机械振动对Sn-Sb合金β相的影响

初步探讨了机械振动对Sn-Sb合金β相在基体中分布的影响,重点讨论了在不同振击力作用下对Sn-Sb11合金中β相(SnSb)偏析和细化的影响效果.试验表明,在不同振击力作用下,合金晶粒以及组织明显得到改善,而且随着振击力的增大,组织均匀化程度的改善效果呈明显上升趋势.分析结果表明,这是由于强烈的振动对金属液体的搅拌以及促使合金液晶粒(或晶团)的游离作用的缘故.     

原料加入温度对Al-Ti-C晶粒细化剂显微组织的影响

采用K2TiF6、石墨粉和纯铝为主要原料的原位反应方法制备了Al-Ti-C晶粒细化剂.通过光学显微镜、扫描电镜和能谱分析等方法分析了Al-Ti-C中间合金的显微组织.试验结果表明,K2TiF6和石墨粉同温下加入时,Al3Ti呈块状分布,不同温度下加入时则呈针状或长条状分布.随着K2TiF6和石墨粉加入温度的不同,Al-Ti-C中间合金中TiC粒子的生成机制也不同.     

5Cr21Mn9Ni4WNb2N奥氏体耐热钢晶界碳化物

5Cr21Mn_9Ni_4WNb_2N耐热钢锻造后在1200℃以上加热时，NbC聚集成大块，在1200℃以下加热时，NbC薄膜（片）的析出倾向随加热温度降低而增大，1130℃及其以下加热时，粒状和细片状M_(23)C_6随加热温度降低而增多，而且NbC块可作为碳源退化成M_(23)C_6颗粒，过高或过低温度的锻造加热，因晶界NbC块过大或晶界NbC薄膜（片）过多而不利于锻造加工。     

液态硅铁直接颗粒化的原理和方法

从理论上说明在一定条件下,液态硅铁合金自由出口处形成液滴的体积仅与液体的表面张力和出流孔直径有关。且当该体积液滴的重力和上部液体的内聚力相等时,液滴即可分离自由下落。据此理论进行了试验,结果表明,液态硅铁合金可直接进入冷却液中形成球状颗粒。且当出流孔径d=8mm,浇注温度为1420℃,落差H=150mm,油层/水层为700mm/1000mm时,76%的颗粒形状几乎都近于圆球形,颗粒体积与理论计算值最大偏差不超过10%。同时,这种液态硅铁合金直接颗粒化的方法与机械破碎法相比具有简易、快捷、节能、高效的优点。     

Electrical and optical study of Cu(In, Ga)Se2 co-evaporated thin films

Co-evaporation technique from three sources was used to prepare Cu(In, Ga)Se₂ polycrystalline thin films for photovoltaic conversion. Their conductivity was studied in the range 20–300 K. The grain boundary scattering mechanism is mainly responsible for the diffusion process in the latter materials. In the low temperature region, we interpret the data in terms of Mott law and the analysis is very consistent with the variable range hopping. However, thermoionic emission is predominant at high temperatures. When the conductivity deviates from the classical grain boundary conduction models, inhomogeneity is then considered and parameters such as the standard deviation and the mean potential barrier height are derived. Transmittance measurements yielded band gap values of 1.07 and 1.64 eV for CuInSe₂ and CuGaSe₂, respectively.     

Detoxification of cereal plant allelochemicals by aphids: Activity and molecular weights of glutathioneS-transferase in three species of cereal aphids

The activity and molecular weights of glutathioneS-transferase were studied in three species of cereal aphid:Metopolophium dirhodum, Sitobion avenae, andRhopalosiphum padi. The highest level of glutathioneS-transferase activity was recorded in extracts fromM. dirhodum and the lowest fromS. avenae, and extracts of larvae were more active than those from adults. The activity of this enzyme was higher in extracts ofS. avenae andR. padi previously fed on a moderately resistant wheat variety than on a susceptible variety. Gel filtration followed by SDS-PAGE revealed three protein bands in the active fractions. The first had a molecular weight of 28,500 and the second of 27,500 and were present in all three species of aphid. The third protein differed in the three species, having a molecular weight of 26,000 inS. avenae, 25,500 inM. dirhodum, and 24,000 inR. padi.     

纳米陶瓷的烧结研究

纳米陶瓷的制备过程中，烧结是关键一环。总结了现有的烧结理论，介绍了国内外流行的纳米烧结技术，并提出了今后的研究方向。     

合成镁白云石中CaO和MgO晶粒生长动力学

应用ＴＰ速率等式和线性截距法研究了经１５００℃至１７００℃烧成的两个合成镁白云石体系中ＣａＯ和ＭｇＯ的晶粒生长，采用回归分析和最小二乘法求得ＣａＯ和ＭｇＯ晶粒的生长指数和晶位生长活化能。结果表明，体系中ＭｇＯ晶粒的生长速率总比ＣａＯ的要大，而加入少量ＣｅＯ２添加剂的合成镁白云石中ＣａＯ和ＭｇＯ晶粒生长速率比无添加剂的要快。     

Synthesis and densification of magnesium aluminate spinel: effect of MgO reactivity

Stoichiometric magnesium aluminate spinel was synthesized by reaction sintering of alumina with caustic and sintered magnesia. The volume expansion of 5–7% during MgAl₂O₄ formation was utilized to identify the starting temperature of spinel formation and densification by high temperature dilatometry. The magnesia reactivity was determined by measurement of crystallite size and specific surface area. Caustic magnesia and sintered magnesia behave differently vis-à-vis phase formation and densification of spinel. Densification of stoichiometric Mag-Al spinel was carried out between 1650 and 1750 °C. Attempts were made to correlate the MgO reactivity with microstructure and densification of spinel.