关于天然气水合物钻采工艺技术进展的研究

目前全球正面临着前所未有的能源危机，天然气水合物由于储量大、能量密度高而将成为一种诱人的新型能源。天然气水合物主要存在于冻土带和海洋，在地下处于低温和高压状态，以现有的技术，钻井和开采都存在很大的困难。简要介绍了天然气水合物的性质及储量，阐述了天然气水合物钻井的六个挑战及目前国外天然气水合物的两种钻探方法；同时阐述了以热力法、降压法和化学试剂注入法为主的天然气水合物开采方法，并针对天然气水合物钻采技术现状指出了下一步的研究方向。     

加油站油品防盗的措施

为防止加油站油品被盗，应采取加强夜间值班管理、加强油品的计量管理和加强安全管理的高科技建设三项措施。     

北部湾盆地福山凹陷CO2气成因探讨

北部湾盆地福山凹陷油气钻探中发现了高含CO₂气的天然气气藏。对CO₂气稳定碳同位素、伴生稀有气体氦和氩同位素进行了分析研究，结果显示，福山凹陷CO₂气稳定碳同位素偏重，(13C_CO2为-5.01～-10.08‰，绝大多数样品大于-7.0‰，为无机成因CO₂气特征；伴生稀有气体氦同位素³He/⁴He值为(4.74~5.03)×10^-6，R/Ra值为3.38～3.59；伴生稀有气体氩同位素⁴⁰Ar/³⁶Ar值为1881～2190，也显示出幔源或壳幔混合CO₂气的特征。综合判定认为，福山凹陷CO₂为壳幔混合成因。始新统流沙港组岩浆岩体分布特征与CO₂气藏分布范围基本一致，也表明幔源-岩浆可能是福山凹陷CO₂气的主要来源。与南海北部边缘盆地其它地区如珠江口盆地西部、琼东南盆地东部CO₂气成因一致，都为幔源-岩浆来源，或壳幔混合来源。     

含硫化氢气井钻井过程中的腐蚀因素与防护研究

在含硫气井的钻井过程中对于HRC大于22的钻具钢材除了腐蚀疲劳之外，在pH值小于9的环境中会发生硫化物应力腐蚀破裂，这种破坏比腐蚀疲劳更突然、更快，使钻杆大量损坏。含硫气井在钻井过程中，由于湿硫化氢的出现，常常会出现油管、套管、钻井设备、钻井仪器以及对支持保护管柱的水泥环柱等腐蚀和损坏问题，为此，阐述了湿硫化氢的腐蚀特点、机理，归纳总结了影响腐蚀的因素，综述了如何在这些方面防止其腐蚀，使损失减小，为指导油管、套管防腐工程实践提供了依据。建议在钻井过程中采用碱性钻井液，其pH值可到9或更高(至pH值12)，以减缓或防止钻井过程中电化学从硫化物应力腐蚀破裂；含硫气井用的钻杆应该间歇使用。钻杆停用堆置时间可使其放氢，使钻杆恢复韧性，防止硫化物应力腐蚀断裂。     

燃气管网动态仿真的研究及应用

研究和了解燃气在管道中的流动，是进行燃气管网系统优化和提高管网输运系统安全性的前提和基础。以流体力学三大守恒方程为基础，建立了等温和非等温条件下的燃气管网稳态和动态仿真理论模型。以有限差分法为基础，得到了上述模型的求解方法，并加入了耗散项，提高了求解方法的稳定性。通过增加初始点和延长出口点的方法，简化了模型的求解。通过在北京六环天然气管网中的初步应用，分别得到了与实际值综合相对误差为1.21％和2.62％的压力和流量仿真值，从而验证了模型及求解方法的可靠性。     

卫星电视上行站信号自动监测系统

每个卫星电视上行站都必须对卫星转发器上的电视信号进行监测,才能及时发现卫星电视上行信号的异常变化,准确处理异常突发干扰。为实现自动、连续、实时监测,就需要建立卫星电视上行站射频信号自动监测系统。文章详细介绍了一个自动监测系统的设计及实现。     

Ring‐opening polymerization of lactones initiated by diphenylzinc–coinitiator systems

Diphenylzinc, alone or in combination with water and butanone as coinitiators, was used as a polymerization initiator system for a variety of lactones at varying temperatures. The resulting data indicate that the course of the polymerization is greatly influenced by the lactone structure, as well as by the molar ratio of coinitiator to diphenylzinc. When used alone, diphenylzinc exhibited high activity as an initiator in δ‐valerolactone polymerizations, although it was less efficient when used in the β‐butyrolactone and the β‐propiolactone polymerizations. Activity in the polymerization of β‐lactones was increased by adding small amounts of butanone or water. It was also observed that the diphenylzinc–butanone combination was more effective than the diphenylzinc–water mixture in the polymerizations of β‐butyrolactone and β‐propiolactone. Copyright © 2003 Society of Chemical Industry     

Biotransformation of l‐menthol by twelve isolates of soil‐borne plant pathogenic fungi (Rhizoctonia solani) and classification of fungi

The microbial transformation of l‐menthol ( 1 ) was investigated by using 12 isolates of soil‐borne plant pathogenic fungi, Rhizoctonia solani (AG‐1‐IA Rs24, Joichi‐2, RRG97‐1; AG‐1‐IB TR22, R147, 110.4; AG‐1‐IC F‐1, F‐4, P‐1; AG‐1‐ID RCP‐1, RCP‐3, and RCP‐7) as a biocatalyst. Rhizoctonia solani F‐1, F‐4 and P‐1 showed 89.7–99.9% yields of converted product from 1 , RCP‐1, RCP‐3, and RCP‐7 26.0–26.9% and the other isolates 0.1–12.0%. In the cases of F‐1, F‐4 and P‐1, substrate 1 was converted to (?)‐(1S,3R,4S,6S)‐6‐hydroxymenthol ( 2 ), (?)‐(1S,3R,4S)‐1‐hydroxymenthol ( 3 ) and (+)‐(1S,3R,4R,6S)‐6,8‐dihydroxymenthol ( 4 ), which was a new compound. Substrate 1 was converted to 2 and/or 3 by RRG97‐1, 110.4, RCP‐1, RCP‐3 and RCP‐7. The structures of the metabolic products were elucidated on the basis of their spectral data. In addition, metabolic pathways of the biotransformation of 1 by Rhizoctonia solani are discussed. Finally, from the main component analysis and the differences in the yields of converted product from 1 , the 12 isolates of Rhizoctonia solani were divided into three groups based on an analysis of the metabolites. Copyright © 2003 Society of Chemical Industry     

新型高K栅介质ZrO2薄膜材料的制备及表征

采用超高真空电子束蒸发法制备了新型高 K栅介质-非晶 ZrO2薄膜. X射线光电子能谱 (XPS) 中 Zr3d5/2 和 Zr3d3/2 对应的结合能分别为 182.1eV和 184.3eV, Zr元素的主要存在形式为 Zr4+,说明薄膜由完全氧化的 ZrO2组成 ,并且纵向分布均一.扩展电阻法( SRP)显示 ZrO2薄膜的 电阻率在 108Ω@ cm以上,通过高分辨率透射电镜( HR- XTEM)可以观察 ZrO2/Si界面陡直,没有 界面反应产物 ,证明 600℃快速退火后 ZrO2薄膜是非晶结构.原子力显微镜( AFM)表征了薄膜的 表面粗糙度,所有样品表面都很平整,其中 600℃快速退火样品 (RTA)的 RMS为 0.480nm.