Simulation of carbon nanotube based p-n junction diodes

Taking advantage of the unique characteristics of an ambipolar carbon nanotube field effect transistor (CNTFET), a ‘p-n junction’ is simulated along the single-walled carbon nanotube channel using two separate gates close to the source and drain of the CNTFET, respectively. The current-voltage characteristics of the double-gated CNTFET are calculated using a semiclassical method based on the Schottky barrier field effect transistor mechanism. The calculation results show a good rectification performance of the p-n junction.     

Impedance spectroscopy study of hardened Portland cement paste

In this paper, the differential impedance analysis (DIA) has been applied to the study of the dielectric properties of hardened Portland cement paste. Two time constants are found in the impedance spectra obtained in the frequency region form 100 kHz to 15 MHz. One time constant has been attributed to the solid matrix and the other one to the liquid phase filling the pores. The effect of the cement paste-electrodes interface has been quantified using two different experimental set-ups. Measurements using direct contact between electrodes and cement paste have been compared with measurements using an air gap technique in which the specimen “floats” between the electrodes. The two referred time constants have been found in both types of measurements. The influence of drying on the dielectric parameters is also studied.     

Structural and electrical properties of mixed oxides of manganese and vanadium: A new semiconductor oxide thermistor material

Binary oxides of manganese and vanadium have been synthesized by solid state sintering, in which the mass ratio of the individual components Mn₂O₃ and VO₂ have been varied from 90:10 to 5:95. The bulk ceramic samples were characterized by X-ray diffraction and scanning electron microscopy with energy dispersive X-ray analysis. The initial compositions either rich in Mn₂O₃ or in equi-proportion by mass with VO₂ yield β-Mn₂V₂O₇ or a new crystalline form of Mn₂V₂O₇, with unit cell parameters: a = 7.73091 Å, b = 6.640788 Å, c = 6.70779 Å α = γ = 90° and β = 98.7086° which is designated as γ-Mn₂V₂O₇. The compositions, richer in VO₂ produce MnV₂O₆ co-existing with V₂O₅ the proportion of which increases with increase in VO₂. The surface microanalysis shows a spherical-granular morphology in Mn₂V₂O₇ structure and plate/rod-like structures co-existing with granular morphology in case of MnV₂O₆ together with V₂O₅. The electrical parameters of the negative temperature coefficient thermistors were determined. Depending on the constituent oxide composition, the NTC thermistors showed room temperature resistivity in the range of 6.52 × 10² to 6.1 × 10⁶ Ω-cm. The thermistor constant and activation energy are in the range of 0.12–0.458 eV and 1393–4801 K, respectively.     

Tracking of moving interfaces in sedimentation processes using electrical impedance tomography

Sedimentation monitoring is widely used to control and optimize industrial processes. In this paper we propose a novel computational method for sedimentation monitoring using electrical impedance tomography (EIT). EIT measurements consist of electric current and voltage measurements that are made on the surface of the sedimentation tank and therefore they do not interfere with the sedimentation process. The proposed computational method is based on shape estimation and state estimation formulation of the EIT problem. The sedimentation is parameterized by the locations of the phase interfaces and conductivities of the phase layers. Three different evolution models for the state parameters are considered and the state estimates are computed using the extended Kalman filter algorithm. The performance of the method and the models are evaluated using simulated data from a six electrode EIT measurement configuration. From the results a promising performance of the method can be seen.     

提高变压器抗短路强度的措施

变压器对抗短路强度的要求是很高的。文中介绍了变压器短路时的电动力的作用情况，结合单位实际情况介绍了提高变压器抗短路能力的措施。     

Electrical and optical characterization of Na: CuInS2 thin films grown by spray pyrolysis

The structural, electrical and optical properties of Na-doped CuInS₂ thin films grown by spray pyrolysis were studied. These films crystallized in the sphalerite structure of CuInS₂, and showed to contain traces of indium sulfide and CuIn₅S₈ as impurity phases. All films were In-rich and showed p-type conductivity. The film conductivity was strongly affected by Na-doping, which decreased from 10⁻² to 10⁻⁵ S/cm by increasing the [Na]/[Cu] ratio from 0.005 to 0.03 in the spray solution. The band gap energy was observed to increase, from 1.4 to 1.45 eV, with increasing the [Na]/[Cu] ratio. Our results suggested that Na could be an effective acceptor impurity in sprayed CuInS₂.     

基于数据库管理系统的电机设计集成系统软件开发

本文基于电机设计的基本原理 ,采用Access数据库管理技术、面向对象技术、SQL查询语言 ,利用VisualBasic 6.0为工具开发了基于数据库管理系统的电机设计集成系统软件。在实际使用中充分证明 ,该软件操作方便、运行良好、可维护性高 ,软件计算结果比较接近实验值。     

电容式两相流层析成象系统仿真研究

以油料在管道中输送为例进行电容层析成象仿真.利用有限元方法对电场建立数学模型,在SGI indigo 2 工作站上,使用AVS可视化软件和反投影算法,对3种典型流态模型反演及显示其流体成份分布的图象.     

电无级变速器的内燃机最佳效率控制

通过对混合动力汽车电无级变速器传动机构原理分析,提出一种内燃机最佳效率控制策略。该策略主要是基于底层控制系统的硬件结构,根据上位机发送的指令对双机械端口电机的内转子进行转矩控制,实现内燃机最佳效率运行;对外转子进行转速控制,满足车辆运行需求。并且给出了该策略下转矩辨识的方法;同时给出在整车中车辆总成控制与双机械端口电机控制系统和其他系统配合关系。通过实验,验证了该控制策略可以实现内燃机最佳效率运行同时满足负载侧连续平滑调速的可行性。     

Crystallinity and electrical conductivity of sulfur-containing microcrystalline diamond thin film

Hydrogen sulfide (H₂S) was introduced into a microwave plasma chemical vapor deposition of microcrystalline diamond thin film. Secondary-ion mass spectroscopy showed that sulfur concentration was controlled from 2 × 10¹⁵ to 9 × 10¹⁷ cm^− 3 by controlling the H₂S/CH₄ ratio, while that of hydrogen concentration was around 5 × 10²⁰ cm^− 3 and was independent of the H₂S/CH₄ ratio. Electrical conductance increased linearly as the S concentration increased from 2 × 10¹⁵ to 3 × 10¹⁶ cm^− 3 without significant deterioration of film crystallinity, i.e., the amount of sp² phase did not increase. Non-ohmic conduction was converted to ohmic conduction when the S concentration reached 9 × 10¹⁷ cm^− 3 by increasing the H₂S/CH₄ ratio to 30,000 ppm. This modification was consistent to the formation of a graphitic phase by heavy S-doping, which was identified by Raman spectra and surface morphology.