Conceptual design of a high-efficiency absorption cooling cycle

The search for high-efficiency, gas-fired cooling cycles has led to the development of dual-loop absorption machines with cooling coefficients of performance (COPs) in the 1.2 to 1.7 range. This increased performance may call for high generator temperatures, new working fluids or new materials of construction. In most cases, two different sets of working fluids are required. The conceptual design presented here is aimed at obtaining high efficiencies with relatively low temperatures, employing only one set of fluids. The concept consists of two loops coupled in a configuration aimed at minimizing the loss of thermodynamic availability incurred when transferring refrigerant between the loops. The working fluid pair is a solution of lithium bromide-water. The calculated COPs are of the order of 1.8. The cycle relies on an elaborate evaporator-absorber combination. The paper presents the conceptual design, the critical assumptions, and the performance calculations for the concept.     

InAs／InP_（0．7）Sb_（0．3）热电子晶体管的f_T及f_（max）

用电荷控制及热电子弹道运动模型计算ＩｎＡｓ／ＩｎＰ０．７Ｓｂ０．３热电子晶体管的截止频率ｆＴ及最高振荡频率ｆｍａｘ。结果表明，ｆＴ、ｆｍａｘ分别达到２８０ＧＨｚ及６００ＧＨｚ。并指出，通过生长ＧａＳｂ中间层，ＩｎＡｓ／ＩｎＰ０．７Ｓｂ０．３ＨＥＴ可在ＧａＡｓ衬底上实现单片集成。     

Ni对球墨铸铁热处理的影响

采用电子探针，图象分析仪、差质变分析仪和Ｘ射线衍仪定量研究了Ｎｉ在球铁中的分布和Ｎｉ铸态球铁组成相比例奥氏体中含碳量以及贝氏体转变ＴＴＴ曲线线的影响，结果表明，Ｎｉ在球铁中呈连续负偏析，其加入可以影响球铁组成上比例，并使粤氏体中含碳量和贝氏体转变孕育期期增加。     

Prediction of evaporation heat transfer coefficient and pressure drop of refrigerant mixtures

A study on the prediction of heat transfer coefficient (HTC) and pressure drop of refrigerant mixtures is reported. HTCs and pressure drops of prospective mixtures to replace R12 and R22 are predicted on the same cooling capacity basis. Results indicate that nucleate boiling is suppressed at qualities greater than 20.0% for all mixtures and evaporation becomes the main heat transfer mechanism. For the same capacity, some mixtures containing R32 and R152a show 8.0–10.0% increase in HTCs. Some mixtures with large volatility difference exhibit as much as 55.0% reduction compared with R12 and R22, caused by mass transfer resistance and property degradation due to mixing (32.0%) and reduced mass flow rates (23.0%). Other mixtures with moderate volatility difference exhibit 20.0–30.0% degradation due mainly to reduced mass flow rates. The overall impact of heat transfer degradation, however, is insignificant if major heat transfer resistance exists in the heat transfer fluid side (air system). If the resistance in the heat transfer fluid side is of the same order of magnitude as that on the refrigerant side (water system), considerable reduction in overall HTC of up to 20% is expected. A study of the effect of uncertainties in transport properties on heat transfer shows that transport properties of liquid affect heat transfer more than other properties. Uncertainty of 10.0% in transport properties causes a change of less than 6% in heat transfer prediction.     

Deformation analysis of skew ruled surface shells by moiré interference

The use of thin film grids coated on surfaces is described in relation to the determination of deformations in doubly curved shells. The technique is called the coating film moiré interference method and employs a laser holographic approach.     

Benefits to 0+ fishes of connecting man‐made waterbodies to the lower River Trent,England

Floodplain waterbodies are reputed to enhance recruitment of riverine fish populations via provision of spawning and nursery habitat, refuge from floods, and increased availability of planktonic food resources compared with main river channels. Notwithstanding, there have been few parallel studies of fishes and their food resources at both main river and floodplain sites. Thus, this study investigated the 0+ fishes, zooplankton and phytoplankton (chlorophyll a) at four main river and four (man‐made) floodplain sites on the lower River Trent, England, between May 1999 and October 2004 inclusive. All sites shared the same key fish species, and there were no consistent differences in the densities, growth or condition of 0+ fishes from main river and floodplain sites. Similarly, all sites shared the same key zooplankton taxa. However, zooplankton densities, notably of large‐bodied cladocerans, and chlorophyll a concentrations, were significantly higher at floodplain sites than at main river sites. Thus, connection of man‐made waterbodies has the potential to enhance recruitment of riverine fish populations via provision of important spawning and nursery habitat, and superior feeding opportunities for 0+ fishes compared with main river channels. Copyright © 2007 John Wiley & Sons, Ltd.     

Degradation of polyethylene terephthalate films in the presence of lubricants for HFC 134a: a critical issue for hermetic motor insulation systems

Earlier studies conducted in the use of sealed tubes with polyalkylene glycol lubricants and polyethylene terephthalete (PET) films revealed that the PET films exhibited embrittlement and (visual) degradation. This led to an investigation of PET embrittlement mechanisms with the new lubricants used with HFC 134a. The lubricants studied were three polypropylene glycols (the monol, the diol and the completely end-capped glycols), pentaerythritol ester and a blend of monol and ester. The effects of moisture content, temperature and lubricant structure were studied. All lubricants in this study were of viscosity grade ISO-32 (150 SUS). The results were compared to PET film embrittlement in the presence of CFC 12 and mineral oil. This study reconfirmed the earlier findings that the PET films must be dried to lower than 0.1 wt.% moisture content for use in hermetic systems. This paper discusses the effect of the moisture content of the lubricant and the effect of the lubricant structure on PET films. The dependence of the various mechanisms on temperature is shown. Esters and end-capped polyalkylene glycols are recommended for use with HFC 134a.     

修正步冷温度曲线试验研究

按修正步冷温度曲线对经步冷脆化的 2 .2 5Cr 1Mo和在加氢反应器内运行 5a的 2 2 5Cr 1Mo试块进行了修正步冷试验 ,评定了材料的回火脆性。结果表明 ,按修正步冷曲线进行修正步冷试验能使已经脆化的材料进一步脆化 ,为加氢反应器材料损伤的研究提供了一条途径。     

应用ITO膜作电荷收集极的位置灵敏探测器

首次尝试将ITO（Indium Tin Oxide）膜与微通道板（Microchannel Plate）结合用作位置灵敏探测器，并对该探测器的线性、位置分辨及探测效率作了测试，得到了令人满意的结果。     

Continuous formation of slurry ice by cooling water–oil emulsion in a tube

Water-silicone oil emulsion with an additive, (C₂H₅O)₃SiC₃H₆NH₂, was examined as a heat storage material. A spiral tube used as a heat exchanger was immersed in a low temperature bath and the emulsion was circulated in the tube to make ice continuously. Ice was separated from the ice–liquid suspension in an outlet tank. The amount of formed ice, the temperatures of the inlet and the outlet of the heat exchanger, and the temperatures in the tube wall were measured and the overall heat transfer coefficient and the heat flux through the tube were calculated. Experiments were carried out, varying the flow rate, the temperature of cooling brine, and the thickness of tube wall. The condition under which slurry ice was formed continuously without adhesion of ice to the cooling wall was clarified. Though decrease in the thermal resistance of the tube increased the rate of ice formation or raised the brine temperature, it narrowed the range of the flow rate and of the brine temperature in which slurry ice was formed continuously.