Study on Reduction of Sulfur Content in FCC Gasoline

Reduction of sulfur content in FCC gasoline was studied in a fixed fluid bed (FFB) unit by using metal-modified LV-23 FCC catalyst. The results showed that the sulfur content in FCC gasoline could be reduced with LV-23 catalyst modified with zinc, palladium, zinc-palladium, zinc-cobalt, and zinc-nickel. Among these metals or metal combinations, palladium-containing catalyst was the most effective. Desulfufization of the heavy fraction of FCC gasoline was more effective than full-range gasoline under the same conditions with palladium-containing catalysts. A high reaction temperature was favorable to desulfurization, but it would reduce the yield of liquid product. After desulfurization reaction, the olefm content of product gasoline decreased while the aromatic and iso-alkane contents increased. Removal of thiophene and benzothiophene is higher.     

利用贫软锰矿制备锰盐的研究

用二氧化硫法处理贫软锰矿，得到含硫酸锰和连二硫酸锰的溶液，继而将该溶液进行净化，除杂，浓缩，结晶处理即得工业级硫酸锰，结晶母液用碳铵沉淀即得碳酸锰产品     

超低硫燃料柴油的润滑性研究与性能研究

研究提出了超低硫燃料暂定战术技术指标，并规定了其润滑性要求。通过对基础油生产工艺研究、柴油润滑性添加剂研究及配方性能评定，成功研制了一种环保型超低硫燃料，满足外燃发动机（燃烧室高温高压）的使用要求。研制产品具有馏分窄、闪点高、氧化安定性好、低温性能优异、硫含量超低、润滑性能好等特点。燃料的低硫化是燃料发展的必然趋势。在我国开展低硫或超低硫环保型燃料研制，同时开展燃料润滑性添加剂的研制，具有重要意义。     

我国车用无铅汽油的质量状况及分析

对1998－2001年间生产领域和流通领域的近500批次汽油产品检验数据进行了总结和分析，表明我国汽油的实物质量正在不断提高，但从环保要求出发还需不断向国际水平靠扰，尤其应进一步降低烯烃含量，硫含量。     

制备低硫可膨胀石墨的研究

研究了以过二硫酸铵作氧化剂低硫可膨胀石墨的制备，找到了在较低温度下，制备低硫可膨胀石墨的最佳条件。即过二硫酸铵和石墨的重量比为１５％；反应温度为５５℃；反应时间为４０ｍｉｎ；硫酸浓度为９８％；硫酸与石墨的重量比为４∶１，草酸和硝酸（浓度为６５％）的重量比为７．５％时，所制得的可膨胀石墨含硫量为０．６５％，膨胀容积为２００ｍＬ／ｇ可膨胀石墨。并且，其终端产品柔性石墨具有优良的力学性能和抗氧化性能。     

Thermal diffusivity of fluids in a broad region around the critical point

Dynamic light scattering is a suitable method for the investigation of transport properties such as the thermal diffusivity of optically transparent fluids. The main advantages of the method are its quickness, the fact of the thermodynamic state of equilibrium of the sample (gradients are not required), and the relatively simple evaluation of data without the necessity of calibration. However, an insufficient production of intensity of scattered light may be a limiting effect. For that reason the vicinity of the gas-liquid critical point represents the classical range of application. In this paper, it is shown that by means of an appropriate choice of experimental apparatus, measurements are also feasible in an extended range of states. Broad regions around critical points of three pure fluids (sulfur hexafluoride, SF₆; ethane, C₂H₆; nitrous oxide, N₂O) over temperature ranges ¦T-T _c¦ of 0.02 to 50 K and density ranges (/_c) of 0.2 to 2 were investigated. In this region the thermal diffusivity shows great variations with temperature and density and cannot be described by means of ideal-gas behavior or relations for liquids. The measurements were carried out along the coexistence curve for both phases, along the critical isochore and along some isotherms with TT _c. The measured or calculated density, pressure, and thermal diffusivity data as well as some correlations are presented.     

城市垃圾渗滤液烟气脱硫体系气液吸收与解吸过程的数学模拟

针对垃圾渗滤液烟气脱硫体系气液吸收和解吸过程反应复杂的特性,基于经典双膜传质理论,建立了填料塔内湿法烟气脱硫模型,包括填料塔反应器模型和烟气SO2在垃圾渗滤液中吸收并伴随氨的解吸过程的数学模型。模型将系统内复杂的多组分反应分解为独立的离子反应,从而在确定的独立反应的条件下,可使模型的数值求解不依赖于特殊的假设条件以及可变的操作条件。根据工艺研究的实验条件对模型赋初值,结合模型参数估值确定适宜的边界条件,采用Maple 8.0对模型方程进行求解,得到了液膜内各组份的浓度分布特性曲线,以及气相分压、pH值、传质阻力、传质速率、吸收增强因子等沿塔高的分布特性,结果表明模型预测结果和实验结果吻合良好。所建立的模型为本工艺过程和其它湿法烟气脱硫过程的传质-反应现象提供了一个定量的理论分析和工程设计基础。     

解析参数对活性焦再生过程及再生效果的影响

 活性焦的热解析参数对再生活性焦的脱硫脱硝性能和机械强度至关重要。为了明确解析参数对活性焦再生过程和再生效果的影响规律,通过热解析试验探究活性焦硫残余比例、CO₂和CO生成量及再生活性焦脱硫脱硝性能随解析温度和解析时间的变化规律,继而明确适宜的活性焦热解析参数。结果表明,活性焦升温解析过程中,脱硫产物在317 ℃左右迅速分解,随后分解速率下降;在进入恒温解析阶段后脱硫产物分解速率先快速下降,而后进入缓慢解析状态。硫残余比例随恒温解析温度的升高而下降,在530 ℃下解析3 h可使脱硫产物完全解析;解析温度高于430 ℃后,活性焦表面的酚基、醌基、内酯基等含氧官能团分解量明显增加,并随恒温解析温度的升高而持续增加,分解所生成的CO和CO₂也随之大幅增加,这将使活性焦的孔隙结构进一步发展,继而不利于活性焦机械强度的保持;解析温度低于530 ℃时,硫残余比例随解析温度的升高而持续降低,使再生活性焦的脱硫脱硝性能持续提高;解析温度高于530 ℃后,含氧官能团分解量随解析温度的升高而持续增加,这将有利于提高活性焦表面SO₂氧化反应速率,继而使再生活性焦的脱硫性能持续升高,但酚基、内酯基等酸性含氧官能团的分解使再生活性焦对NH₃的吸附性能降低,进而使其脱硝性能降低。在兼顾再生活性焦脱硫脱硝性能、机械强度和生产效率等多方面因素时,430 ℃恒温解析3 h是相对较优的解析参数。在此解析条件下,再生活性焦的硫残余比例仅为1.8%,含氧官能团尚未发生大量分解,脱硫脱硝性能相对较为优良。     

Sulfur in chromia

The solubility of sulfur in chromia has been studied in H₂-H₂O-H₂S tagged with³⁵S at 973 and 1173 K at low oxygen and sulfur partial pressures typical for coal gasification-systems. For monocrystalline samples, it has been shown that sulfur-containing species are only present adsorbed on the surface of the specimens and can be removed by ultrasonic cleaning in acetone. The surface coverage after 4 weeks of exposure to H₂-H₂O-H₂S was between 2.8 and 19.3% of a monolayer. In polycrystalline chromia, sulfur was located only in pores and cracks of the sample. In dense, compact areas of the specimens the solubility of sulfur was below the detection limit of autoradiography, which was estimated to be better than 0.17 ppm.     

PRO/Ⅱ软件在硫磺回收中的二次开发应用

硫磺回收装置的设备需要有较大的操作弹性。针对其过程气进口压力低，手工计算难于进行严格的全程压降计算，现以PRO／Ⅱ软件为开发平台，通过扩充数据库和建立模拟流程，成功地将其用于硫磺回收装置的设备选型和核算，为工程设计提供了先进的计算手段。