreover, the dense interpenetration of chains may limit the ability of junctions in real networks to accommodate the fluctuations envisaged in the theory of phantom networks. It was suggested in 1975 that departures from the form predicted for the elastic equation of state are due to constraints on the fluctuations of junctions whose effect diminishes with deformation and with dilation. Formulation of a self-consistent theory based on this suggestion required recognition of the non-affine connection between the chain vector distribution function and the macroscopic strain in a real network, which may partake of characteristics of a phantom network in some degree. Implementation of the idea was achieved through postulation of domains of constraint affecting the equilibrium distribution of fluctuations of network junctions from their mean positions. This led in due course to a theory that accounts for the relationship of stress to strain virtually throughout the ranges of strain accessible to measurement. The theory establishes connections between structure and elastic properties. This is achieved with utmost frugality in arbitrary parameters.     

白钨矿浮选731捕收剂低温乳化试验研究

介绍了731捕收剂在低温条件下试验的情况。试验研究结果表明，采用A和B药剂以5：6的比例混合组成的复合乳化剂对731进行乳化，低温时乳化体系稳定性好，浮选过程中降低乳化731的用量，同时提高了选择性，降低了浮选成本，实现了低温环境下白钨矿正常浮选作业，达到选矿技术攻关指标。