普光气田邻井干扰压降研究

根据普光气田现场资料,分析普光气田关井压降恢复时间和稳定生产时间的关系。建立邻井干扰计算模型,评价邻井干扰压降值及邻井干扰,并对邻井干扰规律进行敏感性分析。     

Interfacial Microstructure and Mechanical Properties of Al/Mg Butt Joints Made by MIG Welding Process with Zn-Cd Alloy as Interlayer

Butt joints between Mg alloy AZ31 B and pure Al 1 060 sheets were produced via metal inert gas welding process with Zn-Cd alloy foil. Crack-free Al/Mg butt joints between AZ31 B Mg alloy and pure Al 1060 sheets were obtained. Intermetallic compound layer 1 and layer 2 had formed in fusion zone/Mg alloy and the average thickness of the layer 1 was about 50 μm. The intermetallic compound layer 1 consisted of Al12Mg17 and Mg2Si phases while layer 2 consisted of Al12Mg17, Mg2Si and Mg Zn2 phases. The crack started from the IMC layer at the bottom of the joint and propagated along the brittle IMC layer, then expanded into weld metal during the SEM in situ tensile test. The highest tensile strength of the dissimilar metal butt joints could reach 46.8 MPa and the effect ofinterfacial IMC layer on mechanical property of the joint was discussed in detail in the present study.     

“顶岗置换”模式培养高师准幼儿教师的探讨

＂顶岗置换＂模式不仅促进了一线学前教师的职后培训,更有利于高师准幼儿教师的培养;同时,＂顶岗置换＂对高师准幼儿教师的培养提出了相应的挑战：顶岗对学生的高要求——能否从学生变为教师,顶岗对学生的低回报——能否从教中学。提出相应策略,促进＂顶岗置换＂模式下准幼儿教师的培养。     

On the gas dynamics of HVOF thermal sprays

An experimental study of the gas-dynamic aspects of the high-velocity oxyfuel (HVOF) thermal spray process has been performed using commercially available HVOF equipment (Hobart-Tafa JP-5000, Ho-bart-Tafa Technologies, Inc., Concord, NH). Optical diagnostic techniques, including microsecond-expo-sure schlieren and shadowgraph imaging, were applied to visualize the hot supersonic jet produced by this equipment without particle injection. Rapid turbulent mixing of the jet with the surrounding atmos-phere was observed, which is an issue of concern in coating quality due to the possibility of oxidation of sprayed particles. This mixing appears to be a function of the ratio of densities of the hot jet and the cold atmosphere as well as a function of the velocity of the jet, rather than one of combustion-chamber pres-sure or barrel length. The supersonic core of the HVOF jet dissipates rapidly due to the mixing, so that the jet is no longer supersonic when it impinges on the target surface being sprayed. Secondary issues also observed in this study include strong jet-noise radiation from the HVOF plume and the entrainment and induced bulk motion of the surrounding air.     

高炉铜冷却壁凝固过程数值模拟

在对铜冷却壁砂型 金属型复合铸造条件下的热态工况进行分析的基础上,利用有限元数值模拟的方法首次建立了铸型传热分析对称模型。在模型中对铸型传热系统中的对流、辐射、接触边界条件和凝固潜热进行了处理,利用有限元分析软件ANSYS,分析了紫铜冷却壁的温度场的变化。数值模拟的结果与实际生产相当吻合。     

研究合金定向凝固组织的脉冲磁场设备的研制

介绍了脉冲电磁场发生设备的工作原理 ,设计等。并介绍了其如何与合金的定向凝固设备结合 ,以实现对合金的定向凝固组织在脉冲电磁场作用下的研究。     

电场固溶对2091A1-Li合金显微结构的影响

用电子探针及透射电镜研究了２０９１ＡｌＬｉ合金的电场固溶对显微结构的影响。结果发现，电场固溶通过促进含铜相溶解提高铜元素的固溶程度，加剧Ｌｉ原子在晶界上的非平衡偏聚，导致析出相δ′分布不均匀，体积分数减少，晶界上出现粗大的δ平衡相，Ｔ１及Ｓ′相均匀弥散分布，合金的力学性能（Ｔ６）达到了应变时效处理（Ｔ８）的水平。     

连续碳分CO2吸收率分析及探讨

本文简述了CO2 气体吸收率的测定原理 ,着重分析了影响连续碳分CO2 气体吸收率的因素 ,提出了提高连续碳分CO2 气体吸收率的途径     

TBC experience in land- based gas turbines

This paper summarizes prior and on-going machine evaluations of thermal barrier coatings (TBC) for power generation, that is large industrial gas turbine applications. Rainbow testing of TBCs on turbine nozzles, shrouds, and buckets are described along with a test of combustor liners. General Electric Power Generation has conducted more than IS machine tests on TBC turbine nozzles with various coatings. TBC performance has been quite good, and additional testing, including TBCs on shrouds and buckets, is continuing. Included is a brief comparison of TBC requirements for power generation and aircraft turbines.