1998年九江抗洪启示录

简述1998年江西特大洪水的基本情况，重点介绍了九江防洪的形势和九江长江城防堤4～5号闸口间堤段溃决的情况及堵口过程，并总结了经验教训和抗洪工作的体会．     

Single and combined deactivating effect of alkali metals and HCl on commercial SCR catalysts

Two commercial SCR catalysts, with a nominal W content of about 9 wt.% and a V nominal content of 0.55 and 1.8 wt.%, respectively, were contacted with different amounts of Na and K and with HCl vapours in order to simulate poisoning by species more specifically contained in exhaust gases from MSW combustion. Catalysts were characterised using XRD analysis, SEM/EDX analysis, BET and pore size distribution measurements, NH₃ TPD, TG analysis. Poisoning agents do not cause loss of surface area nor pore occlusion. A significant loss of surface acidity was observed upon alkali metals poisoning whereas a decreasing of vanadium content was observed for the more concentrated catalysts upon HCl poisoning. Catalysts deactivation is proportional to the number of acid sites neutralised by alkali metals adsorbing ammonia in the temperature range typical of SCR process. HCl promotes the formation of new acid sites showing a lower activity compared to the original one.     

利用抽余碳五馏份制备TAME

探索了以抽余Ｃ５为原料经与甲醇醚化制ＴＡＭＥ的过程。试验表明，在国产催化剂Ｄ５４型大孔阳离子交换树脂存在下，在反应温度６０℃、ＬＨＳＶ２．４ｈ－１、甲醇／异戊烯物质的量比１．００、反应压力０．２ＭＰａ的条件下，抽余Ｃ５中的异戊烯可与甲醇反应生成醚，异戊烯的转化率达６３．２６％，ＴＡＭＥ的选择性可达９９．６１％。     

两步法合成2-氨基-5-硝基苯酚

以邻氨基苯酚和尿素为原料,将传统环合-硝化-水解三步法工艺改为环合硝化-水解两步法合成了2-氨基-5-硝基苯酚(ANP);研究了影响环合硝化反应和水解反应的因素;优化了反应条件。环合硝化反应的最优条件为:n(邻氨基苯酚)∶n(尿素)=1.00∶1.20、环合时间6h、硝酸用量40.2g、硫酸用量20g、硝化时间3h、硝化温度70℃,在此条件下中间产物6-硝基苯并噁唑酮的收率为90.2%;水解反应的最优条件为:体积分数95%的乙醇为溶剂、n(6-硝基苯并噁唑酮)∶n(氢氧化钠)=1.0∶3.3、水解温度80℃、水解时间15h,在此条件下ANP收率为81.2%。两步反应ANP的总收率为73.2%。对产品进行了元素分析和红外光谱表征,确认终产物为ANP。该方法成本低,ANP总收率高,溶剂可回收,三废量少。     

活性碳和5A分子筛的吸附特性及其在真空获得中的作用

评述了活性碳和５Ａ分子筛的吸附等温线及其在真空佩温绝热夹层真空获得中的作用。分析了真空夹层抽真空除气时用Ｎ＿２气置换以及用“多次吸附－脱附Ｎ＿２气”方法活化吸附剂等先进工艺的机理。论述了根据吸附剂吸水的吸附等温线，合理确定活化工艺条件的方法。     

GJK-3型高准确度长度测量仪

本文分析了使用计数的原理来测量长度、转速的仪器，其误差产生的原因，并结合G3K-3型高准确度长度测量仪，着重介绍了消除误差的方法．     

钨精矿、锡石矿中铌和钽的5—Br－PADAP分光光度法的测定

用２－（５－溴－２吡啶偶氮）－５－二乙氨基苯酚（５－Ｂｒ－ＰＡＤＡＰ）为显色剂，采用多波长分光光度法测定钨精矿、难溶锡石矿中的铌、袒，方法快速、准确、灵敏度高，相对标准偏差≤０．０２１（ｎ＝１６）．     

ANALYSIS OF EXPERIMENTAL AND NUMERICAL RESULTS OF A TURBULENT SWIRLING FLOW IN A TUBE

In many applications swirling flow is used to enhance heat and mass transfer. One of the problems of modelling a turbulent swirling flow is the choice of the turbulent closure model which is acceptable for engineering purposes. To evaluate which model performs best, numerical results are compared with experimental data. Local velocity measurements are carried out on a swirling flow in a circular tube. The measurement method is hot-wire anemometry combined with visualization techniques. The numerical analysis is carried out using the k-ε model and the Algebraic Stress Model. In the experiment a symmetrical swirl was observed, Comparing the experimental data with the numerical results shows that the Algebraic Stress Model represents the experimental data quite well, whereas the k-ε model fails.     

基于嵌入式移动浏览器的QtWebkit 2.1内核研究与开发

通过对多种支持HTML5技术内核的分析,选取了Webkit内核Qtwebkit2.1。在对其进行深入分析的基础上,着重研究了它对HTML5的支持。最后选取并裁剪了基于Qtwebkit2.1内核的浏览器QtWeb,实现对MeeGo平台的移植。经实验表明,该嵌入式移动浏览器能部分支持HTML5技术规范,为以后的进一步研究奠定了良好的基础。