温度应力、自收缩对高性能混凝土早期开裂的影响

根据高性混凝土的水化特性、物理力学特性及自收缩特性，分析了高性能混凝土早期开裂机理和影响早期开裂的主要因素．并结合工程实例，借助混凝土温度和应力有限元仿真计算方法分析研究了表面适度保温和水管冷却技术在高性能混凝土温控防裂中的应用效果．研究结果表明，表面适度保温与水管冷却相结合能有效降低混凝土的内外温差，减小混凝土早期表面拉应力与后期内部拉应力，防裂效果明显，对类似的工程具有借鉴作用．     

重油催化裂化装置的环保对策

对重油催化裂化过程中的环境影响因素、硫分布状况及硫平衡等进行了分析，指出了重油催化裂化过程中的环境污染问题；从对装置污染源的分析出发，提出了相关的治理措施。     

新型香料苹果酯-B的合成

以硫酸高铈为催化剂,通过乙酰乙酸乙酯和1,2-丙二醇反应合成了苹果酯-B,研究了各有关因素对产品收率的影响。实验表明,硫酸高铈是合成苹果酯-B的良好催化剂,在酯醇物质的量比为1∶1.25、催化剂用量为0.3g/0.1mol乙酰乙酸乙酯、环己烷10mL、反应时间2h的条件下,苹果酯-B的收率可达91.5%。     

催化裂化沉降器多臂式旋流快分系统封闭罩内的流场

用智能型五孔探针对催化裂化沉降器内多臂式旋流分离系统封闭罩内的气体流场进行了测试。测试结果表明，罩内流场为轴对称的三维湍流场，在旋流头喷出口处径向速度较大，呈短路流现象。根据流场测试结果，建立了三维气流速度分布的无因次计算式，可供工程设计参考。     

沸石孔结构对1-己烯异构化性能的影响

采用1-己烯为原料,对硅铝比相近、不同孔结构的沸石在脉冲微反装置上进行了评价试验,考察了FCC条件下沸石孔结构对烯烃异构化性能的影响。结果表明,大孔径的Y型沸石具有良好的异构化性能,异构化能力由强到弱的排列顺序为Y>β>ZRP>丝光沸石>镁碱沸石。     

Fracture toughness of thermoset composites reinforced by perfectly bonded impenetrable short fibers

The fracture toughness of brittle thermoset resins could be improved significantly by perfectly bonded tough, short fibers through both crack trapping and bridging effects. In this paper, the crack trapping effect was studied through the analysis of the change of strain energy associated with the crack propagation across a regular array of fibers, and the bridging effect was discussed based on the Andersson–Bergkvist model. The fracture resistance increases with the fiber volume fraction, and is independent of the elastic properties of the matrix, the crack length, and the cross-sectional diameter of the fibers.     

Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

街面水电站混凝土面板堆石坝主要技术问题探讨

街面水电站拦河坝为混凝土面板堆石坝,在面板止水结构型式、面板防裂措施、上游面的施工方法、趾板开挖处理及趾板灌浆等方面,根据工程实际情况,结合国内外的新技术新工艺进行了探讨。     

氧化铝熟料单筒冷却机节能技术改造

本对影响氧化铝熟料单筒冷却机冷却效率的因素进行了分析，并提出了相应的节能技术改造措施，取得了明显的节能效益。     

芳烃抽提装置技术改造

由于中国石化锦西石化分公司600kt／a连续重整装置的建设，芳烃抽提装置的原料由原来的脱戊烷油变为Ce组分。为此，对抽余油水洗塔和芳烃分离部分的苯塔塔盘，以及苯塔塔顶和塔底抽出部分进行了改造，更换部分机泵和增加变频泵，并将常规仪表改为DCS控制。改造后装置实现一次开车成功，生产出合格产品。抽余油中总芳烃含量小于0．1％，苯回收率达到99%以上。