新安江电站进水口快速闸门动水闭门鉴定试验

本文叙述了应用现代科学方法和实验原型观测技术对新安江水电站进水口快速闸门进行安全检测鉴定，并介绍了水电站快速闸门动水闭门试验程序，对水电站快速闸门试验及相关鉴定有重要参考意义。     

双河油田注入水适应性及注水井酸化解堵研究

考察了双河油田双河联、江河联注入水堵塞地层的因素;膨胀性黏土，悬浮固体颗粒。细菌及悬浮污油。含膨胀性黏土的双河南、双河北及不含膨胀性黏土的双江岩心粉，在注入水中相对于地层水中的体积膨胀度分别为14．5％、11．1％及0．02％；注入100PV不含悬浮颗粒的等体积比地层水、注入水混合水使双河、双江岩心渗透率分别下降7％和4％、9％和7％。注入水中悬浮颗粒引起岩心渗透率下降，粒径越大、颗粒浓度越大、注入量越大，则渗透率越低。在粒径2．1μm或颗粒浓度3mg／L前后下降幅度变化较大。注入水中硫酸盐还原菌引起岩心渗透率下降，含菌量越大则渗透率开始下降时的注水量越小，注入含菌50个／L的水100PV使岩心渗透率下降7％。岩心对注水合油量敏感，注入含油量20mg／L的水50PV使岩心渗透率下降20％。在岩心注水实验中渗透率下降最严重的是双河南岩心，其次是双河北岩心．江河岩心较轻，注入精细过滤水的双河北岩心渗透率下降大大减少．说明悬浮固体是造成注水堵塞的主要因素。为了解除双河油田注水井的堵塞，研制了含黏土稳定剂、缓蚀剂、铁离子稳定剂、互溶剂的土酸液，与南阳油田使用的低伤害酸液一起，用于1口注水井的解堵，效果良好。图7表4参5。     

高温高盐高含水油藏提高水驱采收率配套技术

针对江汉油区高温高盐高含水油藏的储层条件,应用国内外油藏精细描述、油藏工程最新理论与技术,提出了高含水油田合理钻加密井、完善注采井网、水平井挖潜、不稳定注水及高温高盐油藏采油工艺配套技术措施,形成了一套适应高温高盐高含水油藏提高水驱采收率的配套技术。     

乐滩灌区输水隧洞穿合山煤矿采空区处理设计

分析了乐滩灌区工程北干渠溯河隧洞段长约1.06 km穿合山煤矿采空区的地质情况.借鉴高速公路煤矿采空区的成功处理经验,通过科学分析,对采空区变形和区域内覆岩的稳定性做了评价,论述了输水线路穿采空区段采取全充填压力注浆法的工程处理方法.     

大同市节水型社会建设的探讨

大同市是全国108个比较严重缺水城市之一，人均水资源量不足全国的1/10（全国人均水资源量2231m^3），稍超过全省的1／2（全省人均水资源量388m^3），市中心城区工农业及城市生活用水近20年来靠超采地下水来支撑。文中就大同市水资源供需不平衡的现状，提出大同市节水型社会建设的必要性，及今后水资源开源和节流的措施。     

控制反转技术分析

轻量级容器的解耦模式被称为“控制反转”或者“依赖注入”,组件之间的依赖关系由容器(运行环境)在运行期决定,从而在相当程度上降低了组件之间的耦合。该文详细论述了这种解耦模式的原理,以及依赖注入的3种主要形式,并且对几种形式进行了对比总结。     

轻质滤料滤池的试验与研究

轻质滤料滤池是以比水密度略小的滤料为滤床的滤池，通过以净水厂的原水和污水处理厂的二级处理出水为过滤试验对象，所取得的结果表明：下向流轻质滤料滤池对浊度和悬浮固体（SS）的去除率分别可以达到80％和45％，而滤床的水头损失不超过15cm。因此轻质滤料滤池可以以预过滤的形式配置在过滤处理的净水和污水的处理工艺中。     

GIS在深圳市三防指挥信息系统中的应用

深圳市三防指挥信息系统利用GIS技术,结合水利(水务)、防汛、抗旱的具体业务,建立了水情遥测数据处 理分系统、工况监测数据处理分系统、水务行业三防信息管理分系统、决策支持分系统、水源优化调度分 系统,提高了现代化管理水平。     

Metalorganic chemical vapor deposition of silver thin films for future interconnects by direct liquid injection system

Deposition of Ag films by direct liquid injection-metal organic chemical vapor deposition (DLI-MOCVD) was chosen because this preparation method allows precise control of precursor flow and prevents early decomposition of the precursor as compared to the bubbler-delivery. Silver(I)-2,2-dimethyl-6,6,7,7,8,8,8-heptafluoro-3,5-octanedionato-triethylphosphine [Ag(fod)(PEt₃)] as the precursor for Ag CVD was studied, which is liquid at 30 °C. Ag films were grown on different substrates of SiO₂/Si and TiN/Si. Argon and nitrogen/hydrogen carrier gas was used in a cold wall reactor at a pressure of 50–500 Pa with deposition temperature ranging between 220 °C and 350 °C. Ag films deposited on a TiN/Si diffusion barrier layer have favorable properties over films deposited on SiO₂/Si substrate. At lower temperature (220 °C), film growth is essentially reaction-limited on SiO₂ substrate. Significant dependence of the surface morphology on the deposition conditions exists in our experiments. According to XPS analysis pure Ag films are deposited by DLI-MOCVD at 250 °C by using argon as carrier gas.     

Oligo(ethylene oxide) side‐chain steric screening effects on conductimetric properties of grafted poly(4‐vinylpyridinium) salts in aqueous solutions

A set of poly[N‐oligo(ethylene oxide)yl 4‐vinylpyridinium tosylate] (P4VOEOOTs) has been prepared by spontaneous polymerization of 4‐vinylpyridine. This method gives a grafted polyelectrolyte having a positive charge on every backbone pyridinic moiety. The P4VP15Ts, P4VP164Ts, P4VP350Ts and P4VP750Ts aqueous solution conductivities were determined in the concentration range from 6 × 10^?4 to 10^?2 M at 25 °C. The variation of the conductivity versus concentration of the investigated system exhibits typical polyelectrolyte behaviour. The polyelectrolyte mobility was found to be dependent on the oligo(ethylene oxide) (OEO) side‐chain length. Manning's rod‐like model fails to describe these results. A simple steric effect is proposed to explain the influence of the OEO length. Copyright © 2003 Society of Chemical Industry