济钢转炉煤气储存加压系统存在缺陷及处理措施

济钢燃气厂针对济钢转炉煤气储存加压系统的设备现状，组织了一次设备大修，大修后煤气柜升降速度提高到了1．0m/min，并解决了加压机前负压等问题。     

Effect of Pressure Gradient on Heat Transfer of Impinging Submerged Circular Jets

An experimental and numerical study have been carried out to investigate the distribution of radial local heat transfer coefficients of impinging submerged circular jets. Good agreement is achieved between the experimental results and the predicted value. Results show that the outer peak usually occurs at the radial location of r/d= 1.8~2.0, in which transition from laminar to turbulence happens resulting from disappeared pressure gradient abruptly, and that the inner peak appears rigidly at r/d=0.5, where the boundary layer has a minimum thickness because of elevating pressure gradient.     

Yield Stress and Microstructure of Set Yogurt Made from High Hydrostatic Pressure-Treated Full Fat Milk

ABSTRACT: Set yogurts were prepared from fortified milk subjected to the following processes: (a) Thermal process (85C,°C,35 min), (b) High hydrostatic pressure process (193 or 676 MPa for 5 or 30 min), and (c) Nonprocessed milk (control). Yogurts from milk treated with 676 MPa for 30 min exhibited similar yield stress and water-holding capacity (WHC) to yogurts from heated milk. Transmission Electron Microscopy (TEM) micrographs exhibited small round casein micelle aggregates without appendages in yogurts from heated milk. Yogurts from milk treated with 193 MPa and untreated milk exhibited low yield stress, low WHC, and large clusters of coalesced micelles. Mechanisms for gel formation are discussed.     

三峡地下电站变顶高尾水洞水动力特性

在国内首次应用模型水轮发电机组对三峡地下电站变顶高尾水洞方案进行水力过渡过程试验研究。对水轮机导叶实行分段关闭 ,并求出了二段关闭的最佳拐点 ,试验证实了二段关闭对减小尾水管进口的负压和机组转速上升有明显的作用。通过有关水力参数的测试 ,认为变顶高尾水洞可以满足各项技术要求 ,是一个减少山体开挖、节省投资的新型设计方案。在地下电站中具有广泛的应用前景     

高压玻璃钢管道的研制及在油田中的应用

本文介绍了高压玻璃钢管道的特性及在我国油田的应用情况。     

气液固三相相平衡热力学模型与计算方法

原油中含有大量的高分子有机固相物质，因此，要准确地描述油气体系相平衡，必须对气液固三相相平衡进行研究，在对高分子有机烃类沥青沉降机理有了一定的认识的基础上，提出了大的交互作用系数，可以描述沥青与原油中轻质不相容性的程度。根据对油气烃类混合物体系的一般性认识与提出的沥青组分特征化方法，导出了与之相应的有其自身特殊性的气液沥青三相相平衡物料平衡方程组，用考虑沥青沉降三相闪蒸数值算法，对沥青沉降进行有效的理化模拟计算，此外，结合实例分析，给出了沥青质参考逸度的计算，饱和压力和沉降量的拟合方法。     

Study of impurity induced modifications in amorphous N-type (GeSe3·5)100−x Bi x using high pressure technique

The technique of high pressure is utilized to study the carrier transport behaviour in doped and undoped bulk amorphous (GeSe_3·5)_100−x Bi _x (x=0, 2, 4, 10) down to liquid nitrogen temperature to observe impurity induced modifications in amorphous semiconductors. It is observed that pressure induced effects in lightly doped (2 at % Bi) and heavily doped (x=4, 10) semiconductors are markedly different. Results are discussed in view of the incorporation behaviour of the bismuth impurity.     

反渗透膜仓用韧性环氧树脂基体研究

工业上广泛使用反渗透膜仓制备高纯水,为了用玻璃钢替代不锈钢,研究了一种适合湿法缠绕的反渗透膜仓用韧性环氧基体。在配方中采用液体酸酐固化剂甲基四氢邻苯二甲酸酐和高效活性增韧剂,对树脂基体和复合材料力学性能及耐水性能的研究表明该树脂基体具有许多优良性能,如拉伸强度≥86.2MPa,断裂延伸率≥5.2%,弯曲强度≥139MPa,制得膜仓爆破时纤维强度转化率高达88.7%,耐疲劳达10万次而无损伤。此外,配方体系室温下粘度为0.35～0.4Pa·s,适用期≥8h,室温下在水中浸泡180d后吸水率低于0.5%,同不锈钢相比成本降低1/2。实验结果表明,该韧性环氧基体完全适用于反渗透膜仓使用。     

Effects of hot-carrier stress on high performance polycrystalline silicon thin film transistor with a single perpendicular grain boundary

This paper is a report on the effect of a single perpendicular grain boundary on the hot-carrier and high current stability in high performance polycrystalline silicon (poly-Si) thin film transistors (TFTs). Under a hot carrier stress condition (Vg = Vth + 1 V, Vd = 12 V), the poly-Si TFT with a single grain boundary is superior to the poly-Si without any grain boundary because of the smaller free carriers available for electric conduction. The shift of transconductance in poly-Si TFT with a single grain boundary is less than 5% after hot carrier stress during a period of 1000 s. The shift of transconductance is about 25% in the case of the poly-Si TFTs without a grain boundary in the channel. On high current stress, the poly-Si TFT without the grain boundary is less degraded than the poly-Si TFT with the grain boundary because the concentrated electric field near the drain junction is lower.     

The Influence of Ir and Pt Addition on the Synthesis of Fullerenes at Atmospheric Pressure

The addition of metallic Ir and Pt to a fullerene-forming, atmospheric-pressure plasma reactor was found to influence the generation of carbonaceous products. It was observed that the added metals were efficiently dispersed into the plasma and that their presence increased the yield of fullerenes. The addition of Ir led to a noticeable shift in the fullerene distribution towards C₆₀, whereas the addition of Pt increased the proportion of C₆₀ oxides and decreased the proportion of higher fullerenes. Addition of Ir also caused a reduction of the soot particle size and the formation of a considerable quantity of carbon nanotubes.